What are the consequences of a blocked exhaust valve?

1 Answers
MacCarlos
07/30/25 2:43am
If the exhaust valve is blocked, the polluted gas will flow back into the air filter, contaminating the filter element and reducing its filtration capacity. The dirty mixed gas being inhaled will further pollute the crankcase, leading to increased fuel consumption, accelerated engine wear, and even engine damage. Below is some information about the exhaust valve: 1. Introduction: The exhaust valve, also known as the oil-gas separator or pressure control valve, is installed between the compressor outlet and the condenser inlet. It improves the heat transfer efficiency in the condenser and evaporator by separating oil and gas. 2. Function: Its purpose is to allow a small portion of the exhaust gas to recirculate into the cylinder for combustion. This small amount of exhaust gas lowers the combustion temperature in the cylinder and reduces the NOX content in the exhaust gas.
Was this review help?
19
3
Share
More Forum Discussions

How to Replace the Remote Key Battery for Ford Mondeo?

Here is the method for replacing the key battery for the Ford Mondeo: 1. First, press and hold the top of the car key and pull upward firmly to remove the physical key. 2. Then, use the back of a utility knife to slide along the seam of the key to open it. 3. Remove the old battery, replace it with a new one, and finally close the key cover. Below is a brief introduction to the Ford Mondeo: The Ford Mondeo has body dimensions of 4873 mm in length, 1852 mm in width, and 1470 mm in height, with a wheelbase of 2850 mm. The Ford Mondeo features front-wheel drive, a front suspension type of MacPherson strut independent suspension, and a rear suspension type of multi-link independent suspension.
13
5
Share

How to use a newly installed ETC card?

The usage method of a newly installed ETC card is: 1. The ETC transaction sensing area is 8 meters. To prevent the ETC device of the vehicle in front from malfunctioning, maintain a distance of more than 10 meters from the vehicle in front; 2. The recognition speed for passing through an ETC lane is 20 kilometers per hour. If the speed is too fast, the vehicle device information cannot be read, which will result in a failed deduction; 3. When using a debit card to bind with ETC, insufficient balance will also cause a failed deduction. ETC uses dedicated short-range communication between the on-board electronic tag installed on the vehicle's windshield and the microwave antenna in the ETC lane at the toll station. It employs computer networking technology to perform backend settlement processing with the bank, achieving the purpose of vehicles passing through highway or bridge toll stations without stopping to pay the highway or bridge fees.
8
1
Share

Why can't the car window be rolled down?

The reason why the car window cannot be rolled down is: insufficient oil in the door's internal lifting mechanism, causing the window lift motor to enter an overheating protection state. The car window is an essential component of the vehicle body, designed to meet the needs of interior lighting, ventilation, and the visibility of drivers and passengers. Depending on the installation position of the glass, car windows can be categorized into: front and rear windshields, side windows, and door windows. Their design structure and quality significantly impact the driver's visibility, passenger comfort, exterior aesthetics, and aerodynamic characteristics. The causes of abnormal noises during car window operation include: 1. Loose fastening screws or lift mechanism brackets inside the window glass; 2. Aging of the window glass's sealing strip; 3. Debris in the window glass guide rails.
20
2
Share

How to Turn on the Air Conditioning in the Excelle?

The method to turn on the air conditioning in the Excelle is: 1. Press the AC switch to turn it on; 2. Adjust the appropriate temperature and air outlet mode; 3. According to the principle that hot air rises, direct the cold air upward. The body dimensions of the Excelle are: length 4609mm, width 1798mm, height 1486mm, wheelbase 2640mm, and fuel tank capacity 44L. The Excelle is equipped with a 1.3T turbocharged engine, with a maximum horsepower of 163, maximum power of 120 kW, maximum power speed of 5500 rpm, matched with a 6-speed automatic transmission. It adopts a front suspension type of MacPherson independent suspension and a rear suspension type of multi-link independent suspension.
17
5
Share

What needs to be replaced at the 20,000-kilometer maintenance?

At the 20,000-kilometer maintenance, the following items need to be replaced: 1. Engine oil; 2. Oil filter; 3. Fuel filter; 4. Air filter; 5. Cabin air filter; 6. Spark plugs; 7. Coolant. The benefits of car maintenance are: 1. Ensuring the vehicle is in good working condition; 2. Effectively improving vehicle efficiency and reducing wear on parts and tires; 3. Enhancing driving safety; 4. Preventing vehicle breakdowns; 5. Reducing noise and environmental pollution; 6. Keeping the vehicle's appearance clean and preventing damage. Precautions for car maintenance include: 1. Using high-quality lubricants; 2. Performing scientific and reasonable repairs; 3. Maintaining proper tire inflation.
4
5
Share

What is the maintenance interval for the Honda Accord?

Honda provides a three-year or 100,000-kilometer (whichever comes first) warranty for the Accord. According to the maintenance manual, the service interval for the Accord is every 5,000 kilometers. More details are as follows: 1. The current Accord is equipped with three engines: a 2.0L, a 2.4L, and a 3.0L V6 naturally aspirated engine. The 2.0L and 2.4L engines are paired with a CVT transmission, while the 3.0L engine is matched with a 6-speed automatic transmission. 2. The first maintenance for the Accord is required at 5,000 kilometers. This free service can be performed at any GAC Honda 4S dealership nationwide, primarily involving vehicle condition inspection and oil and oil filter replacement. Subsequent maintenance services will be based on this, with decisions on replacement or cleaning/adding made according to the wear and tear of various fluids and components.
12
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.