···
Log in / Register

Should I Repair a Slightly Leaking Car Driveshaft?

1 Answers
MacSophie
08/31/25 6:05am
Car driveshaft oil leakage requires repair. Below are specific details about driveshaft oil leakage: External Inspection: Check whether the oil seals at the front and rear ends of the crankshaft are leaking. A cracked, damaged, or aged front crankshaft oil seal, or wear on the contact surface between the crankshaft pulley and the oil seal, can cause front crankshaft oil leakage. A cracked or damaged rear crankshaft oil seal, or an excessively small oil return hole in the rear main bearing cap obstructing oil return, can cause rear crankshaft oil leakage. Additionally, check whether the camshaft rear oil seal is leaking. If the oil seal is aged or cracked, it should be replaced promptly. Crankcase Inspection: If oil is leaking from the front or rear oil seals but no obvious leak source is found, inspect the crankcase ventilation system. Clean the crankcase ventilation pipes, especially checking whether the PCV valve is malfunctioning due to carbon buildup and gumming. Poor crankcase ventilation can significantly increase crankcase pressure, leading to multiple oil seepage points. Oil Pressure Inspection: If oil continues to leak from the oil filter or some oil pipe joints after tightening, check whether the oil pressure is too high and whether the oil pressure relief valve is malfunctioning.
Was this review help?
9
3
Share
More Forum Discussions

What are the symptoms of a faulty intake manifold pressure sensor?

Intake manifold pressure sensor failure symptoms include: 1. Open or short circuit in the sensor's internal wiring; 2. The sensor's output signal fails to vary with changes in intake manifold vacuum; 3. The sensor's output signal voltage is excessively high or low, deviating from the normal range. The intake pressure sensor is a device capable of detecting pressure signals and converting them into usable output electrical signals according to specific patterns. The working principle of the intake manifold pressure sensor is: it detects changes in absolute pressure within the intake manifold based on engine speed and load, then converts this into a signal voltage sent to the engine ECU. The ECU uses this signal voltage to determine the basic fuel injection quantity.
11
4
Share

Where is the air filter of Patrol located?

The air filter of Patrol is located inside the glove compartment in front of the front passenger seat. You can see the air filter after opening the glove compartment. The functions of the air filter are: 1. Filter the air entering the cabin from the outside to improve air cleanliness; 2. Provide a good riding environment for the driver and passengers, and protect their health. The Patrol is equipped with a 4.0L naturally aspirated engine, with a maximum power of 205kW and a maximum power speed of 5600rpm. The maximum torque is 394Nm, matched with a 7-speed automatic transmission. The front and rear suspension types are double-wishbone independent suspension.
13
3
Share

What is an automobile engine composed of?

An automobile engine is composed of five major systems and two main mechanisms. The five systems are the fuel supply system, cooling system, lubrication system, ignition system, and starting system. The two mechanisms are the crank connecting rod mechanism and the valve train mechanism. The automobile engine is the device that provides power for the vehicle, determining its power, fuel economy, stability, and environmental performance. The working principle of the engine is as follows: 1. Mixing air and gasoline in a certain proportion to form a combustible mixture; 2. The intake stroke draws the mixture into the cylinder, where it is compressed, ignited, and burned to generate thermal energy; 3. The high-temperature and high-pressure gas acts on the top of the piston, driving the piston to perform reciprocating linear motion, and mechanical power is output externally through the connecting rod, crankshaft, and flywheel mechanism.
3
3
Share

Where is the car filter located?

The car filter is located in: 1. The air filter is installed in front of the carburetor or intake pipe; 2. The oil filter is in the engine lubrication system, mainly located at the front top of the engine and below the engine; 3. The cabin air filter is located below or inside the glove box on the passenger side; 4. The fuel filter is located at the fuel pipe connection on the vehicle chassis. The car filter is connected in series in the pipeline between the fuel pump and the throttle body inlet. The structure of the car filter consists of an aluminum shell and an internal stainless steel bracket, with high-efficiency filter paper sheets mounted on the bracket. The filter paper sheets are chrysanthemum-shaped to increase the flow area. Fuel injection filters cannot be used interchangeably with carburetor filters.
19
1
Share

How to check the tire pressure of an Audi A3?

Audi A3 checks tire pressure by: The tire pressure monitoring is built-in and passively sensed. When there is a problem, the dashboard will alert, but you cannot see the specific value, only the tire pressure warning light will illuminate. Tire pressure refers to the air pressure inside the tire, and the level of tire pressure plays an important role in the performance and power of the car. The Audi A3 is a compact 5-door, 5-seat hatchback with body dimensions of: length 4351mm, width 1815mm, height 1458mm, and a wheelbase of 2630mm. The Audi A3 is equipped with a 1.4T turbocharged engine and a 7-speed dual-clutch transmission, with a maximum power of 110 kilowatts and a maximum torque of 250 Newton-meters.
6
2
Share

How wide is the Lamando?

The width of the Lamando is 1826mm, the length is 4615mm, the height is 1425mm, the wheelbase is 2656mm, and the fuel tank capacity is 51 liters. The Lamando is equipped with a 1.4T turbocharged engine, with a maximum power of 96kW and a maximum torque of 225Nm, paired with a 7-speed dual-clutch transmission. The front suspension uses a MacPherson independent suspension, and the rear suspension uses a multi-link independent suspension. In terms of appearance, the front face of the Volkswagen Lamando adopts a family-style design, with a three-bar grille connected to the headlights, and round fog lights on either side of the bumper. The side lines are very smooth, with a straight and deep waistline extending all the way to the rear of the car, leaving a very impressive impression.
9
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.