Should the first maintenance be done after only driving 1,000 km in 3 months for a new car?

1 Answers
VanBradley
07/29/25 4:06pm
If a car has only been driven a little over 1,000 km in three months, the first maintenance may not be necessary. The first maintenance is the initial service for a car, typically recommended at 5,000 km/6 months (with some exceptions). Many brand dealerships, aiming to shorten customers' maintenance intervals, now advise customers to perform maintenance at 3,000 km/3 months. The service is due when either of these two thresholds is reached first. First maintenance includes: Changing the engine oil and oil filter, checking all vehicle lights, inspecting fluid levels, verifying the functionality of all electrical systems, examining tires and adjusting tire pressure, inspecting the chassis components for any issues, checking for oil leaks in the engine and transmission, and ensuring they are functioning properly. Additionally, a professional diagnostic tool will be used to perform a computer scan of the entire vehicle, and the maintenance reminder will be reset. First maintenance mileage: Different car brands and models may have varying requirements, but most commonly, the first maintenance is recommended between 3,000 to 5,000 km. Some brands may extend this interval to around 8,000 to 10,000 km.
Was this review help?
18
3
Share
More Forum Discussions

Can a Vehicle License Show if a Car is Second-Hand?

A vehicle license cannot indicate if a car is second-hand. Here are some considerations when buying a used car: 1. Pay attention to the appearance: Some used cars have been in accidents. To increase their value, dealers may refurbish them, repaint the car to make it look newer. Therefore, when purchasing a car, carefully inspect the exterior, check all corners and parts for signs of repainting, and look for wear on the tires, headlights, and bumpers. 2. Check the chassis and frame: After an accident, even if the exterior is well-repaired, the frame and chassis are difficult to restore. If you notice any deformation or bending, be cautious—this car might be an accident vehicle.
1
1
Share

How to Disassemble a Kia K3 Key?

Use a flathead screwdriver, place it in the notch at the bottom of the key, and pry open the key shell. It might be tight, so gently twist the screwdriver left and right to open it. Once the notch is pried open, separate the upper and lower shells along the edge. You can use a card or simply slide your fingernail slowly forward to separate the upper and lower shells.
4
1
Share

What are the differences between C1, C2, and C3?

C1, C2, and C3 differ mainly in the types of vehicles they permit driving and the additional vehicle categories they cover. Below is a detailed introduction to the differences between C1, C2, and C3: 1. Different permitted vehicle types: (1) A C1 license allows driving manual or automatic transmission vehicles with fewer than 9 seats. (2) A C2 license only permits driving automatic transmission passenger cars, light, and mini automatic transmission trucks. (3) A C3 license allows driving low-speed trucks and three-wheeled vehicles. 2. Different additional permitted vehicle categories: (1) Additional categories permitted by C1: C2, C3, C4. (2) Additional categories permitted by C2: None. (3) Additional categories permitted by C3: C4.
7
2
Share

How to Remove the Headlights of a Mondeo Zhisheng?

Open the engine compartment cover of the Mondeo. At the position of the headlights, there are two long retaining strips, which are steel clips inserted on top to secure the headlights. Simply pull them out when removing.
6
4
Share

Can Toothpaste Be Used to Refurbish Headlights?

Toothpaste can be used to refurbish headlights. However, if the headlight cover is severely stained, the refurbishing effect of toothpaste will not be very noticeable. Here is an introduction to the methods for headlight refurbishment: 1. Spray Paint Refurbishment: Apply UV paint to the headlights and dry it using an ultraviolet lamp. This method has a relatively short duration. 2. Polishing Refurbishment: Polishing refurbishment can be performed at a car detailing shop. Sand the headlights with sandpaper and polish them with specialized wax. This refurbishment method yields noticeable results, but it cannot polish all areas, and the protective film will also be worn off after polishing. 3. Fumigation Repair Refurbishment: Reapply a layer of protective film. Seal the edges of the headlights with tape, sand them with sandpaper of varying coarseness, and apply the protective film using professional tools.
1
1
Share

How to Replace the Cabin Air Filter in a Toyota Corolla?

To replace the cabin air filter, you need to remove the glove compartment first. After removing the glove compartment, locate a horizontally placed cover. The left and right sides of this cover can be moved; gently pull them outward to open the cover. Once the cover is open, you will see the cabin air filter inside, which can then be taken out. Insert the new cabin air filter into place.
17
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.