Should You Release the Throttle When Upshifting?

1 Answers
StRebecca
07/29/25 2:47pm
Whether to release the throttle when upshifting depends on two scenarios: 1. For manual transmission vehicles, you should release the throttle when upshifting; 2. For automatic transmission vehicles, there's no need to release the throttle. In automatic transmission vehicles, upshifting can occur in two ways: one is when the onboard computer automatically upshifts, which can be done without releasing the throttle, and the other is when using manual mode to upshift by shifting the gear lever to manual mode—pushing it upward to upshift and pulling it downward to downshift. The gears for automatic transmissions are as follows: P (Park) is the parking gear and also the starting gear; R (Reverse) is the reverse gear; N (Neutral) is the neutral gear; D (Drive) is the forward gear, also known as the driving gear; S (Sport) is the sport mode; and L (Low) is the low-speed gear.
Was this review help?
3
5
Share
More Forum Discussions

What does the ECON button in a car mean?

The ECON button in a car is the switch for the fuel-saving mode, which can be used to turn the fuel-saving mode on or off. Modern cars generally offer three driving modes to choose from: fuel-saving mode, comfort mode, and sport mode. In fuel-saving mode, the compressor is not turned off, but the control point for the compressor is raised, preventing it from running continuously. The start-stop point of the compressor is determined by the evaporation temperature. The working principle of ECON mainly involves analyzing various configurations that affect fuel consumption, such as transmission gear, engine speed, braking system, and transmission oil temperature, through multiple sensors. Then, the ECU calculates the amount of fuel to be supplied to the engine for operation, resulting in lower fuel consumption in ECON mode compared to normal driving mode.
20
2
Share

What is the method for adding refrigerant to a car?

Automobile air conditioning refrigerant charging method is to first evacuate the vacuum and observe the scale, ensure there is no vacuum rebound, then disconnect the manifold gauge tube from the vacuum pump, connect one tube to the low-pressure pipe charging port, and the other tube to the refrigerant cylinder. Below is relevant information about automobile air conditioning refrigerant: 1. Definition: Refrigerant, commonly known as Freon, is the working fluid used in refrigeration and air conditioning systems to transfer heat energy and produce cooling effects. 2. Classification: Refrigerants can be categorized by their working methods into primary refrigerants and secondary refrigerants. Based on material properties, they can be classified into natural refrigerants and synthetic refrigerants.
3
1
Share

What causes the right side to cross the line when reversing into the right parking space?

Crossing the right line when reversing into the right parking space is caused by turning the steering wheel (1.5 turns to the right) too early. Below are relevant details about reversing into a parking space: Park the vehicle in the designated area: After parking the vehicle in the designated area, shift into reverse gear to back up. At this point, observe the left rearview mirror. When you see the left line at the lower edge of the left rearview mirror, this is the optimal moment to turn the steering wheel fully to the right. Vehicle moving backward to the right: Observe the relationship between the car body and the parking space corner, as well as the driving path, through the right rearview mirror. If the door handle is outside the parking space corner while reversing, it indicates that continuing to back up will cause the line to be crossed. At this point, you can turn the steering wheel half a turn to the left. If half a turn is insufficient, continue turning left further, remembering to proceed slowly and avoid turning too much at once, until you ensure the right rear wheel can enter the parking space.
4
3
Share

What Causes Front Wheel Wobble in Motorcycles?

Motorcycle front wheel wobbling from side to side is due to damaged bearings inside the wheel. Worn-out bearings increase axial clearance, causing the wheel to sway. Vehicle maintenance methods are as follows: 1. Spark Plug Maintenance: Spark plugs ignite the air-fuel mixture. The maintenance interval for spark plugs is approximately 50,000 kilometers. They are crucial for engine combustion. Continuous engine operation wears down spark plug electrodes over time, reducing ignition energy and leading to symptoms like poor acceleration and misfires. 2. Cabin Air Filter Maintenance: The cabin air filter purifies incoming air. Replacement intervals are typically around 20,000 kilometers but may shorten in polluted environments like smog-heavy Beijing. It directly affects in-cabin air quality. 3. Fuel Filter Maintenance: Fuel filters (gasoline filters) clean fuel. They come in two types: inline and in-tank. Inline filters require replacement every ~30,000 km; in-tank filters every ~50,000 km. Substandard gasoline at some Chinese gas stations accelerates filter clogging, causing hard starts and sluggish acceleration.
5
1
Share

Where is the Roewe CVT transmission produced?

The Roewe CVT transmission is produced in Nanjing and is independently developed by SAIC. The CVT transmission in the Roewe i5 can simulate 8 gears, offering lower costs and better fuel efficiency. The Roewe i5 is equipped with two types of engines: a 1.5-liter naturally aspirated engine and a 1.5-liter turbocharged engine. Below are the details of these two engines: 1. 1.5-liter turbocharged engine: Maximum power is 124 kW, maximum torque is 250 Nm, maximum power speed is 5500 rpm, and maximum torque speed ranges from 1700 to 4300 rpm. This engine features direct fuel injection technology and uses an aluminum alloy cylinder head and block. It is paired with a 7-speed dual-clutch transmission. 2. 1.5-liter naturally aspirated engine: Maximum power is 88 kW, maximum torque is 150 Nm, maximum power speed is 6000 rpm, and maximum torque speed is 4500 rpm. This engine is equipped with DVVT technology and uses an aluminum alloy cylinder head and a cast iron cylinder block. It is paired with either a 5-speed manual transmission or a CVT transmission.
11
5
Share

How to Start the Atenza When the Key Fob Battery is Dead?

When the Atenza key fob battery is dead, press the button on the side of the remote key to eject the mechanical key, then use the mechanical key to open the car door. After entering the vehicle, place the remote key near the start button; the induction coil inside the key can communicate with the vehicle's computer to allow ignition and starting. Below is some relevant information about the Atenza: 1. Introduction: The Atenza is Mazda's new generation mid-to-high-end sports sedan flagship model, developed under the philosophy of "breaking conventions, starting from scratch." The Atenza continues the design of the imported Mazda ATENZA. 2. Configuration: As Mazda's new generation flagship model, one of the Atenza's standout features is the application of Mazda's SKYACTIV technology. Compared to traditional naturally aspirated engines, the Atenza's SKYACTIV engine boasts a high compression ratio of 13:1, improving fuel economy and torque by 15% each.
17
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.