···
Log in / Register

Should the Air Conditioning Be Turned Off When the Car Is Turned Off?

4 Answers
VanEthan
07/29/25 10:04am
It is necessary to turn off the air conditioning when the car is turned off. Below are some related additional information: 1. Disadvantages of not turning off the air conditioning: When the vehicle is started next time, the engine will start with the load of the air conditioning, and such a high load can damage the engine. After parking, the evaporator for cooling will adsorb many small water droplets on its surface. If left unattended, bacteria will breed inside the evaporator over time, and a musty odor will be produced. 2. Maintenance of car air conditioning: Regularly clean and replace the air conditioning filter, as the air conditioning filter is an air filtration device that can filter out dust particles, harmful particles, and other dirt from the air before it enters the cabin. However, after prolonged use, the filter will become clogged with these particles, gradually affecting the cooling efficiency of the air conditioning and increasing fuel consumption. Regularly clean the radiator and condenser, as the radiator and condenser are located in the engine compartment at the front of the car and are used for heat dissipation. Over time, they can also become dirty, affecting the cooling efficiency of the air conditioning and increasing fuel consumption. Therefore, these two areas, as well as the engine compartment, should be cleaned before the summer season begins.
Was this review help?
7
1
Share
DeBriella
08/13/25 12:43pm
As a seasoned driver with twenty years of experience, turning off the air conditioning before shutting down the engine is crucial. If the AC is left on when the engine is turned off, it will suddenly activate upon the next start-up, placing an extra burden on the battery. This can easily lead to battery drain or even shorten its lifespan. Over time, it may also damage the compressor and electrical system. I usually turn off the AC a few minutes in advance, allowing the cabin temperature to adjust naturally. This not only protects the vehicle but also saves a bit of fuel. Since adopting this habit, my car has experienced fewer issues, especially during hot summers, avoiding discomfort caused by extreme temperature differences. Additionally, this contributes slightly to the environment by reducing unnecessary energy consumption. In summary, turning off the AC before shutting down the engine is a small action with significant benefits.
Was this review help?
3
0
Share
Expand All
DiBenjamin
10/07/25 2:45am
As an energy-saving enthusiast, I believe turning off the AC before shutting down the engine is a must-do daily habit. It helps conserve energy and avoid unnecessary waste, such as the AC consuming battery power when left on after the engine is off. If not turned off promptly, it may lead to battery depletion during prolonged parking, causing inconvenience. I've practiced turning off the AC before pulling into a parking spot, letting the fan blow for a while to naturally cool down, which is not only comfortable but also fuel-efficient. It's also environmentally friendly, reducing carbon emissions. Adopting this simple action has made my life greener and more economical.
Was this review help?
16
2
Share
Expand All
AustinAnn
11/20/25 4:08am
From a convenience standpoint, I make it a habit to turn off the air conditioning before shutting down the vehicle. This prevents the jolt upon next startup and protects the car's electronic components from potential damage. For instance, leaving the AC on during engine cutoff may cause minor issues due to excessive system load during restart. I typically switch it off a few minutes before parking to utilize residual airflow for cabin cooling. This simple practice also teaches children good habits and reduces household expenses. Maintaining vehicle health ensures more worry-free journeys.
Was this review help?
8
0
Share
Expand All
More Forum Discussions

What are the hazards of a faulty thermostat?

The hazards of a faulty thermostat to a car are as follows: 1. A faulty thermostat can cause the cooling water temperature to go out of control. When designing the cooling system, the maximum heat dissipation capacity is based on ensuring reliable cooling for the engine under the most challenging conditions, such as high load, low speed, and high external temperature. Obviously, under conditions of low load, high speed, and low external temperature, the heat dissipation capacity is excessive, causing the engine to overcool. Therefore, a device to regulate the cooling intensity is needed, achieved by changing the air flow of the radiator or the cooling water circulation route, ensuring the engine operates within the most suitable range. The change in the cooling water circulation route is generally automatically controlled by the thermostat based on temperature changes. When the cooling water is below 70°C, the cooling water circulates in a small loop without passing through the radiator; when the cooling water temperature is above 80°C, it circulates in a large loop through the radiator. 2. A faulty thermostat causes drastic changes in the engine's economy and durability. Without a thermostat, the engine often operates in a low-temperature state, leading to poor thermal conditions, accelerated wear of components, and increased fuel consumption. Experiments show that when the engine operates at low temperatures of 40°C~50°C, its wear increases by 30~40 times, significantly shortening its service life. The reasons are: (1) Increased fuel consumption: Due to the low temperature, excessive heat dissipation from the cylinder walls reduces the temperature and pressure of the gases in the cylinder and thermal efficiency, leading to increased fuel consumption. (2) Increased wear of parts: Poor evaporation and atomization of fuel make it difficult to form a proper air-fuel mixture, causing the mixture to become too rich, incomplete combustion, and a large amount of fuel to be wasted without effective use. This results in reduced power, increased fuel consumption, and in severe cases, some fuel in the mixture condenses on the cylinder walls, washing away the oil film and flowing into the crankcase, diluting the oil and increasing part wear. (3) Reduced engine power: At low temperatures, the viscosity of the lubricating oil increases, and its fluidity deteriorates, increasing the resistance of moving parts such as the crankshaft and bearings, and the piston and cylinder walls, leading to reduced power and increased fuel consumption. (4) Corrosion effect: Water vapor produced by combustion condenses on the cylinder walls at low temperatures and combines with combustion byproducts to form strong corrosive agents, such as sulfuric acid, nitric acid, and carbonic acid, which strongly corrode parts like the cylinder walls, pistons, and piston rings.
8
5
Share

