What are the body dimensions of the 9-seater Iveco?

Can the Prado h4f and h4l be switched at will while driving?

The Prado h4f and h4l can be switched while driving, but it is not recommended to do so arbitrarily. Characteristics of four-wheel drive: A manual transfer case is installed behind the transmission, and a component called the drive axle is installed on each of the front and rear axles. The torque output from the transmission is transmitted to the drive axles on the front and rear axles through the transfer case and drive shaft, and then the torque is transmitted to the wheels through the drive axles. Internal design of four-wheel drive: The four-wheel drive system is a full-time type, equipped with a viscous coupling, eliminating the need for a manual transfer case, and automatically distributing torque to the front and rear wheels as needed. On normal road surfaces, the four-wheel drive system distributes 92% of the engine's output torque to the front wheels and 8% to the rear wheels; on slippery road surfaces, at least 40% of the engine's output torque is distributed to the rear wheels. When the front wheels begin to slip, the speed difference between the front and rear wheels will cause the viscous fluid in the coupling to immediately thicken and lock the coupling, so that the drive shaft only transmits torque to the rear wheels.

1

5

Share

How to Reset the Wrench Icon on Chery Fengyun 2?

The steps to clear the wrench icon on Chery Fengyun 2 are as follows: 1. With the car turned off, press and hold the button on the dashboard, which is the small black lever used to adjust time and reset the odometer. 2. Turn the ignition switch to the "ON" position while keeping the reset lever pressed. 3. Wait a few seconds, then release the small black lever. 4. Press and hold the small black lever again, then gently rotate it to the right to clear the wrench icon. 5. The wrench icon on the dashboard is the car's maintenance reminder light. When it lights up, it indicates that the car requires maintenance. Regular maintenance includes three aspects: body maintenance, interior maintenance, and body refurbishment.

4

3

Share

Can a car that uses 92 gasoline be filled with 95 gasoline?

92 gasoline cars can be filled with 95 gasoline. However, it may lead to incomplete combustion, so long-term mixed use is not recommended. Below is some extended information: 1. Gasoline octane rating: It represents the ratio of the actual gasoline's anti-knock performance to that of standard gasoline. The higher the octane rating, the stronger the anti-knock performance. Standard gasoline is composed of isooctane and n-heptane. However, a higher octane rating is not always better; the appropriate gasoline grade should be selected based on the engine's compression ratio. 2. Switching from a lower octane gasoline to a higher one does not cause significant harm to the vehicle. However, it may result in incomplete combustion, and higher octane gasoline is generally more expensive, reducing fuel economy.

2

5

Share

What does the ECO mode in car air conditioning mean?

ECO stands for Economic Mode. When the ECO switch is pressed, the air conditioning operates in economic mode, where the set temperature of the car's air conditioning cooling system is relatively higher. This means the compressor operates for shorter durations, reducing the engine load and saving fuel consumption. Here are some details about the ECO mode: 1. Energy-saving principle: The vehicle's computer assesses factors affecting fuel consumption, such as transmission gear position, engine speed, and transmission oil temperature, to rationally control these gears and reduce unnecessary fuel usage. 2. ECO mode may become ineffective under the following conditions: when the vehicle speed exceeds 120km/h; during idle or in N/P gear; or when the car requires significant power to operate.

1

2

Share

Does the Audi A6L have tire pressure display?

The Audi A6L has tire pressure display, which is located on the central dashboard. Tire pressure, strictly speaking, refers to the air pressure inside the tire. There are three commonly used tire pressure monitoring methods: Direct tire pressure monitoring: The direct tire pressure monitoring device uses pressure sensors installed in each tire to directly measure the tire pressure. It uses a wireless transmitter to send the pressure information from inside the tire to a central receiver module, and then displays the tire pressure data for each tire. When the tire pressure is too low or there is a leak, the system will automatically issue an alarm. Indirect tire pressure monitoring: When the pressure of a tire decreases, the weight of the vehicle will cause the rolling radius of that wheel to become smaller, resulting in a faster rotation speed compared to other wheels. By comparing the differences in rotation speed between the tires, the purpose of monitoring tire pressure is achieved. The indirect tire pressure warning system actually relies on calculating the rolling radius of the tires to monitor the pressure. Introduction to the Tire Pressure Monitoring System (TPMS): It combines the advantages of the two systems mentioned above. Direct sensors are installed in two diagonally opposite tires, and a 4-wheel indirect system is also equipped. Compared to using only a direct system, this hybrid system can reduce costs and overcome the defect of the indirect system, which cannot detect when multiple tires simultaneously have low pressure. However, it still cannot provide real-time data of the actual pressure in all four tires like the direct system does.

3

1

Share

What is the recommended tire pressure for BMW F750GS?

The optimal tire pressure for BMW F750GS should be maintained between 2.3bar and 2.5bar. During vehicle operation, maintaining proper tire pressure ensures normal usage. Abnormal tire pressure may cause irregular driving conditions. Hazards of underinflation: Increased friction with road surface leads to higher fuel consumption; Causes heavy steering and potential alignment issues, compromising driving safety; Excessive tire movement generates abnormal heat from over-compression; Degrades cord and rubber functionality, potentially causing delamination or cord breakage, along with excessive rim friction damaging bead areas and causing irregular wear; Exponentially increases ground friction, rapidly raising tire temperature and softening rubber, drastically reducing strength. High-speed driving may result in blowouts; Increases tire deformation, causing sidewall cracks and flexing movements that generate excessive heat, accelerating rubber aging, fabric fatigue, and cord breakage, while enlarging contact area and accelerating shoulder wear. Hazards of overinflation: Reduces tire friction and adhesion, affecting braking performance; Causes steering wheel vibration and alignment issues, reducing driving comfort; Accelerates central tread wear, shortening tire lifespan; Increases vehicle vibration, indirectly affecting other components' longevity; Overextends tire cords, reducing elasticity and increasing operational load; Decreases puncture resistance. Sharp objects like nails or glass may easily penetrate, causing internal cracks or blowouts upon impact.

19

1

Share

What are the body dimensions of the 9-seater Iveco?

Can the Prado h4f and h4l be switched at will while driving?

How to Reset the Wrench Icon on Chery Fengyun 2?

Can a car that uses 92 gasoline be filled with 95 gasoline?

What does the ECO mode in car air conditioning mean?

Does the Audi A6L have tire pressure display?

What is the recommended tire pressure for BMW F750GS?

Does the Bora Legend have only one rear fog light?

What is MacPherson Suspension?

What is the reason for the electric tailgate malfunction in the Mercedes-Benz E300L?

Where is the oil filter located on the Passat?