Is there someone sitting in the back during the Subject 3 driving test?

1 Answers
Alexandra
07/30/25 7:16am
There are people sitting in the back during the Subject 3 driving test. Usually, a safety officer accompanies three to four candidates who take turns for the test. This means one candidate sits in the driver's seat, the safety officer sits in the front passenger seat, and the remaining candidates wait in the back seat for their turn. Additional information: I. Precautions for the Subject 3 driving test: 1. Simulated lighting: Listen to the voice commands for simulated lighting and operate only after the instruction is fully read. 2. Starting mnemonic: One press (clutch), two shift (gear), three horn, four turn (signal), five look (mirror), six handbrake. 3. Gear shifting: Steer slowly at low speed with gentle clutch control, shift gears decisively and apply proper throttle. 4. Turn signals: Activate the turn signal when changing lanes, look left and right without panic. 5. Pulling over: Signal, shift to second gear when pulling over, maintain speed at 15 km/h with clutch control.
Was this review help?
8
0
Share
More Forum Discussions

What are the penalties for temporary parking on the emergency lane?

Motor vehicles are not allowed to drive or park on the emergency lane on highways unless it's an emergency. Otherwise, a fine will be imposed, and 6 points will be deducted from the driver's license. If parking on the emergency lane is due to an emergency situation (such as car breakdown or sudden illness of the driver), no penalty will be imposed.
1
3
Share

How to Check Traffic Violations for Commercial Vehicles?

Visit the office halls of traffic police branches in various cities, districts, and counties to check through touch-screen query terminals. Log in to the external service websites of the Public Security Traffic Management Bureau of each city: locate the vehicle violation query section, enter the license plate number and engine number, then click to query.
9
5
Share

How to Apply for Commercial Vehicles?

First, go to the Industrial and Commercial Bureau to apply for the Pre-approval Notice of Individual Business Name, and submit the relevant materials to the relevant departments for review. Apply for the Road Business License, after review by the relevant departments, obtain the Business License. Complete the relevant tax procedures, pay the taxes, and obtain the Tax Registration Certificate; take the vehicle to the local Vehicle Management Office for registration, and obtain the Operation Certificate.
6
2
Share

How to Remove and Install the Headlight Assembly of the Excelle?

After opening the hood, there is an iron hook on the inner side of both headlights. At the back of the headlight, there is a plastic screw used to lock the headlight in place. Unscrew the two plastic screws at the back of the headlight, store them safely, then pull the iron hook outward to its limit to remove the headlight. Once the headlight is removed, you will notice it is held by the headlight wiring harness at the back, which is secured by a clip. Locate the clip, press it down, and you can then disconnect the wiring harness. After disconnecting the wiring harness, the car's headlight assembly can be completely removed.
1
2
Share

How to fix a dent in hard plastic?

You can use a lighter with aluminum foil or a hair dryer to heat the area until it softens, then push it out from the inside with your fingers. You can also use a plunger coated with Vaseline around the edges, place it over the dent, and pull hard to remove the dent.
5
5
Share

How to adjust excessive brake pedal travel?

Adjust the brake cable fixing screw using the 10mm end of a 10-12mm wrench. Tighten the brake cable adjustment screw (turn the wrench clockwise to tighten), secure it properly but avoid over-tightening to prevent damaging the screw.
7
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.