Solutions for Steering Gear Noise in Baojun 730

1 Answers
DeDominic
07/29/25 6:08pm
The main causes and solutions for steering gear noise in Baojun 730 are: 1. Internal damage: Insufficient oil pressure caused by wear of the power steering pump, solution is to replace the power steering pump. 2. Steering gear damage: Failure of power assistance due to steering gear wear, solution is to replace the steering gear. 3. Low tire pressure: Low front tire pressure, inflate to 2.5 kg. Below are some additional details: 1. Introduction: The automotive steering gear, also known as steering mechanism or steering box, is the most critical component in a vehicle's steering system. Its function is to amplify the force transmitted from the steering wheel to the steering linkage and alter the direction of force transmission. 2. Types: Common steering gear types include rack and pinion, worm and sector, and recirculating ball.
Was this review help?
16
4
Share
More Forum Discussions

How to Spray Windshield Washer Fluid on the Leiling Car?

To spray windshield washer fluid on the Leiling car, lift the wiper control lever toward the steering wheel side. The Leiling measures 4630 mm in length, 1775 mm in width, and 1480 mm in height. Safety features include: driver and front passenger airbags, front side airbags, front and rear head airbags, knee airbags, tire pressure monitoring, ABS anti-lock braking, brake force distribution, brake assist, lane departure warning system, and lane keep assist system. In terms of power, the gasoline version continues to use a 1.2T CVT powertrain combination, delivering a maximum power of 85 kW and peak torque of 185 Nm. The hybrid version is equipped with a 1.8L Atkinson-cycle engine and Toyota's THS II hybrid system, with the engine producing a maximum power of 72 kW and peak torque of 142 Nm, and the motor delivering a peak power of 53 kW and peak torque of 163 Nm, resulting in a combined system power of 90 kW. The suspension setup consists of a front MacPherson strut and a rear double-wishbone independent suspension combination.
15
2
Share

What Causes Unstable Idling in a Car?

Unstable idling in a car can be caused by: 1. Idle switch not closing; 2. Faulty idle control valve; 3. Air intake pipe leakage; 4. Incorrect valve timing; 5. Fuel injector dripping or clogging; 6. Exhaust system blockage; 7. EGR valve opening during idle conditions. The solutions for unstable idling are respectively: 1. Adjust, repair, or replace the throttle position sensor; 2. Clean or replace the idle control valve and use a dedicated decoder to perform a basic setting of the idle speed; 3. Locate the leakage, reseal or replace the relevant components; 4. Check the timing marks and readjust the valve timing according to standards; 5. Clean the fuel injectors, check the fuel injection quantity of each injector, and ensure there is no clogging or dripping; 6. Replace the three-way catalytic converter; 7. Remove carbon deposits from the EGR valve or replace the EGR valve.
18
0
Share

What to Do If a Beginner Driver Keeps Stalling When Starting the Car?

If a beginner driver keeps stalling when starting the car, they should first practice lifting the clutch pedal to find the engagement point, which is when the car is about to move (also known as the half-clutch state), and then hold it steady. Next, slowly release the clutch pedal, allowing the car to start smoothly. After that, practice coordinating the clutch and throttle. When lifting the clutch to the half-clutch state, hold it steady, and while slowly releasing the clutch, gently press the throttle to achieve a smooth start. If stopping on an uphill slope, make sure not to release the throttle with your right foot and maintain sufficient climbing power until reaching the chosen parking spot. When performing the stopping operation, both feet must coordinate well, and the entire sequence should be executed smoothly without delay. This means that as soon as the right foot releases the throttle, the left foot should quickly and accurately press the clutch pedal. When the car is about to stop, press the brake pedal to bring the car to a halt. Then, engage the handbrake firmly before releasing the foot brake.
15
1
Share

Will the 2019 CRV still experience oil dilution?

2019 CRV will not experience oil dilution. The 2019 Honda CRV is equipped with a 1.5T engine and a 2.0L hybrid engine. The 1.5T engine delivers a maximum horsepower of 190 HP and peak torque of 243 N·m, paired with either a 6MT transmission or a CVT transmission, meeting China's National VI emission standards. The 2.0L hybrid two-wheel-drive Jingchi version (National VI) adopts a hybrid front-wheel-drive ECVT continuously variable transmission, powered by an LFA11 model 2.0L 146 HP engine and 184 HP electric motor, with peak torque of 175 N·m.
19
1
Share

Should I Shift to P Gear Before or After Turning Off the Engine?

Both methods—turning off the engine before shifting to P gear or shifting to P gear before turning off the engine—are correct and will not cause any damage to the vehicle. Modern car transmissions are equipped with two sets of gears: one for driving and shifting, and the other for parking and locking. When parking, as long as the vehicle is stationary, the locking gears are not engaged, and the driving gears are inactive. The P (Park) gear works by using a mechanical device to lock the rotating parts of the car, preventing it from moving. For long-term parking, it is essential to firmly engage the handbrake and shift the gear to P.
7
5
Share

What Causes the Loud Noise from the BYD Qin's Air Conditioning Motor?

BYD Qin's air conditioning motor produces loud noise due to the following reasons: damaged compressor bearings; excessively loose compressor belt tension; refrigerant charge exceeding the standard, increasing the compressor's load; incorrect type of refrigerant added. Solutions for loud noise from the car air conditioning blower: If the noise is caused by damaged blower bearings, generally replacing the damaged parts will suffice. If the noise is due to deformed exhaust fan blades or a damaged exhaust fan motor, the exhaust fan needs to be replaced. If the noise is caused by excessive dirt inside the air conditioning system, cleaning the air conditioner is necessary. If the blower is damaged, it needs to be repaired. Car air conditioning maintenance methods: Comprehensive air conditioning inspection: When using the air conditioning for the first time in summer, inspect the air conditioning system first, such as checking the refrigerant and whether the air filter is too dirty through the reservoir, and whether there are foreign objects in the radiator. Pay attention to air conditioning cleaning: The air filter should be replaced regularly, especially in spring when there is more sand and dust, and willow catkins flying around, which can stick to the filter and breed bacteria, causing a musty smell in the air conditioning. Additionally, the condenser should be cleaned periodically, and the radiator should be removed for thorough cleaning.
17
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.