What are the common faults of the 2010 Tiguan?

1 Answers
MacMariana
07/29/25 7:27pm
Internal abnormal noise after vehicle startup: After starting, there is abnormal noise in the B-pillar, sunroof, and instrument panel. Since this issue falls under the three-guarantee recall scope, if the problem is severe, it is recommended to go to a 4S shop for a comprehensive inspection. Once the issue is confirmed to be due to quality assembly problems, you should strive for your deserved benefits through the three-guarantee policy. Additionally, if the vehicle's odometer has been tampered with privately, it cannot be replaced for free, which is something to be aware of. Idle vibration and EPC light on: Check the electrical wiring according to the principle, focusing on whether the vehicle frame has undergone severe collision repairs. Clean the throttle valve and inspect the brake lines. High air conditioning temperature: The vehicle's air conditioning temperature is high, and the air volume is low. First, conduct an air conditioning system inspection to test the temperature and air volume to determine if the air volume is normal, thereby ruling out a blower fault. Then check the main fan of the air conditioning. Abnormal noise at the rear of the engine: After starting the vehicle, there is abnormal noise at the rear of the engine. If the noise is excessively loud, it may be due to a damaged ABS pump or the need to replace the brake fluid. If necessary, use an automotive stethoscope for detailed detection.
Was this review help?
8
5
Share
More Forum Discussions

What components does the lock-up clutch consist of besides the driving part and the driven part?

Clutch is composed of transmission steel belt, pressure plate, flywheel, crankshaft, driven plate, front support ring, rear support ring, release hook, release bearing, transmission input shaft, clutch cover, diaphragm spring, etc. The following is the relevant introduction about the clutch: 1. Clutch: The clutch is located in the flywheel housing between the engine and the transmission. The clutch assembly is fixed to the rear plane of the flywheel with screws. The output shaft of the clutch is the input shaft of the transmission. During driving, the driver can step on or release the clutch pedal as needed to temporarily separate and gradually engage the engine and the transmission, so as to cut off or transmit the power input from the engine to the transmission. 2. The principle of releasing the clutch: The principle of releasing the clutch is: "slow first, fast second, and linkage third". When stepping on the clutch pedal, it should be fast and stepped to the bottom at one time. When lifting the pedal, the free travel should be fast, and it should be slow when approaching contact. When reaching the semi-linkage point, it should pause slightly, and then release. This is the process. The key point of this process is to find the semi-linkage point accurately. To control the speed well, the semi-linkage point is the dividing point. Lift it up fast and press it down slow, adjust downward, and choose the speed that suits you.
11
0
Share

Why does the car air conditioning not cool when not accelerating?

Here are the specific reasons why the car air conditioning does not cool when not accelerating: 1. Dirty air filter: If maintenance has not been performed for a long time, the filter may be too dirty, affecting the cooling efficiency of the air conditioning. 2. Dirty condenser: A dirty condenser can also lead to poor cooling performance. The car air conditioning condenser is located at the front of the vehicle and can be rinsed with a water hose. 3. Insufficient refrigerant: A lack of refrigerant in the air conditioning system's pipelines reduces pressure, resulting in poor cooling. Refill the refrigerant and check for any refrigerant leaks in the air conditioning pipes.
4
4
Share

How to Turn on the Fog Lights on a Skoda Octavia?

Skoda Octavia fog light activation method: Turn the light control knob on the left side of the steering wheel to the right to the small light or low beam positions. The first position activates the front fog lights, and the second position activates the rear fog lights. Additional information about fog lights: 1. Front fog lights are usually bright yellow, while rear fog lights are red. 2. The symbols for front and rear fog lights differ slightly—the front fog light symbol has downward light lines, while the rear fog light symbol has parallel lines, typically located on the dashboard inside the car. 3. Fog lights are highly bright and penetrating, preventing diffuse reflection caused by fog. Proper use can effectively prevent accidents.
20
1
Share

What series is Mercedes in relation to Benz?

Mercedes is not a specific series of Benz; they are actually the same automotive brand. Meaning of the names: "Mercedes" means happiness, signifying that Daimler's automobiles would bring happiness to their owners. Benz, a German car brand, is regarded as one of the world's most successful premium automobile brands, renowned for its perfect technical standards, exceptional quality benchmarks, innovative capabilities, and a series of classic coupe models. Product lineup: Currently, it mainly produces C-Class (mid-range sedans and coupes), E-Class (premium sedans and coupes), S-Class (luxury sedans and coupes), and G-Class (SUV off-road vehicles).
18
3
Share

What does TPS mean in cars?

Automotive TPS stands for Toyota Production System. Here are the specific details about the Toyota Production System: 1. Concept: The Toyota Production System is a comprehensive production management methodology created by Toyota Motor Corporation of Japan. It includes a complete production management technology system covering business philosophy, production organization, logistics control, quality management, cost control, inventory management, on-site management, and continuous improvement. 2. Goal: The objective of the Toyota Production System is to eliminate waste and reduce costs, with Just-in-Time (JIT) and automation as its pillars, and based on continuous improvement activities.
17
2
Share

What is the trunk size of the Custo?

The trunk size of the Custo is 262L. Introduction to the Custo: The overall dimensions are 4950/1850/1734mm, with a wheelbase of 3055mm. It features Hyundai's latest family design, with a distinctive hidden daytime running light at the front. It is equipped with two powertrain options: 1.5T/2.0T+8AT. The 1.5T engine delivers a maximum power of 125kW (170 horsepower) and a maximum torque of 253Nm. Trunk sizes of mainstream MPVs: The Buick GL8 has a trunk capacity of 475L, the Trumpchi M8 offers 635L, and the Odyssey provides 259L.
10
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.