What are the differences between the 2022 and 2021 Nissan Sylphy?

2 Answers
McLola
08/29/25 7:29am
Here is an introduction to the differences between the 2020 and 2021 Nissan Sylphy: Different engines: The 2020 Sylphy 1.6L XE Manual Comfort Edition and 2020 Sylphy 1.6L XE CVT Comfort Edition are equipped with a 1.6L 139 horsepower L4 engine; while the 2021 Classic 1.6L XE Manual Comfort Edition and 2021 Classic 1.6L XE CVT Comfort Edition are equipped with a 1.6L 122 horsepower L4 engine. Different dimensions: The 2020 Sylphy 1.6L XE Manual Comfort Edition and 2020 Sylphy 1.6L XE CVT Comfort Edition have a body length, width, and height of 4641mm, 1815mm, and 1450mm, respectively; while the 2021 Classic 1.6L XE Manual Comfort Edition and 2021 Classic 1.6L XE CVT Comfort Edition have a body length, width, and height of 4631mm, 1760mm, and 1503mm, respectively.
Was this review help?
6
5
Share
McJessica
09/11/25 5:02am
I bought the 2021 Sylphy last year, and this year my friend upgraded to the 2022 model. After driving them together a few times, the differences were noticeable. The 2022 version has minor exterior tweaks, with a more refined front grille that gives it a younger look. The interior upgrades include improved seat materials, which feel much softer and more comfortable, making long drives easier on the back. The tech features have seen significant improvements—the infotainment screen responds faster, and wireless CarPlay connectivity is far more convenient, eliminating the need for cables every time. The powertrain remains largely unchanged, still featuring the 1.6L engine paired with a CVT transmission, but the tuning has been optimized for smoother starts. The spaciousness and practicality are just as good, with a trunk that can handle all the family's luggage. Safety-wise, it now includes enhanced blind-spot monitoring and more reliable rear collision warnings. Overall, the 2022 model focuses more on comfort and convenience for daily use, and while it’s a bit pricier, it’s worth it.
Was this review help?
12
2
Share
Expand All
More Forum Discussions

How Much Torque Can the Aisin Third-Generation 6AT Withstand?

The Aisin third-generation 6AT can withstand a torque of 260 Nm. Here is additional information: 1. Principle of torque: The torque of an engine refers to the rotational force output from the crankshaft. The unit of torque is Newton meters (Nm). At a fixed power level, torque is inversely proportional to engine speed—the higher the speed, the lower the torque, and vice versa. It reflects the vehicle's load capacity within a certain range. 2. Impact of torque: Comparing cars with the same type of engine, a higher torque output results in greater carrying capacity, better acceleration performance, stronger climbing ability, fewer gear shifts, and relatively reduced wear on the car. Especially during zero-speed starts, a higher torque demonstrates the advantage of faster speed increase. In physics, torque is the force applied to rotate an object multiplied by the distance to the axis of rotation, representing the magnitude of the force output by the engine.
14
2
Share

What Causes the Clutch to Fail to Engage Gears When It Gets Wet?

There are several reasons why a wet clutch may fail to engage gears: 1. Clutch cable malfunction: Some manual transmission vehicles still use cables to control the clutch. The outer sheath of the cable can easily crack, resulting in difficulty shifting gears due to loss of clutch function. This issue is relatively simple to fix—just replace the cable. 2. Excessive gear self-locking force: If the gear self-locking mechanism on the clutch side is too strong, it can make shifting in and out of gears difficult. In this case, it is advisable to visit a repair shop to adjust the clutch cable and gear lock. 3. Clutch master cylinder failure: The clutch hydraulic master cylinder may develop issues such as pressure loss or oil leakage during use, leading to difficulty engaging gears when pressing the clutch. In such instances, the clutch master cylinder should be replaced at a service station, followed by a bleeding operation to remove air from the system.
13
5
Share

What Causes Water Dripping Under the Car in Summer?

When the air conditioning is on, the temperature inside the evaporator is low, causing the air to condense. The condensed water is discharged through a dedicated drain hole inside the car, leading to water flowing out from the chassis near the passenger side, which is a normal occurrence. Below are relevant details: 1. Location: The water dripping from the car's air conditioning system is typically located towards the middle-right side of the front of the car. Therefore, if you drive for a while in summer, turn off the engine, and wait for some time, you may notice water dripping from the middle-right side of the chassis. Soon, a puddle of clean, transparent water can be seen on the ground beneath the car. This is not a sign of any problem with the vehicle but rather the water discharged by the car's air conditioning system. 2. Exhaust Pipe: It is also normal for the muffler and exhaust pipe at the rear of the car to drip water, a phenomenon that mostly occurs during winter.
12
1
Share

Is it permissible to not carry a driver's license with you?

Driver's license must be carried with you. Extended information about driver's license is as follows: 1. Introduction: A motor vehicle driver's license refers to a legal certificate issued by the administrative department after a person who is legally allowed to learn to drive a motor vehicle has studied, mastered the knowledge of traffic regulations and driving skills, and passed the examination, permitting the driving of a certain type of motor vehicle. 2. Classification: The Ministry of Public Security of the country promulgated the "Motor Vehicle Driver's License Business Work Standards" and supporting regulations, further subdividing the previous three types of permitted driving models - A license (A driver's license, large passenger vehicle), B license (B driver's license, large truck), and C license (C driver's license, small car) - into seven types, while canceling the Q license.
2
0
Share

Is the Audi A6 considered a luxury car?

The Audi A6L belongs to the C-segment and is not classified as a luxury car. Vehicle classification standards are based on factors such as wheelbase, engine displacement, and weight: 1. A-segment: Compact cars with a wheelbase between 2.3 to 2.5 meters, such as the Audi A1. 2. B-segment: Mid-size cars with a wheelbase approximately between 2.5 to 2.8 meters, such as the Audi A4. 3. C-segment: Large mid-size cars with a wheelbase approximately between 2.8 to 3 meters, such as the Audi A6L. 4. D-segment: Luxury cars with a wheelbase exceeding 3 meters and engine displacement generally above 3.0 liters, such as the Audi A8L.
12
4
Share

Which brand does Anchors Tire belong to?

Anchors Tire is a brand owned by Shandong Anchors Tire Co., Ltd., a high-tech enterprise in Shandong Province. The company's business scope includes the manufacturing and sales of tires and rubber products, as well as the sales of raw materials for rubber products. Below is a detailed introduction to automotive tires: 1. Types of Tires: Pneumatic tires are divided into two types based on their structure: tubed tires and tubeless tires. Passenger cars commonly use tubeless tires. Depending on the arrangement of the inner cord layers and cushion layers, tires can also be categorized into radial tires and bias tires. Radial tires are widely used in automobiles. 2. Function of Tires: Tires are in direct contact with the road surface and, together with the vehicle's suspension system, help to absorb shocks during driving, ensuring good ride comfort and smoothness. They also ensure excellent adhesion between the wheels and the road surface, improving the vehicle's traction, braking, and off-road capability. Additionally, tires bear the weight of the vehicle.
18
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.