Should the tire be replaced if punctured by a nail?

What are the regulations for non-local vehicles in Beijing?

Beijing's regulations for non-local vehicles are as follows: 1. From 7:00 to 9:00 and 17:00 to 20:00 on weekdays, non-local vehicles are prohibited from entering roads within the Fifth Ring Road; 2. From 9:00 to 17:00 on weekdays, traffic management measures for peak-hour restrictions based on the last digit of the license plate are implemented, with the restricted area being roads within the Fifth Ring Road. The rotation method for license plate tail numbers follows the rotation method for Beijing motor vehicle license plate tail numbers. In addition, there are strict restrictions for certain types of vehicles such as trucks, special operation vehicles, and yellow-label vehicles: 1. From 6:00 to 24:00 daily, trucks and special operation vehicles are prohibited from entering roads within the Sixth Ring Road; 2. Motorcycles are prohibited from entering roads within the Sixth Ring Road at all times; 3. For yellow-label vehicles from other provinces, districts, or cities, no Beijing entry permit will be issued, and they are prohibited from entering main roads within the Sixth Ring Road and county towns in the suburbs of the city at all times.

3

5

Share

What Are the Reasons for the Engine Light to Illuminate?

The engine light may illuminate due to the following reasons: 1. Poor-quality gasoline that does not meet standards. Low-quality gasoline can lead to incomplete combustion of the air-fuel mixture in the cylinders, resulting in excessive carbon deposits. It also poses risks such as clogging fuel lines and corroding components, directly affecting the normal air-fuel mixture concentration and ultimately causing the engine light to illuminate along with engine vibrations. 2. Oxygen sensor malfunction. If the oxygen sensor is damaged or its connector is faulty or loose, it can cause the air-fuel mixture to become too lean or too rich, triggering the engine light. 3. Mass airflow sensor failure. If the mass airflow sensor or its circuit malfunctions, the engine control unit (ECU) will not receive accurate intake air volume signals, leading to improper fuel control. This can result in an overly lean or rich mixture, causing the engine to operate abnormally and sometimes illuminating the engine light. 4. Spark plug carbon buildup. Carbon deposits on spark plugs can cause poor engine performance, including difficulty starting, unstable idling, poor acceleration, backfiring during rapid acceleration, excessive exhaust emissions, increased fuel consumption, and other abnormal symptoms. 5. Engine knocking. When the level of undetectable knocking exceeds the ECU's adjustable range, the engine light will illuminate as a warning. 6. Coolant temperature sensor failure. If the coolant temperature sensor fails to provide cold-engine status information, it can cause the air-fuel mixture to become too lean, leading to abnormal engine operation. 7. Engine misfire. A misfiring engine can result in increased fuel consumption, black smoke emissions, poor acceleration, severe vibrations, louder engine noise, and an increased likelihood of stalling.

5

4

Share

Can a C1 license drive an automatic transmission car?

A C1 driver's license allows driving small automatic transmission vehicles, as well as manual transmission and automatic transmission blue-plate small box trucks. A C2 driver's license permits driving small automatic transmission vehicles, small and micro automatic transmission passenger vehicles, as well as light and micro automatic transmission cargo vehicles. Regulations on vehicle types permitted by a C1 driver's license: The permitted scope of a C1 driver's license includes small and micro passenger vehicles, light and micro cargo vehicles; light, small, and micro special operation vehicles; small passenger vehicles with seating capacity not exceeding 9 persons. Vehicles not permitted by a C1 driver's license: large buses, tractor units, city buses, medium buses, large trucks, ordinary three-wheeled motorcycles, ordinary two-wheeled motorcycles, light motorcycles, wheeled self-propelled machinery, trolleybuses, and trams. Additionally, a C1 license cannot drive vehicles with more than 9 seats or trucks with a total length exceeding 6 meters. What is a C1 driver's license: A C1 driver's license is one of the codes for motor vehicle driver's licenses. The permitted scope of a C1 driver's license includes small and micro passenger vehicles, light and micro cargo vehicles; light, small, and micro special operation vehicles; small passenger vehicles with seating capacity not exceeding 9 persons. Application age: The minimum age requirement for a C1 driver's license is 18 years old, with no upper age limit. However, applicants aged 70 and above must pass tests for memory, judgment, and reaction abilities.

