What are the changes in Volvo's 2.0 system upgrade?

Why Does BYD Charging Always Stop Automatically?

BYD charging frequently stops automatically for the following reasons: 1. Automatic power cut at the start of charging: This is most likely due to battery damage or poor contact. 2. Abnormal faults during the charging process: The charging system will automatically cut off power, and a fault prompt will appear on the electric vehicle's instrument panel or corresponding fault information will be displayed on the charging equipment. 3. Automatic power cut after the battery is fully charged: This is a normal phenomenon caused by the protection function. If the issue does not fall under the above scenarios, please seek assistance from professionals at a repair shop.

13

4

Share

How to Correct Left Side Being Too Wide When Reversing into the Garage?

When reversing into the garage, it's crucial to maintain a steady speed, especially when backing in from the right side. If the distance between the car body and the right front corner is wider than three fingers, there's no need to adjust the steering wheel. If it's narrower, turn the steering wheel back half a turn. Once you see the right rear corner, immediately check the left rearview mirror. As soon as you spot the left bottom corner, straighten the wheel immediately, then gradually fine-tune the direction.

19

4

Share

Do I need to empty the trunk for vehicle inspection?

Vehicle inspection does not require emptying the trunk. Here are the relevant details: Vehicle annual inspection can be done three months in advance: According to the "Motor Vehicle Registration Regulations", vehicle owners can apply for the inspection compliance mark at the vehicle management office of the registration location within three months before the expiration of the motor vehicle inspection validity period. Bring your driver's license, ID card, vehicle registration certificate, and the current valid compulsory traffic insurance policy. Exempt vehicles: For motor vehicles within the exemption scope, prepare the above materials and go to the nearest vehicle management office to handle the annual inspection. Staff will input the corresponding motor vehicle and compulsory traffic insurance information into the system, and you can then receive the new inspection compliance mark.

10

3

Share

What Causes the Sand-Like Friction Sound When Rolling Up the Window?

Window glass seal aging: The abnormal noise when rolling up the car window glass may be caused by aging of the window glass seal. After the seal ages, the friction increases, leading to the noise. This situation tends to be more noticeable in summer, as the aged seal expands more significantly after exposure to sunlight, resulting in greater friction and more severe noise. Dirty gap between the glass and seal: Another possible reason is that the gap between the glass and the seal is too dirty. Particles in the dust rubbing against the glass can also produce abnormal noise.

11

4

Share

How to Clean Engine Scale?

Here are the steps for cleaning engine scale: 1. After the engine reaches normal operating temperature and is turned off, drain the coolant and add cleaning agent to the cooling system. 2. Restart the engine and let it run at medium speed for 5~10 minutes. During this period, you can also vary the speed to more systematically flush out deposits in the system, then turn off the engine and let it sit for 10~12 hours. 3. Start the engine again, let it run at medium speed for 5~10 minutes, then turn it off and drain the cleaning agent while it's still hot. 4. Repeat the above steps 3~4 times until the discharged cleaning agent is free of contaminants, then reinstall the thermostat.

20

3

Share

Why does the Hyundai ix35 power on but not start with one-key start?

There are two possible reasons why the Hyundai ix35 powers on but does not start with one-key start: 1. Remote key battery dead: First, check if the smart remote key is out of battery. If confirmed, you can press the engine one-key start button directly with the side of the key that has the lock button aligned at a right angle while the transmission is in P or N gear and the brake pedal is depressed. This will start the engine. 2. Other common situations: Poor contact inside the one-key start button or poor connection of the button plug; starter and starting circuit failure; poor contact in the body and engine grounding circuits, etc.

1

2

Share

What are the changes in Volvo's 2.0 system upgrade?

Why Does BYD Charging Always Stop Automatically?

How to Correct Left Side Being Too Wide When Reversing into the Garage?

Do I need to empty the trunk for vehicle inspection?

What Causes the Sand-Like Friction Sound When Rolling Up the Window?

How to Clean Engine Scale?

Why does the Hyundai ix35 power on but not start with one-key start?

How to Drive an Automatic Transmission Car Through Water

How to Turn On and Off the Interior Ambient Lighting?

How to Remove Mold from Car Seats?

How to Remove Paint from Leather Seats?