Is There Purchase Tax for Buying Chery Ant?

1 Answers
VonAlex
07/30/25 8:28am
Chery Ant is a new energy vehicle and does not require payment of vehicle purchase tax when buying. According to the relevant provisions of the "Announcement on Exempting New Energy Vehicles from Vehicle Purchase Tax": Article 3: The Ministry of Industry and Information Technology determines the vehicles exempt from vehicle purchase tax based on the "Catalog", and the tax authorities handle the tax exemption procedures accordingly. New energy vehicles do not need to pay purchase tax, but must meet the following conditions: 1. Pure electric vehicles, plug-in (including range-extended) hybrid vehicles, and fuel cell vehicles that are permitted to be sold in China. The power batteries used do not include lead-acid batteries. 2. The comprehensive fuel consumption of plug-in hybrid passenger vehicles (excluding fuel consumption converted from electricity) is less than 60% compared to the corresponding target value in the current national standard for conventional fuel consumption. 3. The comprehensive fuel consumption of plug-in hybrid commercial vehicles (excluding fuel consumption converted from electricity) is less than 60% compared to the corresponding limit value in the current national standard for conventional fuel consumption. 4. Pass the special inspection for new energy vehicles and meet the standard requirements for new energy vehicles.
Was this review help?
2
4
Share
More Forum Discussions

What are the symptoms of a faulty clutch slave cylinder?

The main symptoms of a faulty clutch slave cylinder are difficulty in disengaging the clutch when pressed or an unusually heavy pedal feel. This is particularly noticeable when shifting gears, as the clutch may not disengage completely. Additionally, there may be occasional oil leakage from the slave cylinder. Below is an introduction to the clutch system: 1. Main function of the clutch slave cylinder: Its purpose is to gradually engage the engine with the transmission, ensuring smooth vehicle starts; temporarily disconnect the engine from the transmission to facilitate gear shifting and reduce impact during shifts; and act as a separator during emergency braking to prevent overload in the transmission system, providing a certain level of protection. 2. Repair method for clutch slave cylinder oil leakage: It is recommended to replace the entire assembly. Clutch slave cylinder oil leakage is caused by wear and tear of the internal piston, sealing rings, and cups, which fail to contain the clutch fluid. Since replacement parts for the clutch slave cylinder are not readily available, repairing with new sealing rings can be challenging, making replacement of the entire assembly the preferred solution.
20
4
Share

What are the methods for detecting the paint surface of a used car?

Here are the common methods for detecting the paint surface of a used car: 1. Use the color difference between various body cover parts to make a judgment. 2. Observe whether the car's paint surface has an orange peel effect by using the reflection principle. 3. Check for sand holes or bubbles on the paint surface by close observation. 4. Determine if there is a sagging phenomenon on the paint surface through close observation. 5. Inspect whether there is overspray on the car's rubber strips and other accessories. 6. Use modern detection tools such as a paint thickness gauge to measure the car body; a reasonable and normal detection value should be between 90~120βm; some luxury vehicles may have thicknesses greater than 120.
14
3
Share

Can You Continue Driving When the Car's Water Temperature is Too High?

You cannot continue driving when the car's water temperature is too high. If you encounter a high water temperature or warning light, you can first perform a simple check and assessment yourself: 1. Immediately pull over to the side of the road, turn on your hazard lights, and place a warning triangle to alert oncoming traffic to avoid you (especially on highways). 2. Do not turn off the engine immediately. Instead, turn the heater to its maximum setting, as this can help dissipate the engine's heat. The coolant pump is driven by the engine, so turning off the engine will stop the pump, preventing the coolant from circulating and making it harder for the engine to cool down. Continue monitoring the temperature gauge, and if the temperature does not drop, then turn off the engine. 3. Open the hood and check around the engine and radiator for any leaks. If there are leaks, you should not continue driving. Also, check if the coolant level in the auxiliary tank is too low. If it is, you can add distilled water or purified water (tap water is also acceptable). If the water temperature returns to normal after adding water, you can continue driving.
10
4
Share

What Causes White Smoke from Car Exhaust in Winter?

There are two main reasons for white smoke from car exhaust: 1. Damaged cylinder head gasket: A damaged cylinder head gasket allows coolant to enter the combustion chamber. The coolant turns into steam when heated, causing white smoke from the exhaust pipe. In this case, the gasket needs to be replaced. 2. Low engine temperature: A cold engine causes water droplets to form on the walls of the combustion chamber and intake pipe, which burn together with the air-fuel mixture, resulting in white exhaust smoke. This issue can be resolved by simply increasing the car's temperature. The main pollutants in car exhaust include carbon monoxide, nitrogen oxides, hydrocarbons, lead, sulfides, etc. Under normal conditions, white smoke should not appear.
14
2
Share

How Often Should Car Brake Pads Be Replaced?

Here are the recommended times for replacing brake pads: 1. When the thickness of the brake pads wears down to less than 3mm, they should be replaced. The thickness of new brake pads is approximately 1cm, and when the wear reaches 3mm, replacement is necessary. 2. Some brake pads come with a groove, and when the wear reaches this groove, replacement is required. 3. Under normal circumstances, they should be checked every 5,000 kilometers, meaning they should be inspected during regular car maintenance. 4. If you hear a metal-on-metal grinding sound from the wheels, this indicates that the brake pads are completely worn out and must be replaced immediately. 5. Modern vehicles are equipped with warning systems; when the wear reaches a certain level, the dashboard will automatically alert you to replace the brake pads.
15
1
Share

What is the Structure and Principle of the Water Heating System?

Water heating systems mainly consist of a blower and a heater core. The principle is as follows: 1. When the heater is turned on, the high-temperature coolant from the car engine enters the heater core. At the same time, the air blown by the blower also enters the heater core, allowing warm air to be blown out through the air conditioning vents. The heater core essentially acts as a heat exchanger. 2. When using the heating function, it is crucial to follow the correct method. Incorrect usage can lead to increased fuel consumption. 3. After starting the engine in winter, do not turn on the heater immediately. Wait for 10 to 15 minutes of normal driving before activating the heater. Right after starting, the engine temperature is relatively low, and turning on the heater too soon can slow down the engine's warming process, increasing fuel consumption. 4. After a cold start in winter, the idle speed is higher than usual. This is because the engine temperature is too low, prompting the ECU to command the fuel injection system to inject more fuel, thereby speeding up the engine's warming process.
8
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.