What are the causes of abnormal tire pressure?

1 Answers
Joel
07/30/25 12:39am
Tire pressure abnormalities can be caused by: 1. Seasonal factors—high temperatures in summer cause tire pressure to expand due to heat, while low temperatures in winter cause it to contract; 2. Tire-related issues, such as poor sealing due to prolonged use, leading to minor air leaks and low pressure; 3. Punctures from sharp objects while driving, causing air loss and low pressure. Hazards of abnormal tire pressure: 1. Reduced friction and grip, affecting braking performance; 2. Accelerated wear, shortening tire lifespan; 3. Increased risk of blowouts; 4. Vehicle instability and loss of shock absorption capability.
Was this review help?
3
2
Share
More Forum Discussions

What Causes the Reversing Camera Screen to Go Black?

The reasons for the reversing camera screen going black are: 1. Aging of the video power cable: Try replacing it with a new one. If the black screen issue is resolved, it indicates a problem with the video power cable. 2. Wiring issues: This is the most common cause of failure. Since the wiring harness for the reversing camera runs from the dashboard to the trunk, the lengthy route increases the likelihood of poor contact at some point in the harness or connectors, requiring thorough inspection. 3. Prolonged use of the reversing camera leading to poor chip photosensitivity, resulting in a black screen.
13
4
Share

What Position Is One Full Turn of the Steering Wheel?

Steering wheel rotation of one full turn means turning 360 degrees. Steering wheel: A wheel-shaped device in cars, ships, airplanes, etc., used to control the direction of travel. Its function is to convert the force applied by the driver to the edge of the steering wheel into torque and then transmit it to the steering shaft. In an S-curve, you should steer towards the wider side. Below is some information about S-curves: 1. Precautions: Use the rearview mirror to check behind you; if the rear of the car is wider on one side, steer towards that side. Avoid reversing too quickly and make corrections as needed to prevent collisions. Generally, avoid turning the wheel fully to prevent scraping the front corners of the car. It's best to have someone observe and remind you from outside the car. 2. Principle: Steering follows the rule of 'turn as much as you need to correct, turn quickly if you need to correct quickly, turn slowly if you need to correct slowly.' For example, if the left rear of the car is wider, turn the wheel 90 degrees to the left. When you are about to achieve the desired effect, turn the wheel 90 degrees back to the right. The speed of turning follows the same principle.
4
5
Share

Is It Necessary to Pass Through Neutral Gear When Shifting?

When driving, it is not necessary to pass through neutral gear every time you shift. For manual transmission vehicles, in the past, you had to press the clutch to shift from first gear to neutral, release the clutch, then press the clutch again to shift from neutral to second gear. This practice was relevant for transmissions without synchronizers. Relevant information about the clutch is as follows: 1. Introduction: The clutch is located inside the flywheel housing between the engine and the transmission. The clutch assembly is fixed to the rear plane of the flywheel with screws, and the output shaft of the clutch is the input shaft of the transmission. 2. Friction Clutch: The friction clutch is the most widely used and historically oldest type of clutch. It basically consists of four parts: the driving part, the driven part, the pressing mechanism, and the operating mechanism.
13
3
Share

What is the actual fuel consumption of the Renault Koleos?

The official combined fuel consumption of the Renault Koleos is 6.4-7.6L/100km. Here are the detailed specifications of the Koleos: 1. Vehicle Positioning: The Koleos is a compact SUV produced by Dongfeng Renault, with dimensions of 4672mm in length, 1843mm in width, and 1678mm in height, and a wheelbase of 2705mm. 2. Powertrain: The Koleos is equipped with either a 2.0L or 2.5L naturally aspirated engine, paired with a CVT transmission that simulates 7 gears. 3. Safety Features: Except for the base model, side airbags, side curtain airbags, electronic stability control, rain-sensing wipers, heated and power-folding mirrors are standard. The four-wheel-drive version comes standard with hill start assist and hill descent control.
8
0
Share

Why does the Tiguan L's battery only last for a little over 2 years?

It is mainly due to insufficient daily maintenance by the owner. Under normal circumstances, it can last for three years. Below are some precautions for car battery maintenance: 1. Avoid leaving the vehicle parked for extended periods: The car battery will self-discharge over time when left idle. It is best to drive the vehicle at least once a week, with a trip duration of at least 20 minutes, to allow the battery to recharge while driving. 2. Close windows before turning off the engine: The power windows and sunroof rely on the battery for operation. Therefore, it is advisable to close all windows before turning off the engine, rather than after. Avoid using the long-press lock button method to close windows after leaving the vehicle. 3. Keep the battery clean and tidy: Regular inspections are an effective way to extend the battery's lifespan. Use a professional battery terminal brush or an old toothbrush to clean dust and corrosion from the positive and negative terminals. Apply a layer of protective coating, such as petroleum jelly or grease, to the contact surfaces to form a protective film.
5
3
Share

Do You Need to Press the Brake for One-Button Start?

One-button start requires pressing the brake to ignite and start the engine. When starting the engine, you must press the brake pedal. If the brake pedal is not pressed, the engine will not start. This is a safety design in cars to prevent accidental activation of the switch, which could cause the vehicle to suddenly move forward. When the vehicle is turned off, pressing and holding the one-button start for 3 seconds without stepping on the brake will only power the electrical system without starting the engine. For some models, you need to press the ignition switch twice. Cars with one-button start are usually automatic. During one-button start, the engine goes through a high-speed starting process. If the driver does not press the brake, it may cause the car to lurch forward unexpectedly, potentially leading to a rear-end collision. Cars equipped with a one-button start system allow the driver to start the engine simply by carrying the key into the vehicle. There is no need to insert or turn the key—just press the brake pedal and the start button to ignite the engine. The one-button start system was originally used in racing cars, enabling drivers to quickly start the engine and get into the race. Later, this system was adopted for civilian vehicles. In addition to pressing the brake, when starting a one-button start car, it is also important to ensure the gear is in the P (Park) position. If the gear is not in P, the car will not start. If pressing the one-button start does not elicit any response, it could be due to a dead key battery or interference from nearby sources. In such cases, bringing the smart key close to the one-button start button while pressing the brake and the start button may allow the car to start.
8
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.