What are the body dimensions of the 2019 Jetta?

How Long Can a 7-Speed Dry Dual Clutch Transmission Last?

7-speed dry dual clutch transmissions typically come with an official warranty of 3 years or 100,000 kilometers. In theory, transmissions from any manufacturer can last between 10 to 20 years. Therefore, there is no need to worry about the lifespan of the transmission unless a major safety incident occurs. Relevant information about transmissions is as follows: 1. Introduction: A device that changes the speed ratio and direction of motion. It is used to alter the torque, speed, and direction of motion transmitted from the driving shaft to the driven shaft under different working conditions. Gear-driven transmissions generally consist of a housing and several gears. 2. Function: While driving, to adapt to different operating conditions, the vehicle's driving force and speed need to vary within a certain range. Since the existing engine's torque and speed variation range cannot meet this requirement, a transmission is installed.

5

0

Share

Should the clutch be fully depressed for hill-start parking?

Hill-start parking requires fully depressing the clutch. During the driving test, you must press the clutch when braking for hill-start parking. The clutch serves to cut off engine power during gear shifts or when stopping. The exclamation mark on the dashboard indicates three possible scenarios: 1. An exclamation mark inside a circled parenthesis: Brake pad damage or insufficient brake fluid. Solution: Release the parking brake and check if brake fluid is low. If the light remains on, visit a repair shop to replace the brake pads. 2. An exclamation mark inside a triangle: External light malfunction. Solution: Inspect the lights for faults. If no issue is found but the light persists, seek professional repair. 3. A yellow parenthesis with an exclamation mark: Tire pressure anomaly. Solution: Check for punctures or air leaks. If none, drive slowly to locate an auto repair shop, car care center, or roadside service for inflation. Monitor the dashboard afterward. If the warning light remains, access the vehicle's central console settings to recheck tire pressure. The light will turn off once normal pressure is detected.

4

3

Share

What Causes the Triangle Warning Light to Illuminate in a Car?

A triangle with an exclamation mark inside is a general fault indicator light. Common vehicle faults indicated by this light include overheating of the dry dual-clutch transmission, intervention or failure of the fuel cutoff system, parking sensor malfunction, external bulb failure, engine oil pressure sensor malfunction, and alerts or faults in the driving acceleration slip regulation system. The exclamation mark on the dashboard can appear in three different scenarios: 1. An exclamation mark inside a circled parenthesis: Indicates brake pad wear or insufficient brake fluid. The solution is to release the parking brake and check if the brake fluid is low. If the light remains on, visit a repair shop to replace the brake pads. 2. An exclamation mark inside a triangle: Indicates an external light malfunction. The solution is to check if any lights are faulty. If no issues are found but the light persists, it is recommended to visit a repair shop for maintenance. 3. An exclamation mark inside yellow parentheses: Indicates a tire pressure issue. The solution is to inspect the tires for punctures or leaks. If none are found, drive at low speed to a car repair shop, auto beauty shop, or roadside car wash, as these places usually have air pumps to inflate the tires. After inflating, observe the dashboard. If the warning light remains on, locate the settings in the vehicle's central console and perform another tire pressure check. The light will turn off once the pressure is normal.

19

4

Share

Why does the car fail to accelerate when the air conditioning is turned on?

The reason why the car fails to accelerate when the air conditioning is turned on may be due to the oil pump overheating internally or in its circuit, resulting in poor working conditions, short circuits, or burnout, leading to insufficient or stopped fuel supply. It could also be caused by internal engine faults, improper internal maintenance, premature or abnormal wear, or issues with cylinder pressure and other potential faults or hazards. Relevant information about oil pressure is as follows: 1. Introduction: The residual pressure that lifts oil and gas from the bottom of the well to the wellhead through the oil pipe is called tubing pressure, or oil pressure for short. It is measured by the tubing pressure gauge, and its value is the flowing pressure minus the pressure of the oil and gas mixed liquid column in the well, friction resistance, and slippage loss. 2. Influencing factors: The oil pressure depends on the level of the flowing pressure, which in turn is related to the reservoir pressure. Therefore, the level of oil pressure reflects the energy level of the oil well.

19

4

Share

Does Charging a Phone in a Car Damage the Battery?

Frequently charging your phone in the car will not harm the vehicle. The charging current for a phone is not very high. Even with a high-current 5A fast car charger, the power typically does not exceed 50W, usually around 45W. At 50W, with the car running, the battery voltage is 14V, and the current is approximately 3.57A. Here is some relevant information about car batteries: 1. Introduction: A car battery, also known as a storage battery, is a type of battery that works by converting chemical energy into electrical energy. Typically, the term "battery" refers to a lead-acid battery, which is mainly composed of lead and its oxides, with a sulfuric acid solution as the electrolyte. 2. Working Principle: It uses lead plates filled with sponge-like lead as the negative electrode, lead plates filled with lead dioxide as the positive electrode, and a 22–28% dilute sulfuric acid solution as the electrolyte. During charging, electrical energy is converted into chemical energy, and during discharge, chemical energy is converted back into electrical energy.

19

0

Share

What is the purpose of a car's three-way catalytic converter?

Automobile three-way catalytic converter is the most important external purification device installed in the automobile exhaust system, which can convert harmful gases such as CO, HC and NOx emitted by automobile exhaust into harmless carbon dioxide, water and nitrogen through oxidation and reduction. The relevant information about the three-way catalytic converter is as follows: 1. Introduction: The three-way catalytic converter is the most important external purification device installed in the automobile exhaust system, which can convert harmful gases such as CO, HC and NOx emitted by automobile exhaust into harmless carbon dioxide, water and nitrogen through oxidation and reduction. 2. Working principle: When high-temperature automobile exhaust passes through the purification device, the purifying agent in the three-way catalytic converter will enhance the activity of CO, HC and NOx, promoting certain oxidation-reduction chemical reactions.

16

5

Share

What are the body dimensions of the 2019 Jetta?

How Long Can a 7-Speed Dry Dual Clutch Transmission Last?

Should the clutch be fully depressed for hill-start parking?

What Causes the Triangle Warning Light to Illuminate in a Car?

Why does the car fail to accelerate when the air conditioning is turned on?

Does Charging a Phone in a Car Damage the Battery?

What is the purpose of a car's three-way catalytic converter?

What is the Principle of the Car Key Induction Coil?

What procedures are required for a car charging station?

Can a Car Battery Still Be Used After Being Soaked in Water?

Is the Vehicle Registration Certificate Required for Annual Vehicle Inspection?