What are the differences between the Audi A4 Progress and Fashion models?

How to Solve the Issue When the Car Engine Warning Light Comes On?

When the engine warning light comes on, you can follow these steps to address the issue: First, check if the engine is running normally and whether there are issues such as shaking or emitting black smoke. If these problems exist, try not to start the engine again. It is especially important to note that you must not start the engine if the red light is on. If the engine can be started, turn it off and wait for 5-10 minutes. Then, without pressing the brake, press the start button once or turn the car key halfway to the 'on' position without depressing the clutch. The car will perform a self-check after powering on. Wait for 5-10 seconds and observe whether the warning light on the dashboard turns off. If the warning light does not turn off, visit a service station as soon as possible to identify the cause. The service station can use a portable diagnostic tool to read the fault code, obtain fault information, and perform targeted repairs. The engine warning light is an icon resembling a water tap. It comes in two colors: yellow and red. Yellow indicates a warning, while red means prohibition. When the yellow warning light is on, it means some system parameters in the car may have exceeded the set range. The car can still be driven, but certain functions may be limited. When the red warning light is on, the car must be stopped immediately, the engine turned off, and driving must not continue. The fault must be checked. Common causes for the engine warning light to come on include: sensor failure, fuel quality issues, poor mixture combustion, turbocharging problems, intake issues, exhaust problems, and anti-theft system failures.

9

1

Share

Can the Wuling Hongguang Carry 2000 Jin?

Under normal circumstances, the Wuling Hongguang minivan can carry 2000 jin of cargo. However, to accommodate 2000 jin of goods, the rear seats generally need to be removed. According to the "Motor Vehicle Registration Regulations," removing the rear seats of a minivan for cargo purposes constitutes unauthorized alteration of the vehicle's registered structure, construction, or features. If caught by traffic police, this can result in fines. Below is additional information: Consequences of vehicle overloading: Vehicle overloading severely damages road infrastructure. Since overloaded vehicles far exceed the design load capacity of roads and bridges, it leads to pavement damage, bridge fractures, and significantly shortens their service life. Vehicle overloading: Increased load mass leads to greater inertia and longer braking distances, increasing the risk of accidents. Severe overloading can cause tire blowouts, sudden swerving, brake failure, rollovers, and other accidents due to excessive tire load and deformation. Additionally, overloading affects the vehicle's steering performance, increasing the likelihood of steering failure and accidents. Increased psychological burden: Drivers operating overloaded vehicles often experience heightened psychological stress and mental pressure, leading to operational errors that compromise driving safety and cause traffic accidents. Overloaded vehicles cannot maintain normal speeds, occupying lanes for extended periods, directly affecting road traffic flow.

19

2

Share

What is the engine model of the Volkswagen Teramont?

The engine model used in the Volkswagen Teramont is the EA888-DPL, with a maximum horsepower of 186 HP, a maximum power output of 137 KW, a maximum power speed range of 4100-6000 rpm, and a peak torque of 320 N.m. The EA390 engine in the Volkswagen Teramont is an imported engine, produced at Volkswagen's manufacturing plant in Salzgitter, France. For the daily maintenance of the Volkswagen Teramont's engine, the following methods can be used: Use lubricating oil of appropriate quality grade. For gasoline engines, SD to SF grade gasoline engine oil should be selected based on the additional equipment of the intake and exhaust systems and usage conditions; for diesel engines, CB to CD grade diesel engine oil should be selected according to mechanical load, with the selection standard not lower than the manufacturer's specified requirements. Regularly change the engine oil and filter. The quality of any grade of lubricating oil will change during use. After a certain mileage, performance deteriorates, which can cause various problems for the engine. To avoid malfunctions, change the oil regularly based on usage conditions and maintain an appropriate oil level. When oil passes through the fine pores of the filter, solid particles and viscous substances in the oil accumulate in the filter. If the filter becomes clogged and oil cannot pass through the filter element, it may rupture the filter element or open the safety valve, allowing oil to bypass through the relief valve and carry contaminants back to the lubrication areas, accelerating engine wear and increasing internal contamination. Regularly clean the crankcase. During engine operation, high-pressure unburned gases, acids, moisture, sulfur, and nitrogen oxides from the combustion chamber enter the crankcase through the gap between the piston rings and cylinder walls, mixing with metal particles from component wear to form sludge. In small amounts, it remains suspended in the oil; in large amounts, it precipitates, clogging filters and oil passages, making engine lubrication difficult and causing wear. Regularly use radiator cleaner to clean the radiator. Removing rust and scale not only ensures the engine operates properly but also extends the overall lifespan of the radiator and engine.

7

3

Share

What is the fuel consumption per 100 kilometers of the Toyota Camry?

