What are the differences between ns110r and ns110i?

How to open the trunk from inside the Wildlander?

Enter the left front door of the car to reach the driver's seat position. Ensure there are no abnormalities in the driver's seat area and that movement and stretching are normal. Locate the interior trim panel on the left front door. Make sure your palm can comfortably touch the panel and that it is not loose or otherwise abnormal to prevent accidents during use. Find the button on the interior trim panel. This button serves as the control switch for opening the trunk, and its function will be indicated by a label. Simply lift the button upwards with your hand, and the trunk lid will open.

7

1

Share

How to Replace a Car Key Shell?

Insert a small screwdriver into the side slot near the key blade. Carefully push the screwdriver towards the key blade in the direction indicated by the arrow to separate the key blade from the chip case. Insert a flat-head screwdriver into the groove on the side of the chip case and rotate it to release the shell clips in this area. Then insert the flat-head screwdriver into the groove at the top of the chip case and rotate it to release the shell clips there, allowing the chip case to be separated. On the left is the CR2032 battery, and on the right is the chip circuit board. Install them according to their corresponding positions in the shell.

3

5

Share

Where is the car chassis waterproof plug located?

Car chassis waterproof plugs are installed in areas prone to dust ingress or near air conditioning pipe openings. Below is an introduction to the regulations regarding the right-side distance during hill starts: 1. Introduction: Waterproof plugs, also known as waterproof breathable valves, are widely used due to their high reliability. They offer excellent breathability and sealing performance, effectively achieving waterproofing while maintaining breathability. 2. Function: The chassis waterproof plug primarily serves as a limit buffer, preventing the shock absorber from exceeding its maximum travel. Additionally, waterproof plugs effectively protect various lamps from natural elements, ensuring reliability. Their breathability allows internal moisture to dissipate, preventing fogging and dampness, while their sealing capability maintains pressure balance on both sides of the lamps through gas exchange.

7

1

Share

How to Connect a Phone to Audi MMI?

To connect a phone to MMI, a smartphone interface is required. The prerequisite for use is that the car is in a stationary state without driving, and the ignition switch is turned on. Turn on the phone, select Bluetooth and other devices, then enable Bluetooth. In the Bluetooth settings panel, add the Audi car's Bluetooth to connect. First, confirm whether the vehicle supports CarPlay functionality. If supported, open the "Settings" interface on the phone, click on CarPlay, and after connecting, click confirm to link to the car's display page. Enter the phone's settings interface, tap the version number seven times to enter engineering mode, then open the developer options and click on USB debugging. Finally, connect using a data cable.

18

0

Share

How to Remove the Engine Mount Rubber of Audi Q5?

For the coolant reservoir, there are two clips. Use a screwdriver to slowly pry out the clip at the bottom left corner. For the clip at the top right corner, use needle-nose pliers to grip the metal piece and pry it upward from the front position at the base. The air conditioning pipe clip on the engine mount is also secured with clips inside the rubber. Pry open both sides of the pipe clip base simultaneously to remove it. Use the car's original jack to find a flat spot near the engine mount, place a wooden board as a buffer, and then use the jack to lift the engine to a higher position. First, loosen the bolt a few turns with a 19mm socket. Check if the bolt has dropped. If the engine sinks, raise the jack further, then use a 16mm socket to remove the connecting bolt.

20

5

Share

Does the Levin have ambient lighting?

The Levin has ambient lighting. Below is a relevant introduction to the Levin: 1. Powertrain: The 2021 Levin lineup starts with four-cylinder engines, including a 1.2T gasoline version and a 1.8L + electric motor hybrid model. The 1.2T engine delivers a maximum output of 85KW and a peak torque of 185Nm, paired with a CVT transmission (simulating 10 gears), achieving a fuel consumption of 5.6L per 100km. 2. Exterior: The 2021 Levin measures 4640/1780/1455mm in length, width, and height, with a wheelbase of 2700mm, featuring a more sporty and dynamic design.

18

4

Share

What are the differences between ns110r and ns110i?

How to open the trunk from inside the Wildlander?

How to Replace a Car Key Shell?

Where is the car chassis waterproof plug located?

How to Connect a Phone to Audi MMI?

How to Remove the Engine Mount Rubber of Audi Q5?

Does the Levin have ambient lighting?

How to Charge a BMW 5 Series Plug-in Hybrid?

How to Maintain Frameless Car Doors in Winter?

How to Play Music from a USB Drive in a Mercedes-Benz E300?

How to Set the Corolla to Only Open the Driver's Compartment