What are the contents of the three subjects of the driver's license test?

1 Answers
AmaraLee
07/30/25 4:12am
The test contents of the three subjects of the driver's license are as follows: 1. Preparation for getting on the car: The candidate must follow the instructions of the safety officer, approach the car body, walk around the car (from the left front door to the back), and open the door to get on the car after confirming safety. After getting on the car, first adjust the seat to a suitable position, adjust the inner and outer rearview mirrors, and fasten the seat belt. Then perform fingerprint verification. The fingerprint device is located below the air outlet on the left side of the steering wheel. 2. Starting: When hearing the voice prompt "Please start", the candidate should step on the clutch, shift into 1st gear, turn on the left turn signal (for more than 3 seconds), observe the left rearview mirror (turning the head to the left), confirm safety, honk the horn, release the parking brake, start smoothly, and straighten the turn signal. 3. Right turn at the intersection: When hearing the voice prompt "Right turn at the intersection ahead", the candidate should turn on the right turn signal (for more than 3 seconds), then turn right into the driving lane according to the guide arrow. 4. U-turn: When hearing the voice prompt "Please make a U-turn ahead", the candidate should turn on the left turn signal (for more than 3 seconds), observe the traffic situation on the left rear through the (left) rearview mirror, confirm safety, then reduce speed, shift into a lower gear, and enter the U-turn area. When entering the U-turn area, observe the road conditions left and right, confirm safety, enter the driving lane, drive normally, and turn off the left turn signal. 5. Go straight through the intersection: When hearing the voice prompt "Go straight through the intersection ahead", the candidate should slow down (brake), observe the road traffic conditions, and drive according to the traffic light. When passing through the intersection, the speed should be below 30km/h, and parking is prohibited within the intersection. 6. Left turn at the intersection: When hearing the voice prompt "Left turn at the intersection ahead", the candidate should turn on the left turn signal (for more than 3 seconds), then turn left into the driving lane according to the guide arrow. 7. Passing the bus stop: When hearing the voice prompt "Passing the bus stop", the candidate should slow down (brake) or keep the speed below 30km/h before entering the area, observe left and right (turning the head), pay attention to avoiding buses and pedestrians, and pass after confirming safety. 8. Gear shifting operation: When hearing the voice prompt "Please complete the gear shifting action", the candidate should adjust the gear to 2nd gear, shift up to 5th gear in sequence, the speed should exceed 40km/h in 5th gear, then shift down to 2nd gear in sequence. 9. Driving straight: When hearing the voice prompt "Please keep driving straight", the candidate should look ahead, control the steering wheel with both hands, and keep the vehicle driving straight. It is strictly forbidden to ride or press the road dividing line. 10. Changing lanes: When hearing the voice prompt "Please change lanes", the candidate should turn on the (left) turn signal (for more than 3 seconds), observe the rear traffic situation through the (left) rearview mirror (turning the head to the left), confirm safety, then turn the steering wheel to the (left) to change lanes. When the conditions for changing lanes are not met, the candidate should slow down and wait for the conditions to allow before changing lanes. It is strictly forbidden to change two lanes continuously. 11. Passing the crosswalk: When hearing the voice prompt "Passing the crosswalk ahead", the candidate should slow down (brake) or keep the speed below 30km/h before entering the area. If there are pedestrians passing, please stop the vehicle outside the safety line and wait, and pass after the pedestrians have passed the crosswalk. 12. Passing the school area: When hearing the voice prompt "Passing the school ahead", the candidate should slow down (brake), or keep the speed below 30km/h before entering the area, observe left and right (turning the head), pay attention to avoiding students, and pass after confirming safety. 13. Pull over: When hearing the voice prompt "Please pull over", the candidate should turn on the right turn signal (for more than 3 seconds), observe the rear traffic situation on the right through the (right) rearview mirror, confirm safety, then park the vehicle (on the right side) parallel to the curb (or the solid line at the edge of the road) within 30 cm, but not pressing the curb (or the solid line at the edge of the road), stabilize the vehicle, pull up the parking brake, and shift into neutral.
Was this review help?
17
5
Share
More Forum Discussions

How to set the sound when locking the Civic?

