···
Log in / Register

Was Turbo Technology Invented by Japan?

1 Answers
ConnorLee
08/26/25 3:54am
Turbocharging technology was not invented by Japan; it was developed by some European engineers. This technology was initially applied to aircraft engines. Due to thin air at high altitudes, aircraft engines often suffer from insufficient air intake, so engineers introduced turbocharging technology to address this issue. Principle of Turbocharging: The principle of turbocharging is quite simple. A turbocharger consists of two parts: a compressor turbine and an exhaust turbine. The exhaust turbine is connected to the exhaust manifold. When the engine reaches a certain speed, the exhaust gases have enough energy to spin the exhaust turbine, which in turn rotates the compressor turbine. As the compressor turbine spins, it compresses air and forces it into the cylinders, thereby increasing the amount of air entering the engine. Function of Turbo Technology: Turbocharged engines can increase the amount of air entering the engine without increasing displacement, thereby enhancing engine power. Most cars today utilize turbocharging technology, and small-displacement turbocharged engines are commonly found in many vehicles. The power delivery characteristics of turbocharged engines make them particularly suitable for stop-and-go urban driving conditions.
Was this review help?
13
2
Share
More Forum Discussions

What does the automatic start-stop failure of Volkswagen Sagitar mean?

Volkswagen Sagitar automatic start-stop failure causes and solutions are as follows: Causes of Volkswagen Sagitar automatic start-stop failure: Most automatic start-stop failures occur when the control unit detects that the vehicle cannot start normally after stalling. There are many reasons, such as insufficient battery power (automatic start-stop vehicles have higher battery requirements), throttle failure, etc. Solutions for Volkswagen Sagitar automatic start-stop failure: Engage the starting gear. If neither the starter nor the engine can rotate, check according to the starting system fault; check the battery storage condition and pole connection. If the battery is normal, then check whether the starting line, fuse, and ignition switch are damaged and need to be replaced.
1
5
Share

Can you make a U-turn on a dashed yellow line?

Yellow dashed-solid lines allow vehicles on the dashed side to cross for U-turns or turns, while the solid side prohibits crossing. Violations captured by traffic cameras typically result in a 200 yuan fine and 3 penalty points. Below is relevant information: 1. Double solid yellow lines: U-turns, crossing, or high-speed turns are strictly prohibited. Violators face a 200 yuan fine and 3 penalty points. 2. Double dashed yellow lines: On main roads, left turns are permitted when safe and without obstructing traffic, but U-turns remain prohibited. 3. Solid-dashed double yellow lines: Vehicles on the dashed side may make U-turns or cross when safe and unobstructive, while vehicles on the solid side must not cross or linger on the lines.
14
3
Share

What does gdit mean?

gdit stands for Turbocharged Direct Injection Engine. Here are the specific details about the Turbocharged Direct Injection Engine: 1. Technology: In a Turbocharged Direct Injection Engine, fuel is directly injected into the cylinder via a high-pressure injector. Due to the concave bowl-shaped design of the piston top, the fuel forms a spiral-like mixture within the cylinder. 2. Advantages: To address the inherent shortcomings of SDI, a turbocharger is installed on the Turbocharged Direct Injection Engine, significantly increasing the intake pressure. The compression ratio generally exceeds 10, allowing the engine to achieve high torque at very low speeds. Moreover, due to more complete combustion, the content of harmful particles in emissions is greatly reduced.
15
2
Share

What Preparations Are Needed Before Learning to Drive?

Here are some preparations needed before learning to drive: 1. Download the "Motor Vehicle Driver Physical Condition Certificate" form from the local vehicle management office website and undergo a physical examination at a county-level medical institution or a military medical institution at or above the regimental level. 2. After passing the physical examination, you can register for the driving test at a driving school. When registering, you also need to prepare four recent one-inch bareheaded photos with a white background and corresponding electronic versions for facial image collection. 3. For non-local residents, a temporary residence certificate must be obtained from the local police station in the temporary residence area before applying for a driver's license. Additional information: The physical conditions for applying for a driver's license include corresponding regulations on age, height, vision, color discrimination ability, hearing, upper limbs, lower limbs, torso, and neck.
19
3
Share

Where is the power steering pump located?

The power steering pump is located near the pulley driven by the engine accessory belt, while the electric power steering is located below the steering wheel. Power steering systems can be roughly divided into three categories: 1. Mechanical hydraulic power steering system. 2. Electro-hydraulic power steering system. 3. Electric power steering system. Introduction to power steering systems: 1. The mechanical hydraulic power steering system generally consists of components such as a hydraulic pump, oil pipes, pressure and flow control valve body, V-type drive belt, and oil reservoir. 2. The main components of the electro-hydraulic power steering system include the oil reservoir, power steering control unit, electric pump, steering gear, and power steering sensor, among which the power steering control unit and electric pump form an integrated structure.
5
4
Share

Where is the turbocharger installed?

Normally, the turbocharger of a car is located near the exhaust manifold. You can check by opening the engine hood. Some cars have the exhaust manifold at the front, while others have it at the rear. Here is more information about turbochargers: 1. A turbocharger consists of two parts: one is the intake turbine, and the other is the exhaust turbine. The exhaust turbine is connected to the exhaust manifold. When the engine reaches a certain speed, the exhaust has enough energy to drive the exhaust turbine to rotate. The exhaust turbine is connected to the intake turbine via the same shaft. Once the exhaust turbine starts rotating, the intake turbine also begins to rotate, compressing air and blowing it into the cylinders. 2. Turbocharging technology can increase the amount of air entering the engine without increasing the engine displacement, thereby enhancing the engine's power.
11
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.