Should a Newly Purchased Battery Be Charged?

1 Answers
Gatsby
07/29/25 3:42pm
If the new battery was produced within the last half month and has not been used, it can be directly used without charging. If the new battery was produced a long time ago or has been used, it is advisable to charge it before use. For dry-charged lead-acid batteries, according to the user manual, if stored for no more than two years, you only need to add the specified density of electrolyte and let it sit for 15 minutes before use—no charging is required. Here are some battery-related tips: 1. Develop good in-car electricity habits. Avoid listening to the radio at high volume, charging your phone, or using air pumps when the engine is off. 2. Regularly drive on highways for long distances. This has many benefits, including removing carbon deposits from the vehicle and ensuring the battery is fully charged.
Was this review help?
4
4
Share
More Forum Discussions

Will water ingress in the turn signal affect its use?

Water ingress in the turn signal will affect its use, and it is recommended to repair it promptly. Below is relevant information about automotive turn signals: 1. Introduction: The automotive turn signal electronic flasher is a flashing device used to indicate changes in the direction of the vehicle. It features a new circuit design, consisting of a low-voltage switch circuit, high-voltage switch circuit, pulse generation circuit, dual-transistor output circuit, and two sets of light indicator circuits. Installed within the flasher housing, it accurately indicates the vehicle's direction through its control, with the added feature of automatic protection. In the event of a short circuit, it automatically stops the flasher and bulb operation. The driver can monitor the flasher's working condition via a fault indicator on the flasher, allowing for timely detection and troubleshooting. 2. Mechanical steering gear inspection: Check for wear and damage on the pinion and rack, and inspect the steering gear housing for cracks. Note that parts on the steering gear must not be welded or straightened; they can only be replaced. Also, examine the wear and damage of bearings and bushings, as well as the wear and aging of oil seals and dust boots, and replace them as necessary.
13
3
Share

What is the power configuration of the Geely Icon?

The power configuration of the Geely Icon is a 1.5-liter turbocharged engine, with a maximum horsepower of 177ps, a maximum power of 130kw, and a maximum torque of 255nm, paired with a 6-speed automatic transmission. Taking the 2020 Geely Icon as an example, its body dimensions are: length 4350mm, width 1810mm, height 1615mm, with a wheelbase of 2640mm and a fuel tank capacity of 51l. The 2020 Geely Icon features front-wheel drive, with a front suspension of MacPherson independent suspension and a rear suspension of multi-link independent suspension.
10
1
Share

How to adjust the air conditioning in the Changan Eado?

To adjust the air conditioning in the Changan Eado, follow these steps: 1. Enter the car and locate the air conditioning control area in the center. The A/C button is the air conditioning cooling switch, and the MAX A/C button maximizes cooling. 2. The left knob adjusts the temperature, while the right knob controls the air volume. 3. The "AUTO" button turns on the automatic air conditioning. Press the car icon button to activate the internal circulation when needed. 4. Use the defogging function when the front windshield fogs up, and activate the rear windshield heating in rainy weather.
19
1
Share

Is the 2019 Corolla a Three-Cylinder or Four-Cylinder?

The 2019 Corolla lineup exclusively uses four-cylinder engines. Here are some details about the 2019 Corolla's engines: 1. This model was available in both gasoline and hybrid versions. The gasoline version is equipped with a 1.2T turbocharged engine, while the hybrid version uses a 1.8L naturally aspirated engine. 2. There isn't a significant difference in performance between three-cylinder and four-cylinder engines, mainly just structural differences. Compared to a four-cylinder engine, a three-cylinder engine has one less cylinder.
9
3
Share

What does 200cc and 400cc mean?

200cc and 400cc refer to the displacement of motorcycles. 200cc means a displacement of 200 milliliters, while 400cc means a displacement of 400 milliliters. The difference between the two is that 400cc has a larger displacement than 200cc, and the engine power, performance, and fuel consumption of 400cc are all greater than those of 200cc. The differences between car displacements of 1.5T and 1.6T are as follows: 1. Different nature: 1.6L is a displacement of 1.6 liters, where L stands for long, and 1.6T is a 1.6L engine with turbocharging; 2. Different fuel consumption: 1.6L has lower fuel consumption; 3. Different power: 1.6T has greater power and performance; typically, a turbo can increase the base power by about 10%-30%, and some can even exceed 50%. 1.6T can deliver greater power and torque, even comparable to a 2.4L naturally aspirated engine; 4. Different maintenance costs: 1.6T has higher maintenance costs. The difference between 1.6L and 1.6T is that 1.6T comes with a turbocharger, resulting in lower fuel consumption, greater power, and relatively higher maintenance costs compared to 1.6L.
2
0
Share

Will the car shake badly if the shock absorbers are too soft?

Yes, if the shock absorbers are too soft, the car will shake up and down significantly. Here is the relevant information: 1. Car Suspension: The damping system of a car's suspension is similar to the shock absorbers on a mountain bike, with the same basic principle. The damping effect depends on the size of the damping force. A suspension with high damping (large damping force) is too stiff, providing strong support. When driving over bumpy roads like small mounds, the car won't experience significant rigid impacts, but it will feel slight bumps on small potholes. Conversely, a suspension with low damping (small damping force) is too soft, producing the opposite effect. Traditional suspensions adopt a design principle that balances both damping and support but cannot optimize both performances simultaneously. 2. Magic Carpet Suspension: This technology has obtained 20 patents, does not require electric drive, and does not add extra energy consumption. The new technology adds a progressive hydraulic buffer at both the upper and lower ends of each shock absorber, allowing the car to adjust its damping according to road conditions, ensuring comfort under different road conditions. The PHC adaptive hydraulic stabilization technology enables the suspension to switch to a low damping range on relatively smooth roads (minor bumps), greatly reducing the bumpy feeling. On severely bumpy roads (major bumps), the suspension can increase its damping force, effectively absorbing mechanical energy and avoiding discomfort caused by rigid impacts, achieving damping effects and thereby realizing the magic carpet effect.
3
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.