What are the differences between the Bora Hatchback and the Golf?

How to Deal with ABS Warning Light On?

ABS warning light on indicates the following fault conditions and solutions: Fault 1: ABS warning light stays on continuously Solution 1: Clean dirt on the vehicle speed sensor and adjust the gap between the vehicle speed sensor and the signal gear ring to restore normal operation. Solution 2: Check the wiring connections and reconnect any loose connections. Fault 2: ABS warning light intermittently turns on, but turns off during acceleration Solution: Check the battery specific gravity; inspect the charging system; examine the power supply (such as voltage relay or poor power contact). Fault 3: ABS warning light remains on after engine starts and only turns off when engine IGFF Solution: Loosen the ground fixing screw of the hydraulic valve body, then retighten the fixing screw and clean the contact surface if necessary; replace the ABS or ABS/ASR computer. Fault 4: ABS warning light turns on during high-speed driving Solution: Refer to the vehicle's tire specifications and wheel specifications, check the sticker near the fuel tank cap. Fault 5: ABS warning light intermittently turns on Solution: Start the engine, press the brake pedal, push the brake switch linkage down to the bottom with your fingers, then release the brake pedal to complete the self-setting position. Replace the brake light switch.

5

Share

What materials are needed to apply for ETC for trucks?

Truck ETC application requires a driver's license and the vehicle owner's ID card. If the vehicle belongs to a company rather than an individual, the company's business license or organization code certificate is required. ETC usage precautions: The ETC transaction sensing range is 8 meters. When encountering a stationary vehicle ahead, maintain a distance of over 10 meters to prevent automatic payment for the preceding vehicle in case its ETC device malfunctions or is absent. The recognized speed for ETC lane passage is 20km/h. Excessive speed will prevent reading of vehicle device information and may cause payment failure. Unauthorized removal or movement of OBU devices, or detachment/loosening of ETC electronic tags will deactivate the tags. These can be taken to the bank where the ETC card was issued or highway service centers for inspection. Non-deliberate detachment only requires reactivation.

3

4

Share

What is the speed limit on national highways?

The speed limit on national highways is 80km/h. Drive according to the speed limit signs on the road. Other speed limit regulations: Urban roads: Motor vehicles driving on urban roads must not exceed the speed indicated by speed limit signs and markings. On roads with two or more motor vehicle lanes in the same direction and without speed limit signs or markings, the maximum speed for urban roads is 70 km/h, while the maximum speed for closed motor vehicle-only roads and highways is 80 km/h. Tunnels: The speed limit in tunnels and tunnel groups is generally 80 km/h. In accident-prone sections, the speed limit is usually 20 km/h lower than the main highway. Sharp curves and interchange ramps have speed limits based on their design speed. The speed limit in ETC lanes is 20 km/h, and the speed limit for truck weigh-in-motion lanes is 5 km/h.

2

4

Share

What is the difference between transverse and longitudinal engine layouts?

The differences between longitudinal and transverse engine layouts are as follows: 1. Different placement directions of engine and transmission: Transverse engines are placed horizontally, requiring the transmission to be placed horizontally side by side. Longitudinal engines are placed vertically, with the transmission positioned behind the engine. 2. Different power output directions: The power transmission direction of a transverse engine is usually perpendicular to the vehicle's forward direction. After entering the transmission, the power is typically transmitted horizontally directly to the half-shafts. The power transmission direction of a longitudinal engine is parallel to the vehicle's movement direction, transmitting backward. After entering the transmission, the power continues to be transmitted longitudinally backward, usually connecting to the central driveshaft for direct rearward transmission.

7

1

Share

Where are the turn signals located on a car?

Turn signals are located on both the upper and lower sides of the front and rear parts of the vehicle. Here is an introduction to the usage scenarios of turn signals: Pulling over: When needing to pull over, the driver should activate the right turn signal in advance and observe the traffic dynamics on the right rear side of the vehicle before pulling over. Starting off: When leaving a parking space, the driver should activate the left turn signal in advance and observe the traffic dynamics on the left rear side of the vehicle before entering the lane. Intersections: When approaching most intersections, at a distance of 30-10 meters from the intersection, the driver should activate the turn signal according to the intended turning direction. Overtaking: When overtaking is required on roads without marked solid center lines, the driver should activate the left turn signal and sound the horn.

11

2

Share

Can I change my car's license plate in a different location?

You can change your car's license plate in a different location. The following is the procedure for changing the license plate in a different location: Handling the change procedures at the original vehicle management office: Go to the vehicle management office where the car's license plate was originally registered to handle the change procedures. (Note: The vehicle used by the owner must meet the National IV emission standard). Required materials for the procedure: the original ID card of the vehicle owner; the vehicle license, registration certificate, and the vehicle itself. Transferring the vehicle records to the new location: After completing the change procedures at the original vehicle management office, transfer the vehicle records to the vehicle management office in the new location. Required materials for the procedure: the original ID card of the vehicle owner, the vehicle records, and the vehicle itself.

18

2

Share

What are the differences between the Bora Hatchback and the Golf?

How to Deal with ABS Warning Light On?

What materials are needed to apply for ETC for trucks?

What is the speed limit on national highways?

What is the difference between transverse and longitudinal engine layouts?

Where are the turn signals located on a car?

Can I change my car's license plate in a different location?

How to Use Vehicle Identification Number to Check Vehicle Details?

Does the ABS yellow light being on affect driving?

What is the standard for adjusting the height of low beam headlights?

What Causes a Car to Lose Power When Accelerating with the AC On?