What are feeder roads and main roads?

1 Answers
VanLaura
07/29/25 11:26pm
Feeder roads are the lanes on either side of the main road, serving as auxiliary lanes to facilitate traffic flow. Main roads are the primary lanes for normal traffic. Below is a related introduction to the differences between main roads and feeder roads: 1. Introduction one: Main roads are exclusively for motor vehicles, while feeder roads accommodate a mix of motor vehicles, non-motorized vehicles, and pedestrians. 2. Introduction two: The speed limit on feeder roads must not exceed 60 km/h, whereas main roads allow speeds of 80 km/h or more. 3. Introduction three: Feeder roads are not just for pedestrians or non-motorized vehicles; they connect to numerous intersections. 4. Introduction four: Vehicles on main roads have the right of way, while those on feeder roads must yield.
Was this review help?
7
5
Share
More Forum Discussions

How Many Kilometers Should Car Clutch Plates Be Replaced?

Clutch three-piece set is generally recommended to be replaced at 80,000 kilometers. The clutch is one of the important components of a car's transmission. The service life of a normal car clutch can exceed 100,000 kilometers, and the normal service life of a manual clutch car has a lot to do with usual habits. In fact, the lifespan of the clutch disc is similar to that of brake pads, mainly depending on normal operation, road conditions, and load. Here are the signs for clutch replacement: 1. Extended clutch engagement point travel: After the clutch engagement point travel is extended, you should quickly go to a repair shop for maintenance and replacement. Otherwise, the pressure plate will wear out, and the repair cost will become increasingly higher. 2. Weak car power: When starting or climbing, the car obviously feels less powerful than before. If there is no problem with the engine, then the clutch plate may be severely worn.
7
0
Share

Can the color of a motor vehicle be changed?

Motor vehicles can apply for a change in body color. According to Article 6 of the "Road Traffic Safety Law," the following documents need to be submitted: the "Motor Vehicle Change Registration Application Form," original and photocopies of the identity certificates of the motor vehicle owner and agent, the original motor vehicle registration certificate, the original motor vehicle driving license, and fines must be paid before changing the vehicle color. According to Article 6 of Chapter 2 of the "Road Traffic Safety Law," if the color change area of a motor vehicle does not exceed 30%, there is no need to go through the change registration process. Conversely, if it exceeds 30%, it must be filed and recorded, and registration must be completed within 10 days after the vehicle color is changed. Precautions for changing the color of a vehicle wrap: Before preparing to change the color of a motor vehicle wrap, it is necessary to consult the vehicle management office where the vehicle is registered to determine whether the region allows motor vehicles to change color using wraps. If the region does not support this method, the change cannot be filed after the color is changed, and the wrap must be completely removed to restore the vehicle's original color. Additionally, according to Article 10 of the "Motor Vehicle Registration Regulations," vehicle owners are no longer required to apply to the vehicle management office in advance. They can first change the vehicle color, install body kits, replace the engine, etc., and then apply to the vehicle management office for change registration. According to Article 10, if a registered motor vehicle falls under any of the following circumstances, the owner must apply to the vehicle management office at the place of registration for change registration: Changing the body color. Replacing the engine. Replacing the body or frame. Replacing the entire vehicle due to quality issues. Changing the use nature, such as converting a commercial motor vehicle to a non-commercial one or vice versa. The motor vehicle owner's residence moves out of or into the jurisdiction of the vehicle management office. Furthermore, according to Article 15 of the "Road Traffic Safety Law of the People's Republic of China": Police cars, fire trucks, ambulances, and engineering rescue vehicles must be painted with emblem patterns and equipped with alarms and signal lights as required. Other motor vehicles are not allowed to paint, install, or use emblem patterns, alarms, or signal lights that are exclusive to the aforementioned vehicles or similar to them.
10
1
Share

Symptoms and Judgment Methods of Damaged Car Bearings

When a car wheel bearing is damaged, the car will experience wheel wobbling, increased vehicle shaking, abnormal noises, and poor rolling, leading to a decrease in power. Here are the methods to determine if a car wheel bearing is damaged: 1. Listen for sounds: Observe whether the noise comes from the engine. If the noise does not change when coasting in neutral, it may indicate a problem with the wheel bearing. 2. Check the temperature: When the brake shoe and pad gaps are normal, there is a difference in temperature between the front and rear wheels, with the front wheels being slightly higher. 3. Inspect the wheels: Manually rotate each of the four wheels quickly; the problematic axle will produce a noise.
9
2
Share

Under what circumstances should the car anti-skid button be used?

Since the car anti-skid button is turned on by default, it means that the car anti-skid button should be kept on during normal driving. The main function of the car anti-skid button is to control the longitudinal and lateral stability of the vehicle to ensure that the vehicle drives according to the driver's intention. Additional information: The following situations are not recommended to turn on the car anti-skid button: 1. When the vehicle is stuck in mud or off-road: When the vehicle is stuck or in other off-road situations, appropriate wheel slip is needed to help escape and climb. 2. When encountering wheel slip during uphill driving in rain or snow: Because when starting on snowy or waterlogged roads, especially when going uphill, the wheels are prone to slip. At this time, the computer will identify the wheel slip and limit the engine output.
4
2
Share

What is the function of a fuel filter?

The main function of a fuel filter is to remove impurities from gasoline. The fuel filter can filter out harmful particles and moisture in the engine fuel system to protect components such as the fuel pump, injectors, cylinder liners, and piston rings, reducing wear and preventing blockages. It removes solid contaminants like iron oxide and dust contained in the fuel, preventing blockages in the fuel system (especially the injectors). This reduces mechanical wear, ensures stable engine operation, and improves reliability. Here are some points to note when replacing a fuel filter: 1. Beware of fuel leaks: After replacing the fuel filter or oil filter, pay attention to the sealing of the connections to prevent fuel leaks. 2. No smoking or open flames: Smoking and the use of open flames are strictly prohibited when replacing the fuel filter or performing maintenance on the fuel system.
2
3
Share

Is an operating permit required to drive for Didi?

Driving for Didi requires an operating permit. According to the "Interim Measures for the Management of Online Car-hailing Services," individuals engaged in the online car-hailing industry must apply for the "Online Car-hailing Transport Permit" and the "Online Car-hailing Driver's License" from the local taxi administration department. Otherwise, using a private car for Didi services is considered illegal operation. If caught, illegal income will be confiscated, and corresponding fines will be imposed. Additional information: Below are some considerations for driving for Didi: 1. Vehicle selection: Didi has requirements for vehicle models, so it's necessary to choose a suitable vehicle before operating. 2. Confirm the pickup location by phone when accepting an order: Incorrect locations can increase fuel consumption and waste time.
11
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.