···
Log in / Register

Should the Turn Signal Be Reactivated If It Goes Out During Parallel Parking in Subject Three?

4 Answers
OAlyssa
09/07/25 4:17am

It is mandatory to reactivate the turn signal if it goes out during parallel parking in Subject Three. The right turn signal must remain on until the vehicle comes to a complete stop; it should only be turned off after parking. During the Subject Three examination, after identifying a suitable parking spot and before initiating the parking maneuver, the right turn signal must be activated. Failure to do so will result in point deductions. Below are some tips for the Subject Three examination: Follow voice prompts: Listen carefully to the voice instructions during the Subject Three test and act accordingly. It is crucial not to perform any actions before the voice prompt has finished; wait until the instruction is complete before proceeding to the next step. Pay attention to special zones: In many regions, voice prompts no longer remind candidates of special zones such as school areas, bus stops, and pedestrian crossings. However, examinees must perform corresponding deceleration or yielding actions based on roadside signs and road markings. For school zones, apply the brakes within 10 meters of the sign, maintaining a speed below 30km/h. For bus stops, apply the brakes within 10 meters of the sign, also keeping the speed below 30km/h. For pedestrian crossings, decelerate by applying the brakes within 30 meters before the crossing, and come to a complete stop if pedestrians are crossing.

Was this review help?
3
3
Share
DeFrank
09/19/25 3:41am

I just passed the driving test's Subject 3, and during the roadside parking, if the turn signal goes off, you must immediately reactivate it. In the test, the turn signal is a crucial indicator showing your intention to park. If it goes off, the examiner may assume you failed to operate it correctly, resulting in major point deductions or even failure. During practice, my instructor repeatedly emphasized this detail. He explained that the turn signal might turn off automatically when the steering wheel returns to the center position, but before the front wheels are fully aligned during the parking process, you should manually reactivate it to ensure it stays on, demonstrating control. If you don’t reactivate it, the examiner might suspect you’re not focused or unaware of the rules—I once lost points in a mock test for this very reason. More importantly, in real-world driving, failing to reactivate a turn signal can confuse drivers behind you, significantly increasing the risk of a rear-end collision. So whether during the test or in daily driving, make it a habit to manually reactivate the turn signal immediately if it goes off—don’t hesitate.

Was this review help?
15
4
Share
Expand All
Lulu
11/02/25 4:02am

During the driving test, you must reactivate the turn signal if it goes off. Before my test, I read many guides and found that the turn signal needs to remain on throughout the entire parallel parking phase. If the light goes off, it counts as failing to maintain proper signaling operation, and the deduction criteria are clear. The instructor mentioned that manually reactivating the signal if it goes off mid-operation is a basic requirement—otherwise, the examiner will directly judge your driving skills as unstable. In real driving, a turn signal going off could be due to an electrical issue or excessive steering input, but during the test, don’t try to cut corners. Be proactive and manually reactivate the signal to demonstrate your safety awareness. A friend of mine failed the test because of this small mistake, so remember to practice simulating such unexpected scenarios during training. Developing good habits isn’t just about passing the test—it also helps avoid many misunderstandings when driving in the future.

Was this review help?
19
2
Share
Expand All
LeNathan
12/16/25 4:06am

The turn signal must be replenished if it goes out. During the parking test in Subject 3, manually turning off the signal after it extinguishes is normal because turn signals are often designed to turn off automatically, especially when the steering wheel is straightened. If you don't replenish the signal, the examiner may consider your signal ineffective. The test rules are strict, and failing to replenish a signal that has gone out is considered a major mistake, resulting in significant point deductions. From a driving safety perspective, replenishing the signal ensures that following vehicles clearly understand your intentions, avoiding accidents. Remember not to skip this step during the test.

Was this review help?
14
1
Share
Expand All
More Forum Discussions

How to Use Rearview Mirrors?

Rearview mirrors should be adjusted to view the left and right positions of the center rearview mirror. Below are some instructions on how to use rearview mirrors: 1. Center rearview mirror: Adjust the left and right positions of the center rearview mirror so that the left edge of the mirror just cuts off your right ear in the reflection, and position the distant horizon in the center of the mirror. 2. Viewing angles: For the left side mirror, position the distant horizon in the center when adjusting the lower part, and adjust the left and right positions so that the car body occupies 1/4 of the mirror's area. For the right side mirror, leave a larger ground area, about 2/3 of the mirror's area, when adjusting the upper and lower positions. As for the left and right positions, similarly adjust so that the car body occupies 1/4 of the mirror's area.
5
1
Share

What to Do When There Is Green Powder on the Negative Terminal of a Car Battery?

