···
Log in / Register

Reasons for slight shaking during car idling?

5 Answers
AlexaLee
07/25/2025, 12:00 AM

Reasons for slight shaking during car idling: 1. Poor ignition system performance, suboptimal spark plug firing; 2. Unstable oil pressure; 3. Aging engine components or worn engine mounts; 4. Severe engine carbon buildup, dirty throttle body, or excessive fuel injector deposits. Solutions for slight shaking during car idling: 1. Clean the fuel system and check if the idle control valve has carbon deposits that need cleaning; 2. Inspect spark plugs for excessive carbon buildup and replace if necessary; 3. Check oil pressure and replace components when needed; 4. Replace engine rubber components and consider an engine overhaul if appropriate; 5. Perform wheel alignment and dynamic balancing.

Was this review help?
4
4
Share
KaydenAnn
08/11/2025, 08:11 AM

My old car shakes a bit at idle, which is a pretty common issue. Often, it's due to worn-out spark plugs, where long-term use leads to carbon buildup causing uneven ignition. It could also be a problem with the ignition coil; unstable electricity supply from the coil can make the engine run rough. Carbon buildup in the throttle body is another key factor—when it's dirty, it causes uneven air intake, leading to shaking. Additionally, aging engine or transmission mounts can harden and crack over time, allowing vibrations to come through at idle. Misfiring is another reason; if one cylinder isn't working properly, the whole engine becomes unbalanced. It's best to start by checking the spark plugs and throttle body, cleaning or replacing them if necessary. If the problem persists, take it to a repair shop to inspect the mounts. Regular maintenance is crucial—idling rough not only increases fuel consumption over time but also risks sudden stalling on the road. Safety first.

Was this review help?
13
1
Share
Expand All
DeLucia
09/26/2025, 11:37 PM

There are quite a few reasons for idle vibration. Based on my experience repairing cars several times, it could be due to worn spark plugs or incorrect gaps, causing delayed ignition and unstable operation. Clogged fuel injectors are also common, leading to uneven fuel spray and poor combustion. A dirty air filter can affect air intake, causing the engine to not get enough air and resulting in vibration. Issues like insufficient fuel pump pressure or poor fuel quality can also cause shaking, especially after filling up with contaminated fuel. If the vibration is accompanied by unusual noises, it might be due to cracked or aged engine mount rubbers, reducing their damping effect. It's advisable to start with simple checks, like replacing spark plugs or cleaning fuel injectors. If that doesn't work, use a professional diagnostic tool to read the fault codes. Prolonged driving with vibration can accelerate part wear, waste fuel, and damage the car, so addressing it early saves both hassle and money.

Was this review help?
13
3
Share
Expand All
LeFrancisco
11/10/2025, 12:37 AM

Most cases of car idle shaking are due to carbon deposits buildup. Dirty components like the throttle body or intake manifold can disrupt airflow, leading to uneven fuel mixture combustion and unstable operation. Worn-out spark plugs are another major cause - broken filaments or poor insulation may result in ignition failure. Clogged fuel injection systems causing uneven fuel supply can also create engine vibration. If engine mounts are cracked or worn, their shock absorption capability decreases, amplifying the shaking. Simple self-check: Listen for smooth engine sound during startup and feel the steering wheel vibration level. If frequent occurrences are noticed, prompt repair is recommended to prevent worsening issues. Unstable idling may lead to stalling risks, especially in traffic congestion which increases collision probability.

Was this review help?
17
2
Share
Expand All
McValerie
12/31/2025, 02:22 AM

The causes of slight idle shaking usually focus on several aspects. Issues in the ignition system, such as damaged spark plugs or faulty ignition coils, can lead to unstable voltage and engine vibration. Problems in the air and fuel systems, like carbon buildup in the throttle body causing it to stick and operate inflexibly, result in fluctuating air intake. Clogged fuel injectors causing uneven fuel spraying are also common factors. Aging and hardening of the engine or transmission support structures can fail to effectively dampen vibrations. Other causes include engine cylinder pressure imbalance or misfiring. Although the shaking may seem minor, the hidden risks are significant, potentially accelerating component wear, increasing fuel consumption, or even causing the engine to stall. Regular maintenance is key, with checks on support mounts every two years and spark plug replacements to prevent issues. If detected, prompt repairs are essential to ensure safe and reliable driving.

Was this review help?
19
3
Share
Expand All
More Forum Discussions

What is the method to reset the maintenance light on the Great Wall H6?

The method to reset the maintenance light on the Great Wall H6: 1. Insert the key and keep the engine off; 2. Press the reset button once to display the system that needs to be reset, and each press will switch to the next system; 3. Select the system the owner needs to reset and hold the reset button for about 3 seconds; 4. The multifunction display on the instrument panel shows the relevant icon, indicating the maintenance light has been successfully reset. Taking the 2021 Haval H6 as an example, its body dimensions are: length 4615mm, width 1860mm, height 1720mm, wheelbase 2680mm, minimum ground clearance 182mm, and body weight 1675kg. In terms of suspension, the 2021 Haval H6 has a front MacPherson independent suspension and a rear double-wishbone independent suspension.
17
3
Share

Where is the cabin air filter located in the old Buick LaCrosse?

