Should I Buy the Haval Big Dog with 1.5T or 2.0T?

1 Answers
VonBrandon
07/30/25 5:23am
Whether to buy the Haval Big Dog with 1.5T or 2.0T depends on the required driving range. Here is a partial introduction about car fuel consumption: Fuel consumption fluctuations due to temperature influence: This is a normal phenomenon. Generally, in winter when temperatures are low, fuel consumption increases slightly, almost comparable to fuel consumption when using air conditioning in summer. This is because lower temperatures cause the engine to dissipate more heat. Vehicle not maintained for a long time: Dirty engine oil and air filters can also lead to increased fuel consumption. Dirty oil results in poor lubrication, increasing resistance in the engine's moving parts and requiring more energy to overcome this resistance, thus raising fuel consumption. Insufficient tire pressure: Low tire pressure increases the contact area between the tires and the ground, increasing friction and driving resistance, which in turn raises fuel consumption.
Was this review help?
11
1
Share
More Forum Discussions

How to Control Fatigue Driving?

Measures to prevent fatigue driving are as follows: 1. Light diet: Drivers should try to maintain a light diet and avoid greasy and fried foods that increase the burden. 2. Shock-absorbing steering wheel: The steering wheel is the main way for drivers to perceive road conditions, which makes the vibration of the steering wheel more obvious than other parts. For some harder steering wheels, a steering wheel cover can be installed to reduce driver fatigue. 3. Adequate sleep: As a driver, you must ensure adequate sleep. Seven hours of sleep every day is essential, and maintaining regular living habits is important.
8
1
Share

How to Solve the Problem of Water Accumulation Under the Rear Floor Mats of a Tiida?

Drive the vehicle to a 4S shop. The 4S shop will first remove all damp components such as the seats and carpets and dry them in the sun. Then, they will inspect the damp wiring harness connectors, clean them with specialized cleaning agents, and finally dry them with an air gun. The 4S shop will check all possible causes of water accumulation in the vehicle and resolve them. After that, the dried interior components such as seats and carpets will be reinstalled.
17
2
Share

How to Bleed Air from a Three-Wheeler's Hydraulic Brakes?

The brake caliper has a bleeder screw. It requires two people to operate. After starting the vehicle, one person gently presses the brake pedal while the other slowly loosens the bleeder screw to release the brake fluid. The person pressing the brake must keep the pedal depressed without lifting their foot. When the pedal can no longer be pressed down, they should inform the person releasing the fluid. At this point, the bleeder screw should be tightened, and only then can the brake pedal be released.
5
2
Share

How to Remove the Speed Limiter on CBR650R?

With the ignition switch in the off position, turn the throttle grip all the way to the end with your right hand and then pull the brake lever all the way to the end. Next, use your left hand to turn on the ignition switch, then release the throttle grip and brake lever with your right hand. Turn the throttle grip all the way to the end with your right hand and pull the brake lever all the way to the end. With your left hand, turn on the ignition switch and then hold the left brake lever. With your right hand, turn the throttle grip all the way to the end and then release it completely, repeating this operation twice.
15
3
Share

What to Do If Your Car Tire Gets Punctured on the Highway?

Heavy braking can cause the vehicle to become unstable and lose control, so you should not immediately step on the brake after a tire blowout. Do not immediately release your foot from the accelerator pedal. It is recommended to maintain the throttle for a while before slowly releasing it. After stabilizing the vehicle's movement, gradually bring the car from idle to a complete stop. Use engine braking if necessary. Once the speed has decreased, gently apply the brakes, turn on the turn signal, and move out of the driving lane.
17
0
Share

Which company manufactures Hanteng?

Hanteng is manufactured by Jiangxi Hanteng Automobile Co., Ltd., a company engaged in automobile and agricultural vehicle manufacturing, sales, and hoisting machinery manufacturing, headquartered in Shangrao City. Taking the Hanteng X5 model as an example, its body dimensions are 4500mm in length, 1820mm in width, and 1645mm in height, with a wheelbase of 2600mm. In terms of exterior design, the Hanteng X5 continues the family-style design language, presenting a relatively simple appearance; the hexagonal front grille features two thick horizontal chrome strips, connecting the grille with the headlights on both sides. The interior showcases a large area of wood grain trim on the center console.
18
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.