To what extent must sidewall cracks on tires be replaced?

1 Answers
WilliamLee
08/29/25 8:25am
Here are the situations where sidewall cracks on tires require replacement: Cracks less than 6mm in length: If cracks appear on the tire, the depth of the cracks should be assessed. Cracks less than 6mm in length can be repaired at a maintenance shop. Otherwise, the tire needs to be replaced because damage to internal materials cannot be repaired. If the repaired tire is on the front wheel, it is recommended to swap it with an unrepaired rear wheel to minimize the risk of a blowout. In remote areas where maintenance shops are not nearby, if cracks appear on the tire, it is safest to replace it with a spare tire. Numerous small cracks: If the tire shows signs of aging, with numerous small cracks at the base of the tread grooves or on the sidewall that are about to damage the tire body, the tire should be replaced immediately, regardless of how long it has been used or how much it has worn.
Was this review help?
7
2
Share
More Forum Discussions

What are the differences between the 2021 Nissan X-Trail and the 2020 Nissan X-Trail?

The differences between the 2021 Nissan X-Trail and the 2020 Nissan X-Trail lie in their power outputs: the 2021 model has a maximum power of 111 kW and a maximum torque of 194 Nm, while the 2020 model has a maximum power of 113 kW and a maximum torque of 204 Nm. Both the 2021 and 2020 Nissan X-Trail models share the same body dimensions: length 4675 mm, width 1820 mm, height 1722 mm, wheelbase 2706 mm, minimum ground clearance 208 mm, fuel tank capacity 65 liters, and luggage compartment capacity 700 liters. Both models are equipped with a 2.0L naturally aspirated engine.
4
0
Share

Should First Gear Be Used for U-turns in Subject Three?

In the Subject Three driving test, there are no specific requirements for gear selection. Generally, first or second gear can be used for U-turns, but first gear is the most dangerous. Below are some considerations for the Subject Three test: 1. Oncoming traffic and turning at intersections: "Oncoming traffic" refers to two vehicles crossing paths. During driving, maintain a steady speed, avoid excessive speed (preferably not exceeding 30 km/h), and gently tap the brakes when vehicles cross paths to prevent gear disengagement. When turning at intersections, continue to control speed, signal in time, and downshift. 2. Lane changing and U-turns: Lane changing shares the same requirements as turning. Ensure to signal and turn the steering wheel after 3 seconds, gradually aligning the vehicle. During U-turns, remain vigilant with signaling, gently tapping brakes, and other necessary actions.
4
1
Share

What are the advantages and disadvantages of an automatic transmission in cars?

Automatic transmissions have the following pros and cons:1. Advantages: Due to the use of hydraulic transmission, gear shifts are smooth, maintaining driving stability; simply place the gear lever in the D position, and you can freely press the accelerator or brake, eliminating the hassle of manual shifting, making operation convenient; the failure rate is relatively low.2. Disadvantages: The engine braking effect is poor. Automatic transmissions use a hydraulic torque converter to replace the clutch, resulting in less force transmission from the wheels to the engine. Therefore, the engine braking effect is not significant when in drive mode, and the braking effect only becomes apparent when using higher or lower gears; fuel consumption is higher. Since the shifting process relies on hydraulics, there is power loss during transmission, making it more fuel-consuming compared to the mechanical transmission of manual transmissions; automatic transmissions are more expensive due to their precision manufacturing.
17
2
Share

What is the normal engine speed for an automatic transmission?

Automatic transmission engine speed is normally between 1800 to 2000 RPM. RPM refers to the number of revolutions per minute of the engine crankshaft. The engine speed directly affects the number of power strokes per unit time or the effective power output of the engine. An automatic transmission eliminates the need for the driver to manually shift gears, as the vehicle automatically selects the appropriate gear based on driving speed and traffic conditions. The method for starting an automatic transmission car is: 1. Sit in the driver's seat and press the start button to turn on the ACC light; 2. Press the start button again for the vehicle to perform a self-check; 3. Depress the brake pedal and press the start button to ignite and start the engine; 4. Depress the foot brake, shift to D (Drive) gear, and release the handbrake.
1
3
Share

Can a Locked Vehicle Be Driven Normally on the Road?

A locked vehicle cannot be driven normally on the road. Driving a locked vehicle will not only result in penalties but also lead to the vehicle being confiscated. Locked and impounded vehicles cannot be used normally; only vehicles under seizure status or normal status can be used normally and have insurance purchased legally. Additional Information: When a vehicle's records are locked, it means the vehicle's records at the Department of Motor Vehicles (DMV) are frozen due to certain reasons. During the locked period, the vehicle cannot legally engage in normal activities and must be unlocked legally before any actions can be taken. Vehicle records include: Original copy of the "Motor Vehicle Registration, Transfer, Cancellation/Import Application Form"; Copy of the vehicle owner's identity proof; Original or copy of the vehicle's origin proof; Original copy of the vehicle purchase tax proof or tax exemption voucher; Original copy of the third part of the compulsory traffic accident liability insurance certificate; Original copy of the domestic or imported vehicle's certificate of conformity; Vehicle inspection form.
20
2
Share

What is the fuel tank capacity of the BMW 525 in liters?

The fuel tank capacity of the BMW 525 is 68 liters, as officially announced by the manufacturer. The BMW 525 requires 95-octane fuel, with a fuel consumption of 6.5-7.2L per 100 kilometers. A full tank can cover a distance of 944-1046km. During daily driving, it is essential to monitor the remaining fuel level in the tank. This is typically observed through the fuel gauge inside the vehicle. Under normal circumstances, the fuel level will be accurately reflected on the gauge. The fuel gauge usually has 5 to 6 segments, and it is advisable to refuel when only 2 segments remain to avoid running out of fuel mid-journey. In actual refueling situations, the amount of fuel added may exceed the marked capacity. This is because the manufacturer's specified tank capacity is measured from the bottom of the tank to the safety limit. There is additional space from the safety limit to the tank opening, which is designed to accommodate fuel expansion due to temperature increases without causing overflow. If fuel is added up to the tank opening during refueling, the actual amount of fuel added may exceed the marked tank capacity.
1
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.