The cabin air filter in the old Buick LaCrosse is located under the trim panel beneath the right front wiper blade. Steps to replace the cabin air filter in the old LaCrosse: 1. Remove the seal strip under the passenger-side wiper, then detach the plastic clips and take off the wiper cover panel; 2. Remove the cabin air filter cover to access the filter; 3. Take out the old filter and install the new one; 4. Reassemble the cabin air filter cover, wiper cover panel, seal strip, and plastic clips in their original positions. The Buick LaCrosse is a mid-size sedan under SAIC-GM Buick. Taking the 2013 LaCrosse eAssist 2.4L Energy-Saving Comfort model as an example, its powertrain is equipped with a 2.4L inline-four naturally aspirated engine, delivering a maximum power of 137kW and a maximum torque of 240Nm, paired with a 6-speed automatic transmission.
4
0
Share

What is the solution for the increased engine oil issue in Dongfeng Honda CR-V?

The solutions for the increased engine oil issue in Honda CR-V are as follows: 1. FI-ECU software upgrade. 2. Replacement of the air conditioning control unit. 3. TCU software upgrade, applicable only to CVT models. 4. Replacement of the radiator lower hose assembly, applicable only to CVT models. Below is an introduction about the CR-V: (1) Advantages: Stylish and dynamic appearance with smooth lines, maintaining a sporty feel while being rounded; improved materials and craftsmanship, good configuration, powerful performance, flexible handling, and relatively high cost performance. (2) Space: Overall spacious and ample driving and riding space, with no obvious tightness in head and legroom; abundant and practical storage space inside the car; seats are well-wrapped and quite comfortable, with the rear seats being slightly adjustable, making them more practical for long-distance travel. (3) Control: Comfortable and flexible control, clear gear positions, smooth gear shifting, with a sedan-like driving experience; responsive throttle, good steering wheel feel, though the steering is not very precise; wide tires provide good grip, and the chassis is solid, but the ground clearance is small, resulting in poor passability; the suspension is too soft, leading to subpar high-speed stability. (4) Power: Equipped with recalibrated 2.0 and 2.4 displacement engines. The 2.4 displacement offers ample power, quick acceleration, and easy overtaking. The 2.0 displacement is weaker, with slower acceleration from a standstill. (5) Interior: The interior adopts Honda's family style, with a dual-tone design that is warm and clean; the three-spoke steering wheel feels good, and the configuration is practical, with improved materials and craftsmanship. (6) Fuel consumption: Dongfeng Honda CR-V has relatively good fuel economy, with an average fuel consumption of around 10L per 100 kilometers.
3
0
Share

What is the total weight of the Magotan?

The total weight of the Magotan varies depending on the model. Taking the 2020 Magotan as an example, the total weights are 1445kg, 1540kg, and 1580kg respectively. The Magotan is a mid-size car under FAW-Volkswagen. For instance, the 2020 Magotan 280TSI DSG Comfort model has dimensions of 4865mm in length, 1832mm in width, and 1471mm in height, with a wheelbase of 2871mm. The body adopts a 4-door, 5-seat sedan structure. In terms of power, the 2020 Magotan 280TSI DSG Comfort is equipped with a 1.4L inline 4-cylinder turbocharged engine, delivering a maximum power of 110kW and a maximum torque of 250Nm, paired with a 7-speed dual-clutch transmission.
15
5
Share

What is the ultimate trick for maintaining 30cm distance during reverse parking in Subject 2?

Subject 2 reverse parking 30cm viewing trick is to master the distance and angle between the vehicle and the parking spot corner. Concept of Subject 2: Subject 2, also known as the small road test, is part of the motor vehicle driver's license assessment. It refers to the field driving skill examination, with five mandatory test items for small vehicles (C1/C2): reverse parking, parallel parking, hill start and stop, right-angle turn, and curve driving (commonly known as S-turn). Subject 2 reverse parking techniques: When the parking area line is parallel with your shoulder, turn the steering wheel one full turn to the right. When the root of the left rearview mirror aligns with the edge of the yellow zone line, turn the steering wheel two full turns to the left. After straightening the vehicle, return the wheels to the right. When the lower edge of the left rearview mirror exceeds the parking area boundary line, stop—the wheels should be approximately in this position within the yellow zone. Shift into reverse gear. When the lower edge of the left rearview mirror reaches the parking area boundary line, turn the steering wheel one and a half turns to the right. Observe the right rearview mirror—when the distance between the parking spot corner and the vehicle body is about 30cm, turn the steering wheel one full turn to the left. Once the parking spot corner disappears, turn the steering wheel fully to the right. If the distance between the vehicle body and the parking spot corner exceeds 30cm, turn the steering wheel fully to the right immediately. When the vehicle body is parallel with the parking area boundary line, straighten the wheels. Stop when the lower edge of the left rearview mirror reaches the white boundary line. After completing left reverse parking, perform a third exit by executing a right exit, following the same method as the left exit, and then leave the testing area directly.
15
2
Share

How to Remove and Install the Cabin Air Filter in a Cadillac ATS?

Method for removing and installing the cabin air filter in a Cadillac ATS: 1. Open the glove box; 2. Remove the central fixing screw on the upper wall of the glove box; 3. Pull out the upper box of the glove box; 4. At this point, the plastic cover of the cabin air filter becomes visible; 5. Unfasten the four clips of the plastic cover to remove it; 6. After removing the cover, the cabin air filter is exposed; 7. Replace the filter and reinstall it by reversing the steps. The Cadillac ATS is a mid-size sedan under SAIC-GM-Cadillac. Taking the 2017 Cadillac ATS 28T Technology model as an example, it measures 4730mm in length, 1824mm in width, and 1426mm in height, with a wheelbase of 2860mm. The body adopts a 4-door, 5-seat sedan structure. Its powertrain is equipped with a 2.0L inline 4-cylinder turbocharged engine, delivering a maximum power of 205kW and a maximum torque of 400Nm, paired with an 8-speed automatic transmission.
6
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.