No response when pressing the ignition switch on Magotan?
2 Answers
Solutions for no response when pressing the ignition switch on Magotan are as follows: 1. Check whether the wiring terminals on the positive and negative electrode posts of the battery are in good condition. If normal, turn on the emergency hazard lights while starting the motor. If the brightness of the hazard warning lights on the instrument panel weakens, the flashing frequency slows down, or the hazard lights stop working, it indicates that the battery has insufficient charge and cannot provide the working voltage required by the starter motor. In this case, seek assistance from an automotive repair professional. 2. If the brightness and frequency of the hazard warning lights on the instrument panel remain unchanged, it is more likely that the problem lies with the starter motor. In most cases, this is caused by worn carbon brushes in the starter motor. At this point, use a long-handled screwdriver or tire wrench from the car's toolkit to tap the starter motor or nearby areas a few times. This allows the carbon brush springs in the starter motor to press the carbon brushes onto the rotor electrodes under external vibration. After tapping a few times, try starting the motor again, and it will usually succeed. 3. If this fails, except for automatic transmission vehicles which require on-site assistance from a repair professional, manual transmission vehicles can consider using the push-start method to start the engine if the driver is skilled and has at least two helpers.
I had the same issue last time I drove my brother's Magotan. Pressing the ignition switch gave no response at all—it was really frustrating. Later, I found out the battery terminal was loose, and tightening it myself fixed the problem. There are many possible causes, with insufficient battery charge being the most common. First, check if the dashboard lights come on; if not, the battery is likely dead or severely corroded. A faulty starter or relay could also leave the engine silent—listen for a clicking sound. If the dashboard lights are on but the engine won’t start, the ignition switch itself might be broken or there could be poor wiring contact. A blown fuse could also be the culprit. Try turning on the headlights or radio to test the electrical system; if they work, you can rule out battery issues. Don’t force it—tow it to a repair shop for a thorough inspection. Safety first. Regular maintenance includes checking battery terminals and charge levels to prevent minor issues from turning into major repairs.