Methods to set the locking sound for the Civic: 1. There is a speaker with a slash symbol on the remote control. Pressing this button will enable silent locking, where only the headlights flash without any alarm sound; 2. If the remote lock does not have this function, replace it with a normal remote lock. Any remote with that symbol will have the silent lock feature. Relevant information about car horns: 1. The horn is the audio signal device of the car. 2. During driving, the driver can emit necessary audio signals as needed or required to warn pedestrians and alert other vehicles, ensuring traffic safety. It is also used for urging movement and transmitting signals.
11
1
Share

What are the solutions for idle vibration in the Envision?

The solutions for idle vibration in the Envision are: 1. Clean engine carbon deposits, replace spark plugs, and check the fuel supply pressure. 2. Inspect the engine mounts for signs of aging and replace them if necessary. 3. When there is excessive carbon buildup inside the engine, it can cause idle vibration after a cold start. This happens because excessive carbon deposits absorb a large amount of the sprayed fuel-air mixture, making the mixture too lean and causing difficulty in starting. In this case, the engine can only start once the mixture reaches a certain level, but then the excessive carbon deposits cause the mixture in the cylinders to become too rich, leading to engine vibration.
10
4
Share

How to Clear the 'Check Tire Pressure' Display on a Civic?

The method to clear the 'Check Tire Pressure' warning on a Civic is as follows: 1. Press the ignition switch to start the vehicle; 2. Click the ENTER button on the right side of the multifunction steering wheel to enter the vehicle settings page; 3. Press the CANCEL button on the left side of the multifunction steering wheel, at which point the 'Check Tire Pressure' warning will no longer be displayed on the vehicle screen. Additional information about tire pressure monitoring: 1. Tire pressure monitoring automatically checks tire pressure in real-time while driving, alerting the driver to leaks or low pressure to ensure driving safety. 2. The tire pressure monitoring system is a type of active safety device that alerts the driver when potential tire hazards are detected, prompting timely action to prevent serious accidents.
15
3
Share

Which engine oil is better for the Bin Yue?

The Bin Yue performs better with 0w20 engine oil. The functions of engine oil include lubrication, auxiliary cooling, cleaning, sealing and leak prevention, rust and corrosion protection, shock absorption, and wear resistance. Relevant information is as follows: 1. The Bin Yue is a compact SUV with a wheelbase of 2600mm, a fuel tank capacity of 45L, and a curb weight of 1310kg. 2. The Bin Yue features a MacPherson strut front suspension and a torsion beam rear suspension. It is equipped with a 1.4T turbocharged engine, delivering a maximum horsepower of 141PS, a maximum torque of 235Nm, and a maximum power of 104kW. It is paired with a 6-speed manual transmission.
10
2
Share

What is the fuel consumption of the Camaro 3.6?

The comprehensive fuel consumption of the Camaro 3.6 is 8.1L/100km. Daily driving habits vary from person to person, so fuel consumption may also differ. Below are some relevant details about the Camaro: 1. The Camaro is a 2-door, 4-seater hardtop sports car produced by Chevrolet, equipped with a 3.6-liter four-cylinder turbocharged engine and paired with an 8-speed automatic transmission. 2. The dimensions of the Camaro are 4786*1897*1356mm, with a wheelbase of 2811mm. It features a double-ball-joint McPherson front suspension and a multi-link independent rear suspension, delivering excellent handling performance.
20
1
Share

Which Volkswagen models have English letters in their names?

Volkswagen models with English letters in their names include: Volkswagen Phaeton, Volkswagen Phideon, Volkswagen Passat, and Volkswagen Touareg. Relevant details are as follows: 1. The Volkswagen Phaeton is a full-size sedan with body dimensions of 51791mm in length, 1903mm in width, and 1450mm in height, a wheelbase of 3001mm, and a curb weight of 2260kg. 2. The Volkswagen Phaeton features multi-link independent suspension both at the front and rear, and is equipped with a 4.2L naturally aspirated engine producing a maximum horsepower of 335ps, a maximum torque of 430nm, and a maximum power output of 246kw, paired with a 6-speed automatic transmission.
4
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.