Is there a time limit for the Subject 4 driving license test?

1 Answers
OArya
07/29/25 12:47pm
There is a time limit for the Subject 4 driving license test, with a duration of 30 minutes. The main content of the Subject 4 test includes: safe and civilized driving operation requirements, safe driving knowledge under adverse weather and complex road conditions, emergency handling methods for situations such as tire blowouts, and knowledge on handling traffic accidents. The driving license test consists of four subjects: traffic regulations and related knowledge, field driving, road driving, and safe and civilized driving. Each subject requires prior appointment before the test. Special circumstances may allow for scheduling through the driving test green channel, followed by the examination. A driving license is a legally required certification for motor vehicle drivers.
Was this review help?
2
4
Share
More Forum Discussions

Where is the tire pressure sensor located?

Tire pressure monitoring sensors are installed on the tires, usually at the valve stem position. The tire pressure monitoring display is typically placed on the center console. The central area of the center console houses many electronic devices, which may cause some interference with radio frequencies, especially from devices like electronic eyes. Tire pressure warning light: The tire pressure monitoring indicator is a yellow symbol featuring an irregular circle without a seal on top, with four small spikes at the bottom and an exclamation mark inside. When the tire pressure monitoring light illuminates, it indicates abnormal tire pressure. Abnormal tire pressure generally occurs due to the following three reasons: Abnormal tire pressure: The system typically triggers an alarm when the pressure is below 1.8 bar or above 3.0 bar. In such cases, tire inspection and pressure adjustment are necessary. Tire pressure monitoring not reset: After inflating the tires, if the tire pressure is not reset promptly, the system continues to record the previous data, causing the tire pressure monitoring light to stay on. Simply performing a tire pressure reset will resolve this issue. Damaged tire pressure sensor: The tire pressure sensor, which monitors tire pressure, is directly installed inside the tire and connected to the tire inflation valve. If the sensor is damaged due to impact while driving, it can also cause the tire pressure warning light to illuminate. For sensor damage issues, the only solution is to replace it with a new component.
14
0
Share

How to Add Refrigerant to a Car Air Conditioner?

Connect the refrigerant gauge to the air conditioning system (both high and low-pressure pipes), then proceed to evacuate the system, selecting low-pressure evacuation. Generally, there's no need to monitor the negative pressure value during evacuation. Evacuate for 3 minutes, then tighten the low-pressure gauge switch. After that, you can connect the refrigerant canister to begin the refill process.
7
1
Share

How to Change the Transmission Oil for Audi A3?

This method is a root cleaning approach, which can also clean the oil filter. Removing the oil pan is a major task, and the corresponding labor cost will increase accordingly. Loosen the bottom nut of the transmission oil pan to allow the old transmission oil to drain naturally by gravity.
4
1
Share

How to Turn on the Air Conditioning in a Lavida?

To operate the air conditioning in a Lavida, press the AC button and turn the temperature knob to the blue section. The AC button is the air conditioning switch, MAX stands for maximum, and the internal circulation can be manually turned on or off. By default, when the air conditioning is turned on to its maximum setting (or when there is a significant temperature difference between the inside and outside of the car), the internal circulation will automatically activate.
20
5
Share

How to Clear the Immediate Maintenance Reminder in Octavia?

Turn off the ignition switch, then press and hold the "0.0/SET" (reset/setting) button on the instrument panel. Turn on the ignition switch while keeping the "0.0/SET" (reset/setting) button pressed with your left hand. When the reset-related information appears on the instrument panel display, press the "0.0/SET" (reset/setting) button again to confirm.
19
4
Share

How to Deal with Yellowing White Cars?

You can opt for polishing and waxing. Make sure to go to a high-quality car detailing shop for the polishing. If the primer is yellowing, it's recommended to repaint the hood. When repainting the hood, avoid just painting the small yellowed area to prevent color differences.
7
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.