What are the differences between the base and premium versions of the Bora?

Which line should you stop at for hill start?

Stop at the wide white stop line, which is the same as the stop line at a red light. Below is the relevant introduction to the Subject 2 driving test: Medium and large-sized vehicles: Large buses, tractors, city buses, medium-sized buses, and large trucks are tested on: parallel parking, side parking, driving over a single-plank bridge, curve driving, right-angle turns, passing through a restricted-width gate, navigating continuous obstacles, driving on bumpy roads, narrow-road U-turns, as well as simulated highway driving, continuous sharp turns on mountain roads, tunnels, driving in rain (fog), slippery roads, and emergency handling. Small vehicles: Small cars, small automatic transmission cars, small automatic transmission passenger cars for disabled individuals, and low-speed trucks are tested on: reverse parking, hill start and stop, side parking, curve driving, and right-angle turns.

20

0

Share

Which way to steer when reversing into a tight space?

When reversing into a tight parking space, steer in the opposite direction. Here is an introduction about reverse parking: Introduction: Reverse parking has been a mandatory test item for obtaining a small car driver's license since 2013. It assesses the driver's ability to maneuver the vehicle in a confined space. Reverse parking is one of the assessment points in the driver's test, requiring the driver to correctly reverse the vehicle into the garage from both sides while in motion. Evaluation criteria: Failing to follow the designated route or sequence results in disqualification. Having the vehicle body cross the line or failing to complete the reverse parking results in disqualification. Exceeding 210 seconds to complete the reverse parking results in disqualification. Stopping midway deducts 5 points each time.

10

2

Share

What Transmission Does the Chevrolet Orlando Use?

The Chevrolet Orlando is equipped with a 6-speed manual transmission and a 6-speed automatic manual transmission. This vehicle is powered by a 1.3T turbocharged engine, delivering a maximum power of 120 kW and a maximum torque of 230 Nm. In terms of body dimensions, the Chevrolet Orlando measures 4684 mm in length, 1807 mm in width, and 1628 mm in height, with a wheelbase of 2796 mm. Exterior-wise, the Chevrolet Orlando adopts the Chevrolet family design language, featuring a front fascia with the family-style dual grille design that is narrower at the top and wider at the bottom, complemented by a high-gloss black trapezoidal grille that accentuates the large-mouth shape, paired with the raised muscular lines on both sides of the hood.

12

4

Share

Where is the start button of Audi A6?

The start button of Audi A6 is located below the air conditioning panel and in front of the gear lever. The steps to start the engine are as follows: 1. Press the one-touch start button; 2. Step on the brake pedal to prepare for starting the vehicle; 3. Place the gear lever in the P position; 4. Press the one-touch start button again; 5. The tachometer on the dashboard rotates, indicating that the vehicle has been started. Audi A6 is a model under FAW Audi, with a length, width, and height of 5012 mm, 1855 mm, and 1485 mm respectively, and a wheelbase of 2945 mm. In terms of appearance, the rear upper part of the Audi A6 has been changed from a rounded streamline to a slightly raised edge, which has the effect of a spoiler and can provide sufficient grip for the vehicle when driving at high speed.

12

0

Share

How to Adjust the Headlights of a Camry?

Camry headlight adjustment method: 1. Start the car, wait for the dashboard to light up, locate the car's light button, and then turn on all the vehicle's lights; 2. Drive the car in front of a wall, carefully observe the image of the car's lights on the wall, which allows you to see the height of the lights. If the height difference is not obvious, you can also use a ruler to measure it; 3. Return to the car's driver seat and find the button to open the front hood; 4. Set a horizontal standard based on the observed light image, then locate the screw button for adjusting the height of the lights; 5. For the side with higher lights, turn the height adjustment button counterclockwise while keeping an eye on the changes in the light image on the wall until it aligns with the set horizontal standard. For the side with lower lights, use a tool to adjust clockwise, observing continuously until the light image matches the horizontal standard.

8

4

Share

How to Remove the Rear Headrest of a Volvo XC40?

Volvo XC40 rear headrest removal method is as follows: 1. Locate two grooves approximately 10 cm below the headrest at the back of the seat (position: one on each side, near the seat leather stitching). 2. Inside the grooves, there are two clips. Press both clips in the grooves firmly, then lift the headrest upwards to remove it. Below is relevant information about headrests: 1. To minimize head and neck injuries in collisions, it is crucial to control neck twisting to the smallest extent possible. A well-designed and properly installed headrest is essential for this. 2. The headrest should be installed at least parallel to the top of the ears or approximately 8.89 cm below the passenger's head. 3. The gap between the back of the head and the headrest should be as small as possible, preferably not exceeding 10.16 cm.

18

3

Share

What are the differences between the base and premium versions of the Bora?

Which line should you stop at for hill start?

Which way to steer when reversing into a tight space?

What Transmission Does the Chevrolet Orlando Use?

Where is the start button of Audi A6?

How to Adjust the Headlights of a Camry?

How to Remove the Rear Headrest of a Volvo XC40?

What does EQ in a car mean?

What Causes Loud Engine Noise in Cars During Summer?

Where is the Sonata cigarette lighter fuse located?

Can I Continue Driving After Turning Off the Engine and Checking the Coolant?