What are the differences between Lavida and Langdong?

What Causes Vehicle Vibration at High Speeds?

Vehicle vibration at high speeds can be caused by: 1. Improper front tire pressure (too high or too low) or tire imbalance due to repairs: The solution is to replace the tires. 2. Misaligned front wheel alignment angles or excessive toe-in: The solution is to adjust the front wheel alignment. 3. Deformed front wheel hubs or unequal number of tire bolts: The solution is to adjust the quantity to make it consistent. 4. Loose installation of drivetrain components: The solution is to tighten the parts. 5. Bent drive shaft, imbalance, or deformed front axle: The solution is to replace the drive shaft and front axle.

16

3

Share

How to Turn Off the Daytime Running Lights on Lincoln MKC?

Lincoln MKC's daytime running lights cannot be manually turned off. Here are the specific details about these lights: 1. The daytime running lights on Lincoln MKC are part of the active safety features. Generally, these lights will automatically turn off after 30 seconds if the vehicle has a headlight delay function. The daytime running lights use LED technology, which consumes very little power. 2. In early car models, daytime running lights mostly used halogen bulbs, which had relatively low power consumption. However, with technological advancements, most manufacturers now design daytime running lights with brighter LED configurations, reducing power consumption by up to 35% and extending battery life. From an environmental perspective, dedicated daytime running lights enhance visibility and make vehicles more noticeable. This technology, specifically designed for daytime use, is more direct and effective than traditional lighting systems.

6

2

Share

Is It Safe to Drive with the ABS Yellow Light On?

ABS fault light is on, it is recommended not to continue driving, because the ABS light indicates a malfunction in the vehicle's anti-lock braking system. During emergency braking, if the wheels lock up, the vehicle may lose control and skid, making it difficult for the driver to decelerate or adjust the vehicle's trajectory, posing significant safety risks. There are several states in which the ABS light may illuminate, with different causes and solutions for each state, as detailed below: State 1: ABS fault light remains constantly on (most common). Cause 1: The ABS speed sensor's sensing area is covered by dirt, mud, or other contaminants, affecting the sensor's ability to detect the corresponding speed signal. This prevents the ABS computer from determining the vehicle speed and the wheel slip rate, thus failing to issue appropriate commands to regulate braking. Solution: Clean the dirt from the speed sensor and adjust the gap between the speed sensor and the signal ring to restore normal function. Cause 2: Poor signal due to loose connections in the system wiring or poor contact in the ABS relay, leading to system failure. Solution: Check the wiring connections and reconnect any loose parts. State 2: ABS warning light intermittently illuminates and turns off when accelerating. Cause: When multiple vehicle electrical devices are in use, the battery voltage drops below 10.5V. As the engine speed increases and the voltage rises, the ABS indicator light turns off. This may also occur if the ABS system's power supply voltage is too low, such as due to poor terminal contact or grounding issues. Solution: Check the battery's specific gravity; inspect the charging system; examine the power supply (e.g., voltage relay or poor power contact). State 3: The ABS warning light remains on after engine start and only turns off when the engine is turned off (IGFF). Cause: Poor grounding contact in the ABS hydraulic valve body; poor contact in the ABS hydraulic valve body wiring connector; ABS computer malfunction. Solution: Loosen the grounding screw of the hydraulic valve body, then retighten it, cleaning the contact surface if necessary; check if the connector gap has widened; replace the ABS or ABS/ASR computer. State 4: ABS warning light illuminates during high-speed driving. Cause: During high-speed driving, the ABS computer detects a significant discrepancy between the rear and front wheel speed signals; incorrect tire or wheel rim specifications. Solution: Refer to the vehicle's tire and wheel rim specifications, as indicated on the label near the fuel tank cap. State 5: ABS warning light intermittently illuminates. Cause: Improper adjustment of the brake light switch; poor internal contact in the brake light. Solution: With the engine running, depress the brake pedal, push the brake switch linkage down with your finger, then release the brake pedal to complete the self-setting position; replace the brake light switch if necessary.

16

3

Share

How to Set the Best Sound for BMW 530li?

Each car owner has different preferences for sound. Simply press the MODE button, switch to audio adjustment, and select the style that suits your preference. Below is a relevant introduction to the BMW 530li: 1. Power: Equipped with a 3.0-liter inline six-cylinder engine, with a maximum output power of 190 kW/258 hp and a peak torque of 300 Nm. 2. Configuration: It adopts a front MacPherson and rear multi-link suspension system, which is tuned to be quite resilient. Especially when driving on uneven roads, the feedback from the road is quite realistic.

11

5

Share

What labels are required to be affixed on motor vehicles?

Only the motor vehicle inspection compliance label and the compulsory insurance label are required. Below is more information about the motor vehicle inspection compliance label and the compulsory insurance label: 1. Compulsory Insurance Label: According to laws and regulations, this is insurance that must be participated in by units or individuals within the specified scope. It mandates motor vehicle owners or managers to purchase corresponding liability insurance, thereby increasing the coverage of third-party liability insurance. In the event of an accident, compulsory insurance can provide timely and basic protection to the victims of traffic accidents to the greatest extent. 2. Motor Vehicle Inspection Compliance Label: For motor vehicles equipped with spark-ignition engines (mostly gasoline or natural gas-powered vehicles) that meet National Standard I or above, and those equipped with compression-ignition engines (mostly diesel-powered vehicles) that meet National Standard III or above, a green environmental inspection compliance label (commonly known as the green label) is issued. For other motor vehicles that meet the emission standards at the time of manufacture, a yellow environmental inspection compliance label (commonly known as the yellow label) is issued.

3

0

Share

What causes a sudden rise in engine coolant temperature while driving?

Driving with a sudden rise in engine coolant temperature may be caused by excessive scale buildup in the radiator leading to poor heat dissipation. Below is a brief introduction to coolant temperature issues: 1. Air conditioning heat dissipation: Generally, the AC system also relies on the electric fan for cooling. When there is excessive debris or dust trapped between the radiator and condenser, it can result in inadequate heat dissipation and elevated coolant temperature. This occurs because cooler air passes through the condenser first before reaching the radiator, making this fault more apparent when the AC is turned on. 2. False alarm: The temperature gauge shows abnormally high readings with an alert, but the electric fan operates normally without coolant overflow. Most cases of this fault are false alarms, which may stem from: a damaged temperature gauge, faulty sensor, wiring issues, or poor grounding connections. Another possible scenario is a malfunctioning radiator cap that fails to properly release pressure, causing high pressure within the cooling system and triggering the alarm. An emergency solution for this situation is to carefully loosen the radiator cap to relieve pressure (exercise extreme caution to avoid burns). Replacing the radiator cap can permanently resolve this issue.

11

2

Share

What are the differences between Lavida and Langdong?

What Causes Vehicle Vibration at High Speeds?

How to Turn Off the Daytime Running Lights on Lincoln MKC?

Is It Safe to Drive with the ABS Yellow Light On?

How to Set the Best Sound for BMW 530li?

What labels are required to be affixed on motor vehicles?

What causes a sudden rise in engine coolant temperature while driving?

Why Does Water Come Out of the Exhaust Pipe in Winter?

Are Parking Sensor Probes Universal?

How to Remove the Interior Rearview Mirror in a Car?

How to Determine the Date on Car Glass?