What Are the Causes of Paint Peeling?

1 Answers
TuckerRose
07/25/25 4:11am
Paint Peeling Causes and Precautions: Causes of Paint Peeling: Inadequate surface preparation before painting; failure to use intermediate paint to enhance film adhesion; mismatched selection of auxiliary materials such as thinners and hardeners; specialized primers for specific substrates are recommended for superior adhesion. Precautions for Painting: Remove dust from the vehicle body promptly before use to minimize static electricity attracting dust. Wash the car thoroughly after rain, as the concentration of acidic substances in rainwater residues increases significantly, potentially damaging the paint if not cleaned promptly.
Was this review help?
3
0
Share
More Forum Discussions

What to Do If a China III Motorcycle Cannot Be Licensed?

If a China III motorcycle cannot be licensed, you must not continue to drive it on the road, as it is considered illegal. If an unlicensed motorcycle is discovered, the following penalties will apply: 1. Points deduction: The driver's license can be deducted up to 12 points. 2. Fines and detention: Detention for up to 15 days and a fine. Relevant information about China III is as follows: 1. China III: The so-called China III standard refers to China's third-stage vehicle emission standards. The national third-stage emission standard is equivalent to the European III emission standard, meaning the content of tailpipe pollutants is equivalent to that of Euro III. The difference is that new vehicles must be equipped with an OBD, or onboard diagnostic system. 2. Significance: To improve air quality and further curb the pollution caused by vehicle emissions, higher-standard energy-saving and emission-reduction policies will be gradually implemented nationwide.
8
5
Share

How much does the needle drop during hill start?

When the clutch is in the semi-engaged state during a hill start, the engine speed will be maintained at around 1000 RPM. Here is the relevant information: 1. Hill start: A hill start is part of the on-site test for the second subject of the driver's license examination, which involves starting a vehicle parked on a steep slope. 2. Hill start test rules: (1) If the vehicle stops and the front bumper (for cars) or front axle (for motorcycles) is not aligned with the pole line, and the deviation exceeds 50 cm, it results in failure. (2) If the vehicle stops and the front bumper (for cars) or front axle (for motorcycles) is not aligned with the pole line, but the deviation does not exceed 50 cm, 10 points are deducted (originally 20 points). (3) If the vehicle stops and the body is more than 30 cm away from the road edge line, 10 points are deducted (originally 20 points). (4) If the vehicle starts and rolls back between 30 cm and 50 cm, 20 points are deducted. (5) If the vehicle starts and rolls back more than 50 cm, it results in failure. (6) If the engine stalls on the slope, 20 points are deducted. (7) If the vehicle does not start within 30 seconds after stopping, it results in failure due to timeout.
20
1
Share

Where is the transmission cooling valve installed on the Audi A8?

It is located under the left side of the body, between the transmission and the radiator, where two water pipes are connected, specifically on the left side of the radiator, in front of the left front wheel liner. Transmission oil replacement interval: It is best to replace it once after 17,000 kilometers. Although manual transmission oil may not cause discomfort beyond 17,000 kilometers, this is a critical point. Function of transmission oil: During transmission operation, a significant amount of heat is generated, and the transmission oil helps dissipate this heat. In daily driving, gears must be shifted according to driving conditions, and transmission oil needs to be lubricated to ensure smoother gear changes. This helps maintain the cleanliness of the transmission system and prolongs the lifespan of the transmission components.
13
1
Share

What is the recovery method for a malfunctioning Buick remote key?

Here are the situations and solutions for a malfunctioning car remote key: 1. Insufficient battery power: If the car remote key malfunctions, the first thing to check is whether the battery is low. A dead battery can also cause a situation that resembles remote malfunction. In this case, replace the key battery to see if the situation improves. 2. Sealing issues: If the key has power but the remote function is not working, prolonged use may lead to internal moisture or dirt oxidation due to sealing problems, causing the buttons to gradually become less responsive. In this case, disassemble the key shell and use a cotton swab dipped in alcohol to clean the button base on the internal circuit board of the key. 3. Poor circuit board contact: Another possible reason for a malfunctioning car remote is poor circuit board contact. This situation requires soldering, but since the solder points are very small and most car owners lack tools like a soldering iron, it is recommended to take it to a professional electronics repair shop or a mobile phone repair shop for handling.
5
5
Share

What is the load capacity of the Haval H9?

The Haval H9 has a curb weight of 2.25 tons, an equipped mass of 2.369 tons, and a maximum allowable total mass of 2.95 tons. In terms of power: The new 2.0T gasoline twin-scroll high-power engine delivers a maximum power of 165KW and a maximum torque of 385N-m (1800-3600rpm). It incorporates technologies such as direct fuel injection, twin-scroll turbocharger, dual VVT, and dual side-mounted balance shafts. In terms of configuration: It is equipped with full-speed ACC adaptive cruise control, 4-level distance adjustment for automatic following, supporting follow-up functions on curves with a radius >125 meters; includes stop-and-go functionality and the ability to follow from a standstill; and performs well in adverse weather conditions such as rain, snow, and fog.
15
0
Share

How much engine oil should be added to a BMW X1?

Approximately 4 liters, ensuring the oil level is between the upper and lower marks on the dipstick. Recommendations for adding engine oil: Considering the normal wear and tear of the engine, the gaps between mating surfaces increase, and the viscosity of the engine oil should gradually increase as the vehicle ages. For vehicles under 50,000 kilometers, it is recommended to use relatively thinner engine oil. After 50,000 kilometers, slowly increase the viscosity of the engine oil, which provides the most suitable protection for the engine. Notes on topping up engine oil: When topping up, add the oil gradually, checking the level with the dipstick after each addition to avoid overfilling. The oil level is considered appropriate as long as it reaches the middle line of the "measurement area."
13
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.