Must traffic violation points be cleared before the annual vehicle inspection?

1 Answers
LeFernando
07/29/25 5:56pm
Traffic violation points must be cleared before the annual vehicle inspection. Before the annual inspection, all traffic violations must be settled to pass the inspection. The procedures for exemption from inspection and the required documents for the annual inspection are as follows: Procedures for exemption from inspection: For household vehicles with seven seats or less, an exemption from on-site inspection is available within the first six years, provided there are no records of major traffic accidents during this period. After all violations are cleared, only a copy of the valid compulsory traffic insurance policy (the original is also acceptable) and the vehicle registration certificate need to be submitted to the local vehicle management office every two years to apply for the annual inspection sticker. Remember, this is an exemption from on-site inspection, not from inspection altogether. The procedure must still be completed every two years. Required documents for annual inspection: Before the annual review, confirm all violation records and ensure all fines are paid. For the annual inspection, prepare the original vehicle registration certificate, a copy of the compulsory traffic insurance policy, and a copy of the ID card.
Was this review help?
12
4
Share
More Forum Discussions

What is the fuel tank capacity of the GL8 in liters?

The fuel tank capacity of the GL8 is 70 liters, as officially announced. GL8 owners can also verify this information on their vehicle's specification sheet. The GL8 requires 95-octane gasoline, with a fuel consumption of 9.8L per 100 kilometers. A full tank allows for a driving range of approximately 714 kilometers. During daily driving, it is essential to monitor the remaining fuel level in the tank. This is typically done by observing the fuel gauge inside the vehicle. Under normal circumstances, the fuel gauge accurately reflects the remaining fuel. The fuel gauge usually has 5 to 6 segments, and it is advisable to refuel when only 2 segments remain to avoid running out of fuel mid-journey. During actual refueling, the amount of fuel added may exceed the nominal tank capacity. This is because the manufacturer's specified tank capacity is measured from the bottom of the tank to the safety limit. There is additional space from the safety limit to the tank opening, designed to accommodate fuel expansion due to temperature increases without causing overflow. If fuel is filled up to the tank opening during refueling, the actual amount of fuel added may exceed the nominal tank capacity.
7
4
Share

Is the line 'on' or is the 'O' 'on'?

Generally speaking, the horizontal line on a switch represents 'on', while the circle 'O' represents 'off'. Origin of the switch symbols: It is said that this convention dates back to World War II, evolving from the basic definitions of binary 1 and 0. The circle represents an open circuit, i.e., the 'off' state, while the vertical or horizontal line represents a closed circuit, i.e., the 'on' state. After decades of application and evolution, these symbols have now become internationally recognized power switch indicators widely used in production and daily life. Advantages of the switch line: The switch line usually has a glow-in-the-dark feature, making it easier to locate the switch in the dark at night. Typically, the horizontal line is positioned at the top of the switch panel, where pressing down turns it off, and pressing up turns it on.
5
0
Share

What is the function of a steam turbine turning gear?

The functions of a steam turbine turning gear are as follows: 1. Lubrication: It establishes an oil film lubrication on all bearings of the steam turbine to reduce dry or semi-dry friction between the journal and the bearing bush, protecting the journal from damage. 2. Heat dissipation: While ensuring uniform heating or cooling of the rotor, it enhances the stirring effect of the rotor on the steam inside the cylinder, reducing the temperature difference between the upper and lower cylinders and the resulting thermal deformation and thermal stress. However, the disadvantage of high-speed turning gear is the large starting torque. To reduce the torque, a jacking oil system is usually employed. 3. Impact reduction: During turbine startup, it can reduce the rotor's inertia and the impact force on the blades. During major overhauls, the turning gear can also be used for machining operations such as turning the exciter brush slip rings.
15
3
Share

How to reset the tire pressure warning light on Wuling Journey?

The steps to reset the tire pressure warning light on Wuling Journey are: Firmly press the brake pedal to prepare for activating the vehicle's power. Press the one-touch start button. The dashboard will light up, indicating full vehicle power is activated. Inflate all four tires to the standard pressure. Press and hold the tire pressure warning light reset button for 3 seconds. What to do when tire pressure is low: If no visible damage is found on the tires, simply inflate them to normal pressure and reset the tire pressure system. If inspection reveals a punctured tire, drive to a repair shop for patching before reinflating. If the low-pressure warning reappears after inflation without any punctures, it may indicate air leakage due to wheel rim deformation - check and replace the rim if necessary.
3
4
Share

What are the reasons for the Buick GL8 alarm going off for no reason?

The reasons for the Buick GL8 alarm going off for no reason are as follows: Trigger sensitivity is too high: This is one of the common reasons why car alarms go off for no reason. The alarm will activate even with slight vibrations or in relatively quiet environments. If the alarm is too sensitive, you can adjust the knob on the anti-theft vibration sensor. Car door not properly closed: Not only the doors but also the engine hood or the trunk—if any of these components are not properly closed, the car alarm will activate. If not addressed promptly, the alarm will continue to sound until the car battery is drained. Controller malfunction: If the alarm controller malfunctions, such as due to a short circuit, the alarm will also activate. In this case, it is necessary to promptly visit a repair shop or a 4S store for maintenance.
4
4
Share

Do Japanese Cars Have Particulate Filters?

Not all Japanese cars are equipped with particulate filters. Most Japanese cars do not have particulate filters installed because these Japanese engines use natural aspiration, and their exhaust emissions are not highly polluting. However, a small number of vehicles do have particulate filters installed, particularly for those with higher emission levels. A particulate filter is a ceramic filter installed in the exhaust system of diesel engines, designed to capture particulate emissions before they enter the atmosphere. It can reduce the soot produced by diesel engines by more than 90%, and the captured particulate matter is subsequently burned off during vehicle operation. How a particulate filter works: The diesel particulate filter is coated with metals such as platinum, rhodium, and palladium. The black smoke containing carbon particles emitted by the diesel engine enters the particulate filter through a dedicated pipe. The densely arranged bag-type filters inside capture the carbon particles on a metal fiber felt filter. When the accumulated particulate matter reaches a certain level, the burner at the end automatically ignites, burning off the captured carbon particles and converting them into harmless carbon dioxide. To check if a Japanese car has a particulate filter, you can use the following three methods: 1. Refer to the and to see if there is a particulate filter function. Additionally, carefully check the fault codes in the manual to see if there is a "particulate filter" warning light indicator. 2. Check the label on the oil filler cap. If the cap clearly indicates the use of 0W-20 grade oil, it means the vehicle is equipped with a particulate filter. 3. Look at the exhaust pipe behind the three-way catalytic converter to see if there is an additional cylindrical section. If present, that is the particulate filter.
1
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.