12

1

Share

Where is the car cigarette lighter fuse located?

The car cigarette lighter fuse is located at the lower left corner of the driver's seat and inside the engine compartment cover. The cigarette lighter is a component found in all cars, designed to provide a flame source for drivers who smoke. The commonly referred to cigarette lighter can be divided into those that draw power from the vehicle's electrical system. However, some manufacturers produce lighters not for smoking but simply to draw power from the car, which are also called cigar lighters. The disassembly method of the cigarette lighter is as follows: 1. Operate the inner and outer rings: The cigarette lighter consists of outer and inner rings. Press the inner ring in when using it. When it reaches a certain temperature, the inner ring will automatically return to its original position, then you can pull it out by holding the outer ring. 2. Remove screws: Some car lighter sockets are fixed with screws at the back. Just use a wrench to remove the screws to take it off. Similarly, screw them back on to install. 3. Remove the panel: Remove the gear lever panel, which is held by plastic clips. Simply pry one side up by hand or with a flathead screwdriver to remove the entire panel. 4. Remove panel screws: After removing the gear lever panel, the lighter panel door will automatically open, revealing two black screws. Remove them with an M4 hex wrench. 5. Remove the panel box: Pull the lighter's plastic panel box out by hand. When it's about 10 cm out, disconnect the wiring first, then you can pull the entire box out. 6. Operate the inner and outer rings: The cigarette lighter consists of outer and inner rings. Press the inner ring in when using it. When it reaches a certain temperature, the inner ring will automatically return to its original position, then you can pull it out by holding the outer ring.

18

3

Share

How to Remove the Speed Limit on Yadea Electric Scooters?

Yadea electric scooter speed limit removal steps are: 1. With the power lock turned off, prop up the kickstand and ensure the motor hub is stationary (operation will be invalid if the hub is rotating to prevent accidental operation while riding); 2. Twist the throttle to the maximum while holding the brake; 3. Turn on the power lock; 4. Maintain brake pressure, fully release the throttle, then twist it to the maximum twice consecutively; 5. Keep both the brake and throttle at maximum position for over 3 seconds; 6. Completely release both the brake lever and throttle; 7. The removal process is complete. Electric scooters are vehicles powered by electricity, also known as e-scooters. They are categorized into AC electric scooters and DC electric scooters.

5

3

Share

What Documents and Procedures Are Required for Vehicle Transfer?

Vehicle transfer requires the following documents: purchase invoice, vehicle certificate, invoice, ID card, copy of organization code certificate, insurance policy, and tax payment receipt. The procedures include: submitting documents, owner's signature, external inspection and confirmation of the vehicle, selecting a number plate, fixing the license plate, installing the plate, receiving the vehicle license and registration certificate. Non-local residents need to apply for a temporary residence permit. If handled by an agent, the agent's ID card is also required. To pay the vehicle purchase tax, you need to submit the invoice, ID card, copy of organization code certificate, copy of vehicle certificate, purchase invoice, and the first copy of the tax declaration form, but the invoice and original vehicle certificate must be submitted first. The transfer process is completed within one working day.

16

2

Share

Should the tire be replaced if punctured by a nail?

What are the regulations for non-local vehicles in Beijing?

What Are the Reasons for the Engine Light to Illuminate?

Can a C1 license drive an automatic transmission car?

Where is the car cigarette lighter fuse located?

How to Remove the Speed Limit on Yadea Electric Scooters?

What Documents and Procedures Are Required for Vehicle Transfer?

Can Test Drive Vehicles Be Purchased?

What is the difference between the clutch and the accelerator?

What are the hidden features of the new Sylphy?

How to Read Traffic Light Signals?