Should the dual-clutch transmission be shifted to neutral (N) when parking?

What to Do When a Vehicle Wades Through Water

Here are the solutions for a vehicle wading through water: 1. If the vehicle does not stall, lightly tap the brakes after driving out of the water to remove moisture from the brakes. 2. If the vehicle stalls, do not attempt to restart it; wait for rescue and dry the vehicle. 3. If the vehicle stalls and is restarted in the water, the engine may require major repairs (forcing the engine to start after water ingress can damage components such as the crankshaft). Below is additional information for future encounters with waterlogged roads: 1. Slow down and assess the water level. If the water reaches two-thirds of the tire height, wading through it poses certain risks, and it is advised not to force passage. 2. If you decide to proceed, maintain a low speed (manual transmissions should be in the lowest gear). High speeds can raise the water level, increasing the actual wading depth. Additionally, try to pass through in one go without stopping, shifting gears, or lifting off the throttle. Maintain medium-to-high throttle at low speed. 3. If the vehicle stalls during wading, do not attempt to restart the engine. This situation likely indicates water ingress into the engine, and restarting could cause more severe damage.

19

3

Share

Which Position in the Back Seat is Best for Installing a Child Safety Seat?

Installing the child safety seat in the middle position of the back seat is the safest. Below is a brief introduction about child safety seats: 1. Installation Points: There are four possible locations in a car to install a child safety seat—the front passenger seat, the left side of the back seat, the middle of the back seat, and the right side of the back seat. The front passenger seat is the least safe position, while the back seat positions are significantly safer compared to the front passenger seat. 2. Theoretical Installation Point: In theory, the safest position for a child safety seat is the middle of the back seat. However, the middle position usually does not have dedicated ISOFIX or LATCH anchors, requiring the use of the seat belt to secure the safety seat. 3. Practical Installation Point: In real-world scenarios, for family cars with children, the back seat is frequently used. Installing the safety seat in the middle position may encroach on the space of the side seats, affecting passenger comfort. Therefore, the safety seat is often installed on the left or right side of the second row. Since vehicles in this country drive on the right side of the road, for enhanced safety and convenience when passengers enter or exit the vehicle, it is preferable to install the safety seat on the left-side seat, i.e., the seat behind the driver. During driving, the left-side seat offers slightly better safety than the right-side seat.

15

1

Share

Why Can't My Phone Find the Car's Bluetooth?

There are several reasons why a phone cannot find the car's Bluetooth: 1. The car's Bluetooth is not turned on, preventing the phone from detecting it within range. The solution is to enable the car's Bluetooth in the vehicle settings. 2. The phone is too far from the car. Since Bluetooth has a limited range, being too far away will prevent detection. The solution is to reduce the distance between the phone and the car, the closer the better. 3. The car's Bluetooth name has been changed. If the name was altered, the original name will no longer appear in the search list. The solution is to check if the Bluetooth name was changed and search again. 4. If the car's Bluetooth is set to not be discoverable by other devices, it won't appear in searches. The solution is to enable the car's Bluetooth and check if it can be discovered by other devices, then turn on the discoverable mode.

13

4

Share

What Causes Low Oil Pressure?

Low oil pressure can be caused by: 1. Insufficient engine oil level, resulting in inadequate lubrication; 2. Dirty or overly viscous oil preventing proper circulation by the oil pump; 3. Overly thin oil due to dilution or high engine temperature, causing leaks through engine bearing clearances; 4. Oil pipe leaks, damaged oil pump, or excessive component wear; 5. Excessive clearance between crankshaft and bearings; 6. Faulty pressure relief valve due to weak springs, sticking, or damaged components; 7. Malfunctioning oil pressure sensor, gauge, or electrical circuit.

1

2

Share

Where is the seat heating button?

Seat heating button is located above the air conditioning control buttons at the lower part of the center console. The button in the left red frame is the driver's seat heating switch, and the button on the right is the passenger seat heating switch. Precautions for using heated seats: 1. Do not kneel on the seat or subject the seat to concentrated loads to avoid damaging the heating elements of the seat heating device; 2. Do not clean the seat with wet washing methods; 3. The seat heating device can only be turned on when the engine is running, which can greatly reduce the battery capacity consumption; 4. If the vehicle voltage drops, the seat heating device will automatically turn off to ensure that the engine control unit has sufficient power supply; 5. Do not place seat cushions on the seat when using electric heating.

15

1

Share

How to Adjust the Tightness of Electric Vehicle Brakes?

Steps to adjust the tightness of electric vehicle brakes: 1. Squeeze the brake by hand to see a pull wire on the side of the wheel; 2. Follow the wire to find its head held by a hexagonal nut; 3. Use pliers to hold the pull wire and slowly loosen the hexagonal nut to adjust the brake. Disc brakes, also known as disk brakes, are divided into ventilated disc brakes and ordinary disc brakes. Ventilated disc brakes have ventilation slots cut on the end face of the disc, rectangular ventilation holes prefabricated, or many round ventilation holes drilled on the disc surface. Because ventilated disc brakes utilize the effect of airflow, their cooling and heating effects are better than those of ordinary disc brakes. The main advantages of disc brakes are: rapid braking during high-speed braking, better heat dissipation than drum brakes, good stability of braking performance, easy installation of electronic equipment such as ABS, and the use of metal blocks instead of drum wheels.

1

4

Share

Should the dual-clutch transmission be shifted to neutral (N) when parking?

What to Do When a Vehicle Wades Through Water

Which Position in the Back Seat is Best for Installing a Child Safety Seat?

Why Can't My Phone Find the Car's Bluetooth?

What Causes Low Oil Pressure?

Where is the seat heating button?

How to Adjust the Tightness of Electric Vehicle Brakes?

How to Start with One-Button Start?

How Many PSI Should Car Refrigerant Be Charged To?

How to Use a Dash Cam?

Where is the rearview mirror heating switch on the Jetour X70 Plus?