Should You Press the Clutch or Start the Engine First in Subject Two?

1 Answers
OAxel
07/30/25 8:57am
You should start the engine first and then press the clutch. Below are the precautions for Subject Two: Control speed when reversing into the garage: Do not go too slow or let the car stop. Find your reference point and reverse slowly to avoid moving too fast and not having enough time to turn the steering wheel, which could result in crossing the line. Mock exam: The purpose of the mock exam is to familiarize the candidate with the exam environment and allow the instructor to point out areas where points are easily deducted. Therefore, the mock exam is absolutely essential. Being well-prepared is the best way to face the challenge. Ensure preparation work: When you get into the car for your exam, remember to adjust the seat and rearview mirror to the position you find most comfortable and convenient. Keep in mind that unfamiliarity with the rearview mirror and seat can directly affect your judgment during the exam.
Was this review help?
6
1
Share
More Forum Discussions

How to Tell if the Front Wheels Are Crossing the Line in an S-Curve?

When entering a curve, try to stay close to the right-side line because the first turn is to the left. Turn the steering wheel one full turn to the left and check the left rearview mirror. Clearly observe the distance between the rear of the car and the left-side line from the mirror. Adjust the steering to maintain a distance of about 30 centimeters. When reaching the junction of the curves, straighten the steering wheel and proceed straight. At this point, look at the front right corner of the car and ensure the body maintains a distance of about 30 centimeters from the right-side line as seen in the mirror.
9
1
Share

Should You Turn Off the Engine When It Overheats?

When the car engine overheats, you should turn it off and open the hood to allow the engine to cool down. Reasons for car engine overheating: 1. Lack of coolant; 2. Malfunction in the engine cooling system; 3. Incorrect position of the heater baffle; 4. Failure in the cooling circulation system; 5. Blockage or pipe rupture in the catalytic converter. An engine is a machine that converts other forms of energy into mechanical energy. Based on its working principle, engines are categorized into: 1. External combustion engines: Fuel burns outside the engine; 2. Internal combustion engines: Fuel burns inside the engine; 3. Gas turbines: Utilize high-pressure gas to rotate turbine blades for power output; 4. Jet engines: Engines that directly generate thrust by expelling high-speed gas from the nozzle.
8
0
Share

What type of oil should be used for the 2019 Sylphy?

The original factory oil specification for the 2019 Sylphy is 5W30. According to the official maintenance recommendations, SL or higher grade 5W30 oil should be used. The viscosity of the oil changes with temperature, so special attention should be paid to its performance under both low and high temperatures. For example, in 5W-30, the first number indicates low-temperature fluidity, with 5W representing the ability to withstand low temperatures down to -30°C. The smaller this number, the better the low-temperature fluidity, resulting in smoother cold starts for the car. The latter number represents the kinematic viscosity of the oil at 100°C. A higher value indicates better ability to maintain viscosity under high temperatures, which can also be understood as better lubrication performance under high-temperature conditions. The method for changing the oil in the 2019 Sylphy is as follows: Wait for the engine temperature to drop, allowing the oil to flow back into the oil pan. Use a wrench to loosen the oil drain plug and place an oil pan underneath to catch the old oil until it stops flowing. Start the engine and let it run for 30 seconds to allow the oil in the main oil passage to drain out. Use a special wrench to remove the oil filter. Apply oil to the seal of the new oil filter and tighten it clockwise by hand. Add the new oil through the oil filler cap on the engine valve cover, typically filling about three-quarters of the oil container. Start the engine and let it run for 5 minutes, checking for any leaks around the oil drain plug and oil filter. If leaks are found, repairs should be made. After stopping the engine, pull out the oil dipstick to ensure the oil level is within the standard range.
8
4
Share

How to Disable the Anti-Theft System on a Zotye T600?

Locate the vehicle's fuse box, typically found in the engine compartment or glove compartment. Follow the instructions to find the anti-theft system computer fuse and remove it to cut off the power supply. If there is no fuse, locate the car's anti-theft system computer under the steering wheel and directly unplug the power cord connector. The anti-theft system will deactivate once the power is disconnected. If neither of the above methods works, open the trunk and then close and lock the car doors. Within 10 seconds, insert and remove the key more than six times to clear the ID stored in the key. Manually lock the driver's side door using the switch, then use the remote control to lock the car once. This will allow you to input a new ID into the computer. After opening the driver's side door, the anti-theft system will be deactivated.
18
4
Share

What are the reasons for the Passat not moving in D gear?

Passat not moving in D gear may be due to the following reasons: Abnormal sensor signal: When the transmission shift valve position sensor signal of the vehicle is incorrect, it cannot detect which gear it is in. Abnormal shift valve: The reason why the Passat does not move in D gear may also be a problem with the shift valve, where the gear is not engaged properly and the oil passage cannot open. Abnormal solenoid valve and electronic module: Failure of the transmission solenoid valve and electronic module; insufficient transmission oil or internal oil pressure is too low. Abnormal car brakes: Brake lock-up, causing the wheels to not move forward, and there will be abnormal noise when accelerating; the handbrake is not released or not fully released.
7
1
Share

What is the battery model of the Trumpchi GS8?

The battery model for the Trumpchi GS8 is Yuasa LN3, with specifications of 12V-75Ah. For models with engine start-stop technology, the battery is Varta H6, with specifications of 12V-70Ah. Below is relevant information about car batteries: 1. The normal lifespan of a car battery ranges from 1 to 8 years, largely depending on the vehicle's condition. If the vehicle's alternator charges normally and there are no electrical leaks, the battery can typically last over 3 years. If you notice difficulty in charging, weak starter performance, or significantly dimmed headlights, the battery should be removed and charged for 12-24 hours. If the issue persists and the mileage exceeds 50,000 km without alternator issues, consider replacing the battery. 2. Car batteries are highly sensitive to cold temperatures, so regular inspection and maintenance are essential. Daily precautions include: (1) Avoid parking the car in open-air parking lots for extended periods. If long-term parking is necessary, remove the battery to prevent freezing damage. (2) In winter, car engines are harder to start. Each attempt should not exceed 5 seconds, with intervals of at least 15 seconds between attempts. If the car fails to start after multiple attempts, check other aspects like the electrical circuit, ignition coil, or fuel system. Avoid continuous starting attempts, as this can over-discharge and damage the battery. (3) Regularly charge the car battery. A battery left unused will gradually self-discharge and eventually become unusable. Therefore, start the car periodically to recharge the battery. (4) Clean the battery terminals periodically and apply specialized grease to protect the wiring harness. Regularly inspect the battery's accessories and connecting wires. (5) Avoid using car electronics when the engine is off. Using the battery alone without the alternator running can cause damage.
11
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.