Should brake pads be replaced together for front and rear?

1 Answers
McEmilio
07/29/25 8:01pm
Front and rear brake pads do not need to be replaced together, as they have different replacement cycles. Compared to front brake pads, rear brake pads have a longer service life. Under normal driving conditions: 1. Front brake pads typically need replacement after 30,000 to 50,000 kilometers. 2. Rear brake pads can last for about 60,000 to 100,000 kilometers before needing replacement. Additional information: 1. The replacement interval for brake pads is not only directly related to their service life but also depends on the vehicle's driving conditions and the driver's habits. 2. New brake pads are approximately 1.5 cm thick. If they wear down to one-third of their original thickness, or about 5 mm, they should be replaced promptly.
Was this review help?
14
5
Share
More Forum Discussions

What are the uses of Toyota shiftlock?

Toyota shiftlock is a parking gear that enables the vehicle to remain stationary on slopes by locking the axle through the gear position. It is a special neutral gear that mechanically locks the transmission output shaft to secure the vehicle, functioning as a post-parking brake to prevent vehicle movement. Other functions include: 1. Preventing stationary sliding: Shiftlock can prevent the vehicle from sliding when the gear is accidentally shifted while stationary. Pressing this button removes this basic protection, which could lead to accidents. Therefore, it is best to use Shiftlock only when the transmission fails to shift and the vehicle needs to be towed; otherwise, avoid pressing the Shiftlock button casually. 2. Vehicle malfunction: In addition to allowing forced gear shifting during vehicle malfunctions, Shiftlock can also be used in parking lots. Some parking lot attendants may require automatic transmission vehicles to be placed in N (neutral) gear without engaging the handbrake.
10
2
Share

How many liters of engine oil are needed for a Corolla 1.2t oil change?

Corolla 1.2t requires 4 liters of engine oil for an oil change. Oil change interval: Generally, considering the fuel quality in China, it is appropriate to change the engine oil at around 8,000 kilometers. However, this interval is not applicable to all situations, as it may vary depending on the quality of the oil and the driving conditions. Full synthetic oil has the longest service life and can usually be changed at around 10,000 kilometers. Semi-synthetic oil can be changed at 8,000 kilometers, while conventional mineral oil should be changed earlier. Impact of oil quality: The quality of the oil significantly affects the engine's working environment. The engine operates in high-temperature conditions with continuous mechanical friction. Engine oil plays a crucial role in cooling, lubricating, and cleaning during this process. Over time, impurities in the oil increase, and its performance declines. Therefore, regular oil changes are essential for the longevity of the engine.
9
0
Share

What does it mean when the ABS light comes on when starting the car?

There are multiple conditions for the ABS light being on, with different causes and solutions for each condition, as detailed below: Condition 1: ABS warning light stays on (most common). Cause 1: The ABS wheel speed sensor's sensing area is covered by mud, sludge, or other contaminants, affecting its ability to detect the corresponding wheel speed signal. This prevents the ABS control unit from determining the vehicle speed and wheel slip rate, thus failing to issue appropriate commands to regulate braking. Solution: Clean the dirt from the wheel speed sensor and adjust the gap between the sensor and the tone ring to restore normal function. Cause 2: Poor signal due to loose connections between system wires or poor contact in the ABS relay, leading to system failure. Solution: Check wire connections and reconnect any loose parts. Condition 2: ABS warning light intermittently comes on but turns off when accelerating. Cause: When multiple vehicle electrical devices are in use, the battery voltage drops below 10.5V. The ABS warning light turns off as the engine speed increases and voltage rises. The ABS system power supply voltage is too low, possibly due to poor terminal contact or grounding issues. Solution: Check the battery's specific gravity, inspect the charging system, and examine the power supply (e.g., voltage relay or poor power contact). Condition 3: ABS warning light stays on after engine start until the engine is turned off (IGFF). Cause: Poor grounding contact in the ABS hydraulic valve body; poor contact in the ABS hydraulic valve body wiring connector; ABS control unit failure. Solution: Loosen and retighten the hydraulic valve body grounding screw, cleaning the contact surface if necessary; check if the connector gap has widened; replace the ABS or ABS/ASR control unit. Condition 4: ABS warning light comes on during high-speed driving. Cause: During high-speed driving, the ABS control unit detects a significant difference between the rear and front wheel speed signals; incorrect tire or wheel rim specifications. Solution: Refer to the vehicle's tire and wheel rim specifications, as indicated on the label near the fuel tank cap. Condition 5: ABS warning light intermittently comes on. Cause: Improper adjustment of the brake light switch; poor internal contact in the brake light. Solution: With the engine running, press the brake pedal and push the brake switch linkage down fully with your fingers, then release the brake pedal to complete self-positioning; replace the brake light switch if necessary. If the ABS warning light is on, it is recommended not to continue driving. The illuminated ABS light indicates a fault in the vehicle's anti-lock braking system. During emergency braking, if the wheels lock up, the vehicle may skid uncontrollably, preventing the driver from slowing down or adjusting the vehicle's trajectory, posing significant safety risks.
4
2
Share

Can the car door be closed gently?

Not necessarily, it varies from car to car. Introduction: Generally, German car doors require more force to close, while Japanese cars are more gentle like the Corolla, but there are exceptions. For example, the Civic's door requires more force to close. Some modern car designs even eliminate the need for deliberate door closing. For instance, the Roewe 550 features a vibration return system where simply initiating the closing motion will automatically close the door. Solution: When exiting the vehicle and closing the door, gently push the door to about ten centimeters from the car body before completing the closing action - this is the most effective method. If you encounter someone closing doors roughly, seriously remind them to be gentle and not 'hurt' the car. After all, the car owner is the one who feels the pain most. Always remember to close doors gently - it's a sign of respect for both the vehicle and its owner.
17
4
Share

Where is the exhaust valve located on the BMW X5?

The exhaust valve of the BMW X5 is located on the valve cover. Introduction to the exhaust valve: The exhaust valve, also known as the oil separator or pressure control valve, is installed between the compressor outlet and the condenser inlet. Through separation, it improves the heat transfer efficiency of the condenser and evaporator. Working principle of the exhaust valve: The high-pressure gas from the compressor enters the exhaust valve and then flows through the guide vanes in a spiral motion. The centrifugal force and gravity separate the lubricating oil from the working gas, which flows down along the inner wall of the cylinder. The working gas is then discharged from the exhaust valve through the central pipe via multiple baffles. The separated lubricating oil accumulates at the bottom of the oil separator and can be periodically drained or automatically returned to the compressor's crankcase using a float valve.
10
5
Share

How is the interior of the Audi Q5?

Audi Q5's interior craftsmanship is excellent, with high-quality materials used throughout. The overall design is full of technological sophistication, and the configurations are highly practical. Audi Q5 dimensions: The Audi Q5 has a body length, width, and height of 4629mm × 1898mm × 1655mm, with a wheelbase of 2807mm. Audi Q5 powertrain: Equipped with a 2.0T four-cylinder inline engine paired with a 7-speed Stronic dual-clutch transmission, the power output is ample, gear shifts are smooth, acceleration is quick, and it delivers a noticeable push-back sensation. Audi Q5 exterior: The Audi Q5 features a distinctive large grille front face, with an overall stylish and attractive design. The body lines are sleek and fluid.
9
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.