What are the causes of rear shock absorber noise in the Baojun 730?

1 Answers
DelFelix
07/29/25 7:29pm
Baojun 730 rear shock absorber noise causes are as follows: Shock absorber itself leaking oil or bent: The solution is to check whether the shock absorber is leaking oil. Under conditions of no rain or car washing, directly inspect the shock absorber housing or dust cover. A faulty shock absorber will feel unusually hard when pressed, which is a symptom of oil leakage in the later stages. The shock absorber should be replaced directly. Shock absorber pressure bearing aging or abnormal wear: The solution is to directly replace the shock absorber pressure bearing or perform lubrication. Caused by deformed shock absorber spring: The solution is to directly replace the shock absorber spring. Wheel bearing noise: Directly replace the wheel bearing.
Was this review help?
5
3
Share
More Forum Discussions

What is the pin configuration of a car's OBD interface?

Taking the Volkswagen New Passat as an example, the OBD diagnostic interface has 16 pins. Pin 16 is the constant power line. Pins 4 and 5 are ground wires. Pin 1 is the 15a ignition switch control line. Pin 7 is the K diagnostic wire. Pins 2, 3, 6, and 8 are CAN high bus lines. Pins 9, 10, 11, and 14 are CAN low bus lines. Pin 15 is the airbag diagnostic line. Pins 12 and 13 are empty positions. More details are as follows: 1. OBD is the abbreviation for On-Board Diagnostics, which translates to "on-board automatic diagnostic system" in Chinese. 2. This system continuously monitors the engine's operating conditions to check if the vehicle's emissions exceed the standard. If they do, it will immediately issue a warning.
3
0
Share

How to Deal with Slightly Deformed Wheel Hubs?

The method to handle slightly deformed wheel hubs is to perform dynamic balancing for the vehicle. The steps are as follows: 1. Remove and clean the tire, then take off the old balancing weights; 2. Place the tire on the dynamic balancing machine and secure it with clamps; 3. Measure the required values for the dynamic balancing machine; 4. After the tire stops, the dynamic balancing machine will display the deviation value of the tire; 5. Rotate the tire by hand. When the dynamic balancing machine shows full bars on both the inner and outer sides, add balancing weights according to the corresponding values. Dynamic balancing refers to the operation of determining the position and size of the unbalanced amount generated when the rotor rotates and eliminating it. The unbalanced amount can cause lateral vibration of the rotor, subjecting it to unnecessary dynamic loads and adversely affecting its normal operation.
8
0
Share

What are the consequences of a faulty EGR valve in a common rail fuel injection system?

The consequences of a faulty EGR valve in a common rail fuel injection system are: 1. Difficulty in engine starting and weak acceleration; 2. Failure to meet emission standards; 3. Black smoke from the vehicle's exhaust pipe; 4. Unstable idle or stalling at idle; 5. Flashing of the malfunction indicator light; 6. Burning of engine oil. Methods to clean the EGR valve in a common rail fuel injection system are: 1. Spray carburetor cleaner into the intake passage; 2. Spray carburetor cleaner onto the throttle body. The EGR valve is a mechatronic product installed on diesel engines to control the amount of exhaust gas recirculated back to the intake system, located on the right side of the intake manifold near the throttle body.
8
4
Share

What are the advantages and disadvantages of small-displacement turbocharging?

Advantages of small-displacement turbocharged engines: 1. They increase engine air intake without raising displacement, thereby boosting power while keeping fuel consumption from rising too much. 2. Small-displacement turbocharged engines provide higher torque at low RPMs, making this power delivery more suitable for urban driving. 3. They have great modification potential—some engines can gain 40-50 horsepower just by reprogramming without any hardware modifications. Disadvantages of small-displacement turbocharged engines: 1. To reduce turbo lag, many small-displacement turbocharged engines use small-inertia turbos, which can cause pressure drop at high RPMs. 2. Their advantages disappear during high-speed driving, where naturally aspirated engines perform better. 3. Their power delivery is not linear. 4. Maintenance costs are slightly higher than naturally aspirated engines due to the need for higher-quality engine oil.
4
1
Share

Does the Enclave have a 5-seater version?

The Enclave does not have a 5-seater version. Below is relevant information about the Enclave: Design: The Enclave is positioned as a mid-to-large-size SUV, featuring a 7-seat layout. As a mid-to-large-size SUV launched by Buick, it adopts the brand's new family design language. The front fascia boasts high recognition with its large grille seamlessly connected to the headlights, creating a more stylish appearance. Performance: The Enclave is equipped with a 2.0T turbocharged engine (model LSY), delivering a maximum power of 169kW and peak torque of 350Nm. It is paired with a 9-speed HYDRAMATIC automatic transmission.
5
1
Share

What does the license plate Meng D belong to?

Meng D is the license plate code for Chifeng City. The license plate codes for other regions in Inner Mongolia are as follows: Meng A for Hohhot City, Meng B for Baotou City, Meng C for Wuhai City, Meng E for Hulunbuir City, Meng F for Xing'an League, Meng G for Tongliao City, Meng H for Xilin Gol League, Meng J for Ulanqab City, Meng K for Ordos City, Meng L for Bayannur City, and Meng M for Alxa League. License plates, commonly known as vehicle tags, refer to the plates affixed to the front and rear of a vehicle. They are typically made of materials such as aluminum, sheet iron, plastic, or paper, and display the vehicle's registration number, registration region, and other relevant information.
9
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.