Green powder on the negative terminal of a car battery occurs because the negative terminal gradually changes from pure lead to lead oxide during operation, resulting in the formation of green powder. Below are the relevant explanations: 1. Principle of Formation: When different metals come into contact, electrochemical reactions occur due to the diffusion of electrons, which is a normal chemical phenomenon. To prevent corrosion of the battery terminals, both the positive and negative terminals and the connectors are made of pure lead to minimize corrosion. Due to electron transfer during the battery's charging and discharging processes, over time, the negative terminal changes from pure lead to lead oxide, leading to the appearance of blue-green powder. 2. Solution: Remove the terminal, spray an alkaline cleaning agent on the lead terminal and wire connector, and wipe them clean. Use a wrench to tighten the wire connector onto the terminal. To avoid sparks, ensure all vehicle electronics and ignition are turned off before removing the battery terminals, and always remove the negative terminal first, followed by the positive terminal. When reinstalling the terminals, attach the positive terminal first, then the negative terminal.
17
0
Share

Should Cars Be Waxed?

Yes, cars should be waxed. Here are some key points about car waxing: 1. Benefits: Proper waxing significantly enhances the protection level of the car's paint surface. It not only makes the paint less susceptible to damage and slows down the aging process, but also helps to some extent in preventing the paint from getting dirty. 2. Precautions: Incorrect waxing frequency or methods can cause some irreversible damage to the car's paint. Generally, new cars come with a layer of protective wax on their paint when they leave the factory. Waxing too early may remove this original protective wax from the new car's surface.
10
2
Share

How Long Does a Turbocharger Generally Last?

The lifespan of a turbocharger can generally last around 250,000 kilometers. For example, the design lifespan of the Citroen 1.6T is approximately 10 years or 240,000 kilometers, while the General Motors 1.4T has a design lifespan of about 250,000 kilometers. The lifespan of both the turbocharger and the engine is significantly influenced by maintenance, with the turbocharger being particularly affected. Here is some related information: 1. Turbocharger: A turbocharger consists of two parts: a compression turbine and an exhaust turbine. The working principle of a turbocharged engine is quite simple. When the engine reaches a certain speed, the exhaust gases have enough energy to spin the exhaust turbine, which in turn spins the compression turbine. This allows the compression turbine to compress air and blow it into the cylinders. 2. Precautions: After driving a car with a turbocharged engine at high speeds or on a long-distance trip, it is advisable not to turn off the engine immediately. Instead, let the engine idle for a few minutes to help cool down the turbocharger.
4
3
Share

Brief Description of the Causes of Drive Axle Oil Leakage

Drive axle oil leakage is caused by loosening or damage. Below are some of the fault causes: 1. Loosening: Drive axle loosening may be due to loose oil filler or drain plugs; worn or hardened oil seals, oil seals installed in reverse, misalignment between the oil seal and shaft neck, or grooves worn into the shaft neck. Additionally, the drive axle must withstand vertical forces, longitudinal and lateral forces acting between the road surface and the frame or body, as well as braking torque and reaction forces. 2. Damage: Drive axle damage may be caused by damaged fastening screws; blocked ventilation holes; casting defects or cracks in the axle housing; excessive gear oil leading to increased internal pressure during operation, causing gear oil to seep out, etc.
9
5
Share

Where is the USB port in the Honda Avancier?

The USB port in the Honda Avancier is located on the side or rear of the center control panel. Below is some relevant information about the Avancier: 1. Exterior: The Avancier is a new mid-size luxury SUV launched by GAC Honda. With its design concept that transcends the times, the Avancier's exterior showcases a majestic and powerful style, combining strength and beauty. Features like the wide front grille, eagle-wing LED headlights, and bold body lines highlight its uncompromising sharpness. 2. Interior: The interior is equipped with a symmetrical design dashboard wrapped in soft materials and wood grain decorations. A large adjustable floating LCD screen in the center enhances the technological atmosphere inside the car. The engine comes with practical features such as one-key start, electronic parking brake, seat heating, reverse radar, and vehicle stability system. It also includes comfort and tech configurations like rear automatic air conditioning, central armrest entertainment system control panel, and rear sunshades.
10
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.