What are the body dimensions of the Karry K50?

1 Answers
MacIsabella
07/30/25 12:37am
The body dimensions of the Karry K50 are: length 4501mm, width 1760mm, height 1790mm, with a wheelbase of 2755mm, minimum ground clearance of 170mm, fuel tank capacity of 45 liters, and a curb weight of 1230kg. The Karry K50 is equipped with a 1.5L naturally aspirated engine, delivering a maximum power of 80kW and a maximum torque of 140Nm, paired with a 5-speed manual transmission. It features a front MacPherson independent suspension and a rear torsion beam non-independent suspension, with a front-wheel drive configuration.
Was this review help?
14
0
Share
More Forum Discussions

Do I need to change the color back for the annual vehicle inspection after a car color change?

It is not necessary to change the color back for the annual vehicle inspection after a car color change. Below is some information regarding the annual inspection of motor vehicles: Legal Basis: Article 32 of the "Regulations on the Registration of Motor Vehicles" stipulates that the owner of a motor vehicle may apply for an inspection compliance mark at the vehicle management office of the registration location within three months before the expiration of the vehicle's inspection validity period. Consequences: Vehicles that have not undergone the annual inspection within the required time and continue to be driven on the road will be subject to a fine of 200 yuan and a deduction of three points. Additionally, the vehicle may be temporarily impounded. Everyone must consciously undergo the annual inspection. The inspection can be done up to three months in advance, but it must not be overdue. Overdue inspections will result in additional fines. The timing of the annual vehicle inspection is determined based on the date of the vehicle's initial registration. For example, if the initial registration date on the motor vehicle license is June 2018, then the annual inspection time is every June.
10
3
Share

Where is the Mercedes GLK's warning triangle located?

The warning triangle of the Mercedes GLK300 is located inside the left trim panel in the trunk. Rotate the left trim panel in the direction of the arrow to open it and the triangle will be visible. How to use the Mercedes GLK300's warning triangle: Adjust the three legs to your desired height. The lower the legs are extended, the narrower the tube diameter becomes, making it less stable. Therefore, it is recommended to primarily use the upper leg sections when setting up. Based on the required height, first pull out the second section, then sequentially extend the lower sections, and finally pull out the end leg section. Introduction to vehicle warning triangles: The warning triangle in a car is used to alert following vehicles when you need to stop for emergency repairs due to sudden breakdowns or in the event of an accident, indicating that there is a vehicle with issues ahead and to proceed with caution.
13
2
Share

At what mileage should the second maintenance be performed for Volkswagen?

This can be completely determined according to the car maintenance manual, and it can be done at 10,000 kilometers. The items for the second car maintenance are as follows: Check if the steering free travel and toe-in meet the requirements: The steering should be light, flexible, and reliable, with no left-right wobbling or deviation of the front wheels during driving. Check if the clutch free travel meets the requirements: The operation should be convenient, with complete separation, smooth and reliable engagement, no abnormal noise, and no oil leakage in the hydraulic system. Check the gearbox and drive axle: Or ensure that the half-shaft transmission device and other components are well lubricated, reliably connected, with no abnormal noise or overheating, no gear jumping, flexible gear shifting, and no oil leakage.
4
3
Share

Which button is the mirror heater for the Corolla?

The rearview mirror heating button for the Corolla is located on the car's air conditioning control panel, specifically the middle one among the three rotary buttons. Principle of heated mirrors: The mirrors can be heated via heating wires embedded behind the mirror surfaces to ensure clear visibility. The heated rearview mirror function is particularly useful during rainy or snowy weather. When activated, the heater behind the mirror quickly warms the surface, gradually removing rainwater or fog, eliminating the need for drivers to manually wipe the mirrors frequently, thereby reducing driving hazards. Introduction to heated mirrors: Heated power mirrors refer to the side mirrors on both car windows. Firstly, they eliminate the need for manual angle adjustment - being electrically controlled, they typically have adjustment buttons near the driver's seat to modify the mirror angles. Secondly, these mirrors can automatically heat up, drying raindrops or snow accumulation on the surface during rainy or snowy conditions, thus maintaining clear visibility.
9
3
Share

Should Civic touch-up paint be done at a 4S shop or outside?

It is recommended to go to a 4S shop for painting, as the quality is better. Small shops outside may have some color differences. Precautions for painting are as follows: Do not wash the car: After the car is painted, the paint surface should be fine after a few days. Just after painting, pay attention to insufficient baking time. It is best not to wash the car when the paint surface is not completely dry. Avoid contact with oil stains: Do not come into contact with chemicals and oil stains, as they can easily damage the paint surface. Do not cover with a car cover: Try not to cover the newly painted car with a car cover, as it may cause fine scratches on the paint surface. Park in the sun as much as possible: First, it helps the paint surface to dry thoroughly, and second, it can also test the skills of the paint mixing technician.
14
3
Share

Is the Freon in Cars the Same as That in Household Air Conditioners?

Freon in cars is the same as that in household air conditioners. Below is a partial introduction about car air conditioners: Lack of refrigerant or leaks: Most cases of insufficient cooling are due to a lack of refrigerant. You can first measure the air conditioning pressure. If both high and low pressures are low, it is likely a lack of refrigerant, and you simply need to add refrigerant until the pressure is appropriate. Excessive pressure in the air conditioning system: The car air conditioning system has its own pressure due to the compressor's operation. When too much refrigerant is added or there is a blockage in the pipeline, the system pressure can become too high. In such cases, the control system will disengage the compressor's electromagnetic clutch, causing the compressor to shut down. The solution is simple: once excessive pressure is confirmed, release some refrigerant to restore normal pressure. Damaged evaporator temperature sensor or pressure switch: The evaporator, also known as the evaporator box, is located in the air duct under the dashboard. Here, the refrigerant vaporizes and absorbs heat to produce low temperatures. When air flows through the small channels above the evaporator, it is cooled. The compressor stops when the temperature approaches the frost point. If this sensor is damaged and frequently gives false readings of approaching frost temperature, the compressor will shut down frequently.
18
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.