What does motorcycle 125 mean?

Motorcycle 125 refers to motorcycles with an engine displacement of around 125CC. Major motorcycle manufacturers have launched various brand motorcycles with engines based on this displacement. The classification between motorcycle 125 and motorcycle 250 is determined by the actual displacement of the engine installed in the motorcycle. Displacement is a specialized term in hydraulic transmission, referring to the volume of fluid inhaled or discharged per stroke or cycle. Generally, a larger displacement means the engine releases more energy—converting the chemical energy of fuel into mechanical energy—in a given time, resulting in better performance. Motorcycles are two- or three-wheeled vehicles driven by gasoline engines, steered by handlebars for front-wheel turning. They are lightweight, flexible, and fast, widely used for patrol, passenger and cargo transport, and also as sports equipment.
1
3
Share

Does a Car Wash Machine Damage the Car Paint?

Car wash machines do not damage the car paint. Currently, the fully automatic car wash machines available in the market use related programs to achieve automatic cleaning, waxing, drying, and wheel rim cleaning for vehicles. The brushes on the car wash machines are made of high-composite materials, which will not cause any harm to the car paint. Car paint has a certain thickness, and during regular maintenance, sometimes the car paint needs to be polished, removing a layer of the surface paint. Even if the vehicle gets scratched, as long as the primer is not damaged, the car paint can be relatively easily repaired. The car wash machine is mainly a machine that uses computer-controlled brushes and high-pressure water to automatically clean the car. It can be divided into automatic car wash machines, self-service car wash machines, and coin-operated car wash machines, mainly composed of a control system, circuits, air paths, water paths, and mechanical structures.
7
5
Share

How Many Points Will Be Deducted for Missing License Plate Screws?

Missing license plate screws can result in a maximum deduction of 12 points. Motor vehicle license plates must be hung according to regulations, and special license plate fastening devices must be installed in designated positions. Not using the special fastening devices for license plates or using other fastening devices is considered illegal. The license plate fastening device mainly consists of bolts, nuts, a fastening base, and a fastening cover. The fastening cover is printed with Chinese characters representing the abbreviation of the province, autonomous region, or municipality directly under the central government, as well as letters representing the issuing authority code, which must match the abbreviations and codes on the license plate. Each motor vehicle license plate should be equipped with 8 new-style license plate fastening devices.
1
0
Share

Can I directly apply for a B2 license now?

Now you can directly apply for a B2 license. First-time applicants for a driver's license can directly apply for the medium-sized bus driving category, provided they are between 21 and 50 years old. You can register for the exam at the vehicle management office or a driving school. To directly apply for a B2 driver's license, you must pass a physical examination with both eyes having a vision of 5.0, no color blindness, and sound limbs. A B2 license allows you to drive heavy-duty, medium-duty trucks or large, heavy, and medium-sized special-purpose vehicles. Heavy-duty and medium-duty trucks are mainly trucks, while large, heavy, and medium-sized special-purpose vehicles refer to vehicles equipped with special equipment or devices, such as sprinkler trucks, concrete mixer trucks, fire trucks, etc.
4
1
Share

What does a Fujian license plate start with?

Fujian license plates start with the character 'Min', where Min A represents Fuzhou City, Min B represents Putian City, Min C represents Quanzhou City, Min D represents Xiamen City, Min E represents Zhangzhou City, Min F represents Longyan City, Min G represents Sanming City, Min H represents Nanping City, Min J represents Ningde City, and Min K represents the provincial system. License plates are composed of Chinese characters and English letters. The Chinese character is the abbreviation of the province, autonomous region, or municipality directly under the central government, while the English letter represents the code of the vehicle management office. The license plate number consists of 6 characters, which can be Arabic numerals or a combination of Arabic numerals and English letters. License plates, commonly known as car plates, are plates hung on the front and rear of a vehicle, typically made of aluminum, sheet iron, plastic, or paper, displaying the vehicle's registration number, registration region, or other relevant information.
7
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.