Toyota Camry's comprehensive fuel consumption is 4.1-6.0L/100km. Currently, there are 10 models of Toyota Camry on sale. The Hybrid Flagship, Hybrid Leading, Hybrid Sport, and Hybrid Luxury versions have a comprehensive fuel consumption of 4.1L/100km. The 2.0E Elite version has a comprehensive fuel consumption of 5.5L/100km. The 2.0G Luxury version has a comprehensive fuel consumption of 5.7L/100km. The 2.0S Sport version has a comprehensive fuel consumption of 5.8L/100km. The 2.5Q Flagship, 2.5G Luxury, and 2.5S Sport versions have a comprehensive fuel consumption of 6L/100km. The above figures are NEDC comprehensive fuel consumption, which are the fuel consumption data measured under the NEDC test procedure. The actual fuel consumption is higher than these values, ranging from 4.9-8.8L/100km. Here are 5 tips to help reduce fuel consumption while driving: When starting the vehicle, use a low gear, gently press the accelerator, and gradually increase speed. Avoid suddenly pressing the accelerator hard, as this can multiply fuel consumption. Light acceleration, light braking, and early braking: While driving, gently press the accelerator to avoid sudden increases in engine speed and prevent the car from shaking, making it more fuel-efficient. By anticipating road conditions and accelerating or braking slowly and evenly, fuel economy can be improved by up to 20%. Maintain proper tire pressure: Keep tire pressure at the level recommended by the manufacturer. For every 2 PSI below the recommended value (approximately 0.2 in metric units relative to the standard pressure of 2.4), fuel consumption increases by 1%. Regular maintenance or vehicle inspection: Regular oil changes can reduce carbon buildup (carbon buildup can cause ignition issues, sluggish acceleration, increased fuel consumption, and in severe cases, even cylinder misfires). Regularly check and replace the air filter when dirty, and clean or replace the fuel injectors, spark plugs, and throttle body as per mileage. Close windows while driving. Open windows increase wind resistance, which in turn increases the resistance the car faces, requiring more power and thus increasing fuel consumption. Here are some driving techniques to help reduce fuel consumption: Start in low gear, gently press the accelerator, maintain proper tire pressure, perform regular maintenance or vehicle inspections, and close windows while driving.

6

5

Share

Why is the engine fault light on in Changan CS75?

The engine fault light may illuminate due to the following 7 main reasons: Sensor malfunction: Sensors such as coolant temperature, crankshaft position, air flow, intake temperature, and oxygen sensors may be damaged, have poor contact, or experience signal interruption. When the car's ECU cannot accurately obtain engine data, the engine fault light will illuminate. Fuel quality issues: If fuel and engine oil are not added according to the manufacturer's requirements, it may cause engine wear and trigger the fault light. Poor combustion of the air-fuel mixture: Poor combustion can lead to engine carbon deposits or knocking. When detected by the oxygen sensor and reported to the ECU, the fault light will illuminate as a warning. Spark plug failure, ignition coil failure, fuel pump failure, or fuel line blockage can all cause poor combustion of the air-fuel mixture. Turbocharging issues: The intake turbocharging pipeline or turbocharger can also cause the engine fault light to illuminate. The most common issue is turbocharger damage, accompanied by symptoms such as oil leakage, high oil consumption, reduced power, metallic noises, or blue/black smoke from the exhaust pipe. Intake issues: If there is a problem with the car's intake, it may lead to engine pipeline blockage, and in severe cases, the engine fault light will illuminate. A dirty air filter that is not cleaned regularly can cause intake problems. Exhaust issues: Exhaust faults can also trigger the engine fault light. Common causes include rear oxygen sensor failure, three-way catalytic converter failure, exhaust camshaft and bearing failure, with the three-way catalytic converter being the most frequent issue. Using leaded gasoline, lead or silicon-containing lubricant additives, physical damage to the catalytic converter, or fuel supply system failures can easily cause three-way catalytic converter problems. Anti-theft system malfunction: If the car's electronic anti-theft system fails or the anti-theft controller does not match the engine electronic controller, the anti-theft system can prevent the engine from operating normally, and the engine fault light will illuminate. If the engine fault light is on, follow these steps: First, check if the engine is running normally and if there are issues such as shaking or black smoke. If so, avoid restarting the engine. Note: Do not restart the engine if the red warning light is on. If the engine can be started, turn it off for 5-10 minutes, then without pressing the brake, press the start button once or turn the key halfway to the "on" position without pressing the clutch. The car will enter self-check mode after powering on. Wait for 5-10 seconds to see if the fault light turns off. If the fault light remains on, visit a service station as soon as possible. The service station can use a portable diagnostic tool to read the fault code, identify the issue, and perform targeted repairs.

17

4

Share

Is it legal to ride a Kawasaki H2 with a modified Vanhool exhaust on the road?

Kawasaki H2 with a modified Vanhool exhaust cannot be ridden on the road. Whether it's a car or a motorcycle, any modification is illegal. Permitted modifications include: small and micro passenger cars installing front and rear anti-collision devices; cargo motor vehicles adding windshields, water tanks, toolboxes, spare tire racks, etc.; interior decorations of motor vehicles can also be enhanced. Prohibited modifications include: altering tires and rims, adding spoilers, changing lights, modifying exhaust pipes, etc., all of which are considered illegal modifications. After such modifications, the vehicle must be restored to its original condition to pass inspection. Additionally, penalties such as fines and license suspension may be imposed.

17

2

Share

What are the differences between the Audi A4 Progress and Fashion models?

How to Solve the Issue When the Car Engine Warning Light Comes On?

Can the Wuling Hongguang Carry 2000 Jin?

What is the engine model of the Volkswagen Teramont?

What is the fuel consumption per 100 kilometers of the Toyota Camry?

Why is the engine fault light on in Changan CS75?

Is it legal to ride a Kawasaki H2 with a modified Vanhool exhaust on the road?

What is the ground clearance of the Elantra in centimeters?

What causes unstable idling, shaking, and frequent stalling when the engine is warm?

Where is the computer connector located in a 2006 Peugeot 307?

Does the Q3 have a particulate filter?