Is there a time limit for the driving test subject 2?

1 Answers
McHayden
07/24/25 8:12am
Subject 2 does not have an overall time limit, but some individual items have specified completion times. Generally, in most regions where only 5 items are tested, the exam can be completed in about 10 minutes from start to finish; for regions testing 9 items, relatively more time is needed. Some items have time limits: 1. Starting, etc.: Turning the steering wheel less than 3 seconds after turning on the turn signal before starting, turning, changing lanes, overtaking, or parking will result in failure; 2. Reverse parking: The item must be completed within 3.5 minutes, failing to complete within the specified time will result in failure; 3. Parallel parking: The item must be completed within 1.5 minutes, failing to complete within the specified time will result in failure; 4. Hill start and stop: Exceeding the specified time for starting will result in failure.
Was this review help?
9
2
Share
More Forum Discussions

What is a Width Indicator Light?

Width indicator lights are installed on vehicles to indicate the width of the vehicle, serving as a warning to other drivers and following vehicles. They are a type of commonly used light. When the width indicator light switch is turned to the first position, the small lights that illuminate at the front and rear are the width indicator lights. These lights are often found on large vehicles such as buses, coaches, and trucks, with multiple lights on each side. When lit at night, they help other drivers see the length and width of the vehicle, thereby preventing traffic accidents. When driving on the road, if you see a vehicle moving slowly, zigzagging, or with hazard lights on, it indicates that the vehicle is in need of assistance or signaling for help. Hazard lights (also known as emergency flashers) are when the turn signals flash simultaneously, serving as a warning. For example, if a vehicle breaks down and is parked on the roadside, the hazard lights should be turned on to alert passing vehicles. They are also used in special situations, such as when emergency vehicles like police cars are performing their duties.
1
1
Share

What does on-demand four-wheel drive mean?

On-demand four-wheel drive refers to a system that automatically activates four-wheel drive only when the vehicle encounters situations requiring it, otherwise operating in two-wheel drive. Automotive four-wheel drive systems are categorized into full-time four-wheel drive, part-time four-wheel drive, and on-demand four-wheel drive. On-demand four-wheel drive does not require driver intervention; once poor road conditions or wheel slippage are detected, the computer automatically assesses and immediately redistributes the engine's torque output to the front two wheels, naturally switching to four-wheel drive mode. Compared to other four-wheel drive systems, on-demand four-wheel drive has a simpler structure, effectively reducing costs and overall vehicle weight. If a certain level of off-road capability is desired while also considering fuel economy, models equipped with on-demand four-wheel drive are worth considering.
3
1
Share

What is the difference between ethanol gasoline and regular gasoline?

Ethanol gasoline and regular gasoline differ in the following aspects: 1. Different characteristics: Ethanol gasoline uses fuel ethanol as a gasoline additive, which is environmentally friendly, clean, and renewable; regular gasoline uses chemical agents such as MTBE as raw materials for gasoline additives, which causes significant environmental pollution. Many countries have successively banned the use of MTBE and other additives. 2. Different evaporation potential: Ethanol has a greater evaporation potential, approximately twice that of regular gasoline; regular gasoline has a smaller evaporation potential. 3. Different advantages: Ethanol gasoline has a lower heat value compared to regular gasoline, with only 61% of the heat value of regular gasoline, requiring more fuel to travel the same distance; regular gasoline has good adaptability, smooth and gentle operation, is convenient and labor-saving to use, is lightweight, and produces less noise.
19
3
Share

What are the advantages and disadvantages of a dual-clutch transmission?

Advantages and disadvantages of dual-clutch transmission: Advantages: 1. Direct gear shifting, minimal power loss, and low fuel consumption; 2. By alternating the work of two sets of clutches, seamless gear shifting is achieved. Disadvantages: Due to computer control, during the process of shifting gears, electronic signals need to be sent to the engine, and the gear shift can only be completed in coordination with the engine after receiving a response. The extensive use of electronic components increases the probability of malfunctions. Dual-clutch transmission, abbreviated as DCT, is commonly referred to as a dual-clutch transmission because it operates through two sets of clutches. The dual-clutch transmission is located between the engine and the transmission, serving as a transmission mechanism that can both transmit and cut off power.
15
5
Share

Where is the cabin air filter located in the Haval H5?

The cabin air filter is located outside the front windshield on the passenger side, behind the engine compartment, under a plastic cover. You just need to loosen a screw and lift the cover. Here is some additional information: 1. Replacement interval: The replacement interval for the air filter mainly depends on the external environment. Under normal conditions in China, the maintenance cycle for the vehicle's air filter is about 10,000 kilometers or every six months. However, if the vehicle is used in areas with severe smog, it is recommended to replace it every three months. 2. Cleaning method: If the filter is very dirty, use compressed air to clean it from the bottom up. The car's air conditioning system is a relatively complex system, and the cabin air filter can be considered the most important component. Its main function is to thoroughly clean dust, pollen, and bacteria from the air, which can otherwise pollute the internal parts of the air conditioning system.
16
1
Share

Where to Find the 4-digit PIN Code for an Audi Car?

The initial 4-digit PIN for an Audi is either 0000 or 1234. The PIN code is used as a password for Bluetooth connection pairing. Ways to locate the PIN code: The car's PIN code can be found in the electronic anti-theft system of the car's engine or in the vehicle's user manual. The user manual contains a confidential envelope for the engine's electronic anti-theft system PIN code, which holds the PIN code for the system. Purpose of the PIN code: The car's PIN code serves as the vehicle's password, commonly referred to as the engine electronic anti-theft system. The most notable function of the car's PIN code is to prevent theft and address issues like damage to the anti-theft converter. In such cases, repair shops can use the car's PIN code for maintenance. Thus, the car's PIN code acts as a vehicle identification number, ensuring the vehicle's security. Additionally, the car's PIN code can be used for car key programming and repairing the electronic anti-theft system.
6
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.