Should You Brake When Turning?
3 Answers
You should not brake when turning, as it can easily cause the car to lose control. Below is an introduction to drifting: 1. Introduction: Drifting is a driving technique, also known as "tail sliding." The driver intentionally causes the car to slide sideways by oversteering. This is usually compared to grip turning. Drifting is mainly used in performances or racing events with significant changes in road conditions. Due to the friction characteristics of the road surface, drifting is frequently applied in off-road rally races, while other types of racing rarely use drifting techniques for turning. This is because drifting on ordinary asphalt roads results in significant speed loss and increased tire wear. Unless under special circumstances, drivers do not frequently use this technique during competitions. 2. Methods: (1) Pull the handbrake while driving straight and then steer. (2) Pull the handbrake while turning. (3) Slam the brakes while driving straight and then steer. (4) Slam the brakes while turning. (5) For rear-wheel-drive cars with sufficient power, slam the accelerator and steer when the speed is not too high.
Bro, you've hit the nail on the head with this question! With nearly 20 years of driving experience, whether to brake when turning really depends on the situation. For small turns in urban areas where the speed is already low, just easing off the throttle and steering slightly is enough—unnecessary braking can cause the car to nod and wobble. However, for sharp turns like highway ramps, you must reduce speed before entering the curve. If you don't brake, you're just waiting to be thrown off! Especially on rainy days when the road is slippery, it's best to gently brake dozens of meters in advance to control your speed. Also, manual transmission cars require coordination with the clutch, while abrupt braking in automatics can cause the transmission to jerk. Remember these three words: early, gentle, and slowing down is better than forcing a turn!
Last time I was teaching students for the License Test Part 3, I covered this exact topic. Slowing down before a turn is an ironclad rule, but the key is knowing when to brake. Remember the mantra: Spot the turn - Ease off the gas - Apply brake - Slow entry - Smooth exit. Take a 90-degree turn for example: you should release the accelerator about 30 meters before the turn, then gently tap the brakes around 15 meters out to reduce speed below 30 km/h before gradually steering. Never brake suddenly mid-turn - this is the most common mistake learners make, often resulting in backseat passengers' heads thumping against the windows. Crucial point: Complete all braking in the straight section before the turn - braking while turning only increases the risk of skidding. Beginners must develop the habit of glancing at the speedometer before entering any turn.
