···
Log in / Register

Reasons for Car Shaking in First Gear

1 Answers
CharlesFitz
07/24/25 11:51pm

Reasons for car shaking in first gear: Excessive wear of the clutch pressure plate. Solution for car shaking in first gear: Replace the clutch press at a repair shop or 4S store. More information about the clutch pressure plate is as follows: 1. The clutch pressure plate is an important structure on the clutch, which plays a significant role in driving safety. 2. The widely used type is the spring-loaded friction clutch (referred to as friction clutch). The torque generated by the engine is transmitted to the driven plate through the friction between the flywheel, pressure plate, and the contact surface of the driven plate. When the driver presses the clutch pedal, the diaphragm spring's large end moves the pressure plate backward through mechanical transmission, separating the driven part from the driving part.

Was this review help?
14
3
Share
More Forum Discussions

How much weight can a Corolla trunk hold?

The maximum volume of the Corolla is 452 liters, and the trunk can hold approximately 450 kilograms. The function of the trunk: The trunk of a car, as the name suggests, is the area for storing spare items and carrying goods. Trunks vary in size: Since small cars come in hatchback and sedan versions, the trunks also vary in size. Generally, a trunk contains the car's spare tire, emergency kit, tool kit, warning triangle, fire extinguisher, car refrigerator, and the emergency release cable for the fuel tank cap. Some high-end models also have the starter battery located in the trunk.
2
2
Share

Do You Need to Depress the Clutch When Turning Off the Car?

You need to depress the clutch when turning off the car. Here is a detailed introduction about the car clutch: 1. Overview: The car clutch is located inside the flywheel housing between the engine and the transmission, with the output shaft of the clutch being the input shaft of the transmission. During driving, the driver can press or release the clutch pedal as needed to temporarily separate or gradually engage the engine and the transmission, thereby cutting off or transmitting the power from the engine to the transmission. 2. Principle: The driving and driven parts of the clutch transmit torque through friction between contact surfaces, using liquid as a transmission medium, or magnetic transmission (electromagnetic clutch), allowing temporary separation and gradual engagement, while permitting mutual rotation between the two parts during transmission.
3
5
Share

Why does the car make a squeaking noise when the air conditioner is turned on?

The reasons for the squeaking noise when the car air conditioner is turned on are as follows: 1. Refrigerant moisture causing squeaking: Abnormal noises inside the air conditioner are often caused by moisture or air in the system refrigerant, which can be appropriately released. The compressor has high requirements for the electromagnetic clutch. Moreover, the electromagnetic clutch is installed close to the ground and frequently comes into contact with rainwater and mud. When the bearing in the electromagnetic clutch fails, it can produce abnormal noises. 2. Compressor drive belt: The tension of the compressor drive belt may also cause abnormal noises from the car air conditioner compressor. If the drive belt is too tight, the load on the electromagnetic clutch will increase.
2
4
Share

How Many Car Washes Will Remove Car Wax?

After three car washes, the car wax will be completely removed, which takes about a month. Here are the details: 1. Waxing: When waxing a vehicle, it needs to be cleaned thoroughly, and the wax should be applied evenly. The area to be waxed at one time should not be too large, and the time should not be too long. 2. Waxing Frequency: It is recommended to wax every two months. New cars do not need waxing within six months of purchase because they come with a protective wax layer from the factory. Waxing too early will remove this protective layer. Proper waxing intervals can maintain the cleanliness of the car's paint and extend its lifespan.
3
5
Share

How to Drive the T-Roc?

The driving method of the T-Roc: The T-Roc is an automatic transmission vehicle. After starting the engine, press the brake pedal, shift the gear to D, and release the handbrake. The T-Roc has five gear positions: P, R, N, D, and S, representing Parking, Reverse, Neutral, Drive, and Sport mode respectively. The T-Roc is FAW-Volkswagen's first SUV product. Compared to the overseas version, its wheelbase has been increased by 77mm, positioning it as a compact SUV. Its body dimensions are 4318mm in length, 1819mm in width, 1582mm in height, with a wheelbase of 2680mm.
18
0
Share

How to Resolve Vehicle Malfunctions with a 4S Store for a New Car?

There are primarily the following methods to resolve malfunctions in a new car with a 4S store: 1. Negotiation: Generally, if the malfunction is caused by objective reasons, it is usually a quality issue from the manufacturer. In this case, the car owner can directly approach the 4S store to explain the situation and negotiate for repairs or a vehicle replacement. 2. Complaint Handling: If obstacles are encountered during the negotiation process, the car owner can call the manufacturer's after-sales service hotline to request resolution and report the situation. Of course, the car owner needs to provide relevant evidence of the vehicle's quality issues to facilitate the protection of their rights.
13
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.