Method for Replacing the Headlight Assembly of Besturn B70

[DiMadelyn]

Steps for replacing the headlight assembly of Besturn B70: 1. Removal of the front bumper: First, prop up the engine compartment cover. Use a Phillips screwdriver to remove the fixing screws on both sides of the grille, and use a flathead screwdriver to loosen and pull out the plastic screws in the middle of the grille. 2. Removal of the side screws of the bumper: Use a flathead screwdriver to assist in prying open the inner fender liner near the tires, exposing the fixing screws on the sides of the bumper. Use a Phillips screwdriver to loosen these screws. Once both sides are loosened, proceed to remove the fixing screws underneath the car chassis. 3. Removal of the fixing screws under the chassis: The working space under the car chassis is low and narrow. Use the car's onboard tools and a jack to support the front wheels. Lay cardboard on the ground in front of the car to facilitate working under the chassis. The exact position of the screws can be removed using an M10 Torx or open-end wrench or a Phillips screwdriver, allowing the entire front bumper to be removed. 4. Removal of the fog light connector: Since the front fog lights are still connected to the bumper, if the fog light connector wires are long enough, the front bumper can be loosened and placed on the ground. If the fog light connector needs to be removed, simply twist it at an angle to release it. 5. Removal of the headlight: There are a total of 3 fixing screws for the headlight bracket—two on top and one at the bottom. Use an M10 open-end wrench to loosen the headlight bracket bolts. Then, unplug the 4 connectors on the headlight assembly by pressing the plastic clips to easily remove the connectors. 6. Installation of the new headlight assembly: Since the 4 connectors on the headlight assembly are different, simply align them with the sockets and press them in firmly. New headlight assemblies usually come with bulbs. If you have better bulbs, remove the waterproof cover of the bulb by twisting it counterclockwise with an adjustable wrench to replace the bulb. 7. Test installation of the front bumper: Install the front bumper in place, check all connectors for reliability, and conduct a test run.