What are the body dimensions of the 2021 Camry?

1 Answers
DelManuel
07/29/25 6:33pm
In terms of body dimensions, the new Camry measures 4850 mm in length, 1825 mm in width, and 1480 mm in height, placing it at a mainstream level among its current peers. Its wheelbase remains unchanged at 2775 mm. Here are more details: Powertrain: The vehicle is equipped with either a 2.0L or 2.5L engine, delivering maximum output power of 131kw/6600rpm and 154kw/6600rpm, respectively. Transmission: It offers a choice between a 10-speed continuously variable transmission and an 8-speed automatic manual transmission.
Was this review help?
12
5
Share
More Forum Discussions

What does Skoda Rapid mean?

Skoda "RAPID" is known as "Xin Rui" in Chinese, an A-class entry-level sedan launched by SAIC Skoda. In the naming of this car, "Xin" symbolizes the first light of dawn, representing new hope and new strength; "Rui" means moving forward courageously and forging ahead with determination. Below is more information about the Skoda Xin Rui: Configuration: The Skoda Xin Rui is a car developed by Volkswagen based on the PQ25 platform. It comes standard with ABS anti-lock braking system and EBD electronic brake-force distribution system. Power: The Skoda Rapid is equipped with a 1.5-liter naturally aspirated engine, featuring front-engine, front-wheel-drive layout, electric power steering, and a handbrake for parking. Body dimensions: The Skoda Rapid has a body length, width, and height of 4512mm, 1706mm, and 1469mm respectively, with a wheelbase of 2603mm.
17
5
Share

What is a Center-Axle Trailer?

Center-axle trailers are a type of full trailer where the axles are positioned in the middle. Due to stability concerns, full trailers are explicitly prohibited from driving on highways by national regulations. Relevant details are as follows: Introduction to Center-Axle Trailers: A trailer with two axles, both placed in the middle of the trailer, is called a center-axle trailer. Because both axles are located in the middle, a center-axle trailer cannot maintain balance on its own and requires support legs to 'stand' when not connected to another vehicle. Driving of Center-Axle Trailers: The towing device cannot move vertically (relative to the trailer), and the axle is located close to the trailer's center of gravity (under uniform load). This type of vehicle exerts only a small vertical static load on the towing vehicle, not exceeding 10% of the trailer's mass or 10,000N (whichever is smaller). One or more axles can be driven by the towing vehicle.
16
2
Share

How to properly turn off and power down the Changan CS75 when parking?

First, press the brake pedal to bring the vehicle to a smooth and steady stop; Then shift the gear from D (Drive) to N (Neutral); Next, engage the parking brake, being careful not to apply excessive force (for electronic parking brakes, simply pull up the switch); Release the foot brake, but do not turn off the vehicle's power at this point (this is to ensure the car is completely stationary under the parking brake's effect, preventing the P (Park) gear from locking up); Continue pressing the foot brake and shift the gear from N (Neutral) to P (Park); Finally, release the foot brake and press the one-touch start/stop button to power off the vehicle, completing the shutdown process.
13
4
Share

What Are the Reasons for No Hot Air from the AC After the Water Temperature Reaches 90 Degrees?

After the water temperature reaches 90 degrees, the reasons for no hot air from the AC include thermostat issues, water pump circulation problems, and airlocks in the cooling system. Thermostat Issues: Whether the thermostat is stuck open or closed, it can cause heating malfunctions. A thermostat stuck closed will prevent proper coolant circulation, leading to excessively high water temperature. If stuck open, the water temperature gauge will always read below 90 degrees, resulting in slightly warm air at idle but no heat at high speeds. Pay attention to the thermostat's operation. Water Pump Circulation Problems: Poor water pump circulation directly causes high water temperatures. Replacing the water pump will naturally resolve the heating issue. Airlocks in the Cooling System: An airlock in the engine's cooling system disrupts the normal operation of the car's coolant circulation, leading to no hot air. If the heater core's inlet pipe is hot but the outlet pipe is cold, it indicates a blockage in the heater core, which needs replacement.
18
4
Share

What is the lifespan of the third-generation EA888 in kilometers?

The lifespan of the third-generation EA888 is 600,000 kilometers. The Volkswagen EA888 engine is a newly designed engine by Volkswagen, incorporating a series of technologies such as direct fuel injection, turbocharging, and variable valve timing, achieving a balance between power and economic environmental protection. Building on the first two generations, the third-generation engine significantly optimized the oil burning issue and reduced the failure rate. The third-generation EA888 engine introduced new technologies such as hybrid injection (direct fuel injection + manifold injection) and an integrated exhaust manifold in the cylinder head. Additionally, the EA888 engine features dual balance shafts located on both sides of the lower end of the cylinder block, driven by the crankshaft and chain. The centrifugal force generated by the rotation of the two balance shafts is opposite to that generated by the crankshaft, canceling out most of the vibrations. This enhances the engine's dynamic balance characteristics and reduces noise.
3
3
Share

Why is there a hump in the middle of the rear seats in sedans?

The hump in the middle of the rear seats is designed for the flatness of the chassis. Here are the reasons for the hump in the middle of the rear seats: 1. The hump is due to the chassis underneath accommodating components like the exhaust pipe, brake lines, or drive shaft. 2. It ensures the flatness of the chassis. 3. The raised section between the front passenger and driver seats from front to back is a structural design. 4. The purpose is to enhance the longitudinal rigidity of the cabin. The hump is higher in four-wheel-drive (4WD) models for the following reasons: 1. Based on the same chassis assembly, both 4WD and two-wheel-drive (2WD) models are offered for consumers. 2. To save manufacturing costs, space is reserved for 2WD (front-wheel-drive) models (i.e., the hump accommodates the drive shaft for the 4WD system). 3. Some models have 4WD versions abroad but are not introduced in China, so some front-wheel-drive models may still have a higher rear hump.
13
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.