Should You Continue Practicing Driving After Failing Subject 3?

1 Answers
IrisLee
07/30/25 12:57am
Generally, you should continue practicing driving after failing Subject 3. It's important to analyze the reasons for failure and then practice to improve your pass rate for Subject 3. Subject 3 Test Items: There are 16 test items in Subject 3, including preparation before starting, starting the vehicle, driving in a straight line, shifting gears, turning left at intersections, turning right at intersections, changing lanes, passing through intersections, passing school zones, crossing pedestrian crosswalks, meeting oncoming vehicles, overtaking, making U-turns, and using lights. However, the specific items may vary slightly depending on the region. Important Notes for Subject 3 Test: Before starting, check the seatbelt, press the clutch, shift into first gear, release the handbrake, honk the horn, and observe both sides. When pulling up the handbrake, do not immediately release the foot brake; wait for the voice notification before doing so. Remember to close the car door when exiting the vehicle.
Was this review help?
15
1
Share
More Forum Discussions

What Causes a Manual Transmission to Suddenly Lose Its Clutch?

In reality, it's not that the clutch is missing, but rather that an electronic mechanism has taken over the task of operating the clutch for the driver, known as an electronic clutch. An electronic clutch essentially removes the clutch pedal, requiring only gear shifting with the lever. The system then controls the clutch engagement based on the gear lever position, eliminating concerns about incomplete disengagement of engine components and making gear shifting simpler. To some extent, this is quite similar to an automatic transmission vehicle but offers more driving pleasure. Below are specific manifestations of clutch failures: 1. Clutch Slippage: When starting the car in a low gear, releasing the clutch pedal does not result in the car moving or makes starting difficult; during acceleration, the vehicle speed does not increase with the engine RPM, leading to a feeling of lack of power, and in severe cases, a burning smell or smoke may occur. 2. Incomplete Clutch Disengagement: Even with the clutch pedal fully depressed, the power between the clutch's driving and driven discs is not completely cut off, resulting in difficulty shifting gears, gear grinding, inability to stop, or the clutch overheating. 3. Clutch Chatter: The entire vehicle shakes during startup, especially when idling and gradually releasing the clutch pedal to start in a low gear, leading to continuous jerking.
5
1
Share

What Items Are Included in Basic Car Maintenance?

Basic maintenance refers to the replacement of maintenance parts and wear items such as engine oil, oil filter, air filter, fuel filter, brake fluid, coolant, power steering fluid, and spark plugs when the specified maintenance cycle or mileage is reached. The function of engine oil is to lubricate, cool, dampen shocks, and reduce wear in the engine. Changing the engine oil is the most fundamental car maintenance task. Engine oil is categorized into mineral oil, semi-synthetic oil, and fully synthetic oil. Mineral oil should be changed every 5,000 kilometers or 6 months; semi-synthetic oil typically requires replacement every 8,000-10,000 kilometers; while fully synthetic oil is generally changed every 10,000-12,000 kilometers. The three filters in a car refer to the oil filter, air filter, and cabin air filter. The oil filter is replaced every time the engine oil is changed, as its role is to filter out impurities from the oil. The air filter acts like a "mask" for the engine, filtering the air that enters it. The air filter should be replaced every year or 10,000 kilometers, depending on the driving environment. Similarly, the cabin air filter should be replaced every year or 10,000 kilometers, also adjustable based on the driving environment. Transmission fluid serves to lubricate the transmission and extend its service life. Transmission fluid is generally divided into manual transmission fluid and automatic transmission fluid. Manual transmission fluid is typically changed every 2 years or 60,000 kilometers, while automatic transmission fluid is usually replaced every 60,000-120,000 kilometers. Brake fluid is the fluid that needs maintenance in the braking system. Due to the structure of the car's braking system, brake fluid can absorb moisture over time, leading to reduced braking performance or brake failure. Therefore, it should be replaced promptly. Brake fluid is generally changed every 2 years or 40,000 kilometers.
17
2
Share

Will Using the Windshield Wiper in Rain During Subject Two Test Result in Point Deduction?

Using the windshield wiper in rain during the Subject Two test will not result in point deduction. Below is an extended introduction about Subject Two: 1. Alternative Name: Subject Two, also known as the small road test, is part of the motor vehicle driver's license examination and is the abbreviation for the field driving skills test. The test items for small cars C1 and C2 include five mandatory tests: reversing into a parking space, parallel parking, stopping and starting on a slope, turning at a right angle, and driving on a curved path. 2. Content: The test items for large vehicles A1, A2, A3, B1, and B2 include pole test, stopping and starting on a slope, parallel parking, crossing a single-plank bridge, driving on a curved path, turning at a right angle, passing through a width-limited gate, passing through continuous obstacles, driving on bumpy roads, making a U-turn on a narrow road, as well as simulated scenarios such as highways, continuous sharp turns on mountain roads, tunnels, rainy and foggy weather, slippery roads, and emergency handling.
20
1
Share

What are the differences between the Accord and the Inspire?

The main differences between the Accord and the Inspire are as follows: 1. Exterior: The front fascia mainly differs in the grille and the lower bumper design. Although the headlights of both cars have minimal differences, they convey two completely different expressions. The Accord's front fascia resembles a cool and aloof expression, while the Inspire appears to be glaring fiercely straight ahead. 2. Body dimensions: Accord: Length 4893mm, width 1862mm, height 1449mm, wheelbase 2830mm. Inspire: Length 4910mm, width 1862mm, height 1450mm, wheelbase 2830mm.
7
1
Share

What are the reasons for no sound after connecting a phone to a car via Bluetooth?

The reasons why no sound is played after connecting a car and a phone via Bluetooth are as follows: 1. Phone issue: The connected phone may have a problem, requiring a restart or factory reset of the phone. 2. System issue: The car's infotainment system may have a problem, requiring a restart or factory reset of the system. Below is an introduction to in-car Bluetooth: 1. Working principle: The in-car Bluetooth player can connect to the car's Bluetooth system, receive Bluetooth signals from the phone, and convert them into FM signals for sound playback. 2. Function: The function of in-car Bluetooth is to automatically recognize mobile phones, enabling connection without cables or phone mounts; the driver can control the phone without touching it, even keeping both hands on the steering wheel, and use voice commands to answer or make calls.
5
3
Share

Should You Shift Gears or Release the Handbrake First When Starting an Automatic Transmission Car?

When starting an automatic transmission car, shift gears first and then release the handbrake. This is primarily for safety considerations. In practice, releasing the handbrake before shifting gears has no impact on starting the vehicle; the car will still start normally. The recommended sequence is to ensure the vehicle does not move unintentionally and to avoid unnecessary complications. Generally, vehicles have five gears: P (Park), R (Reverse), N (Neutral), D (Drive), and S (Sport). Below are the relevant details: 1. P (Parking) – Parking/Starting Gear: Used when the vehicle is parked and not in use. In this position, the wheels are mechanically locked to prevent rolling. The vehicle must be completely stopped before engaging P gear to avoid damaging the automatic transmission's mechanical components. 2. R (Reverse) – Reverse Gear: Used for reversing. Never force the gear into "R" before the vehicle has come to a complete stop, as this can severely damage the transmission. 3. N (Neutral) – Neutral Gear: Used for temporary stops (e.g., at a red light). This gear disengages the transmission, but the brake pedal must be pressed to prevent the vehicle from rolling on a slope. 4. D (Drive) – Forward Gear: Used for normal driving on roads. 5. S (Sport) – Sport Mode: In this mode, gears can be freely switched, but the shift timing is delayed to maintain higher engine RPMs for increased power. However, this mode increases fuel consumption.
10
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.