Is there a domestically produced Infiniti Q50?

1 Answers
LaElla
07/25/25 2:41am
There is a domestically produced version of the Infiniti Q50. Below are the detailed specifications of the Infiniti Q50: 1. The domestically produced Infiniti Q50 is a model with an extended wheelbase, known as the Q50L. 2. The domestically produced Infiniti Q50 is equipped with a 2.0-liter turbocharged engine across all variants. This engine delivers 211 horsepower and a maximum torque of 350 Nm, achieving peak power at 5,500 rpm and maximum torque between 1,500 and 3,500 rpm. It features direct fuel injection technology and utilizes an aluminum alloy cylinder head and block. The engine is paired with a 7-speed automatic transmission (7AT). 3. The Infiniti Q50L employs a double-wishbone independent suspension at the front and a multi-link independent suspension at the rear. Both front and rear suspensions are equipped with stabilizer bars, which help reduce body roll during sharp cornering, thereby enhancing the vehicle's handling and comfort.
Was this review help?
1
1
Share
More Forum Discussions

What's the matter with the battery management system failure of the Axela?

The battery management system failure of the Axela may be due to insufficient battery charge; poor or incorrect wiring connections; poor battery grounding; damaged distributor or Hall sensor; damaged ignition switch or poor wiring; damaged transistor ignition control unit or poor wiring. Introduction to the Power Battery Management System: The Power Battery Management System (BMS) typically monitors and samples real-time parameters such as individual cell voltage, total voltage, total current, and temperature, and feeds these real-time parameters back to the vehicle control unit. In addition to monitoring battery performance parameters and implementing electrical performance management, the BMS also includes environmental management primarily focused on thermal management, implementing battery heating and cooling to ensure a good operating temperature environment and uniformity of the temperature field for the battery. Hazards of Battery Management System Failure: If the power battery management system fails, it loses the ability to monitor the battery, making it difficult to estimate the battery's state of charge. This can easily lead to overcharging, over-discharging, overloading, overheating, and increased inconsistency issues, affecting the battery's performance, service life, and even driving safety.
20
2
Share

What is the difference between Tesla 3D1 and 3D6?

Tesla 3D1 and 3D6 have the following differences: Different Motors: The 3D6 has 18 more horsepower and 36N.m more torque than the 3D1. From a modification perspective, the additional 18 horsepower should provide a noticeable improvement in vehicle performance. Different Parameters: Tesla Model 3-3D1 and 3D6 represent imported and domestically produced motors, respectively. The main differences lie in the power parameters. Taking the Model 3 Standard Range Rear-Wheel Drive version as an example, the domestically produced 3D6 has a maximum power of 220kW and a maximum torque of 440N.m, while the imported 3D1 has a maximum power of 202kW and a maximum torque of 404N.m. However, the prices for these two models are the same.
2
2
Share

Why does the Haval H2 one-key start occasionally fail to start?

Haval H2 one-key start occasionally fails to start for the following reasons: Smart key low battery: This situation is most likely due to the smart key's low battery, causing the start system to fail to detect the weak signal emitted by the key. Insufficient battery voltage, dead battery, or battery damage: Failure to start may be caused by a drained battery due to reasons like leaving the headlights on for a long time or the battery reaching the end of its lifespan. Replace the battery promptly according to the maintenance manual. Not shifting to P gear when parking: For automatic transmission vehicles, the gear must be in P or N position when starting. If it's in R or D gear, the car will fail to start.
9
3
Share

What to Do When the Rear Tail Light Cover is Broken?

The method to deal with a broken rear tail light cover is to repair it with glass glue. After repair, a deep glue mark will remain, which can be covered by spray painting on the light cover. The method is as follows: prepare a masking film to cover all parts except the rear tail light cover, then spray paint 3 to 4 layers. The method to remove the rear tail light is: 1. Open the trunk lid and locate the rear tail light; 2. Lift the cover; 3. Use a wrench to remove the screws; 4. Gently pry off the headlight assembly. The classifications of rear tail light sources are: 1. Incandescent light source; 2. Light-emitting diode (LED); 3. Neon light source.
17
0
Share

What is the battery model of Haval H6?

The battery model of Haval H6 is 55D26R. The battery is an essential part of a car. Advantages of the battery: Since the battery uses lead-calcium alloy as the grid frame, the amount of water decomposition during charging is small, and the amount of water evaporation is also low. In addition, the sealed structure of the outer shell releases very little sulfuric acid gas. Therefore, compared with traditional batteries, it has the advantages of not needing to add any liquid, connecting to the terminal, and having a long power storage time. The first charge of the battery is called the initial charge, which has a great impact on the service life and charge capacity of the battery. Notes on battery charging time: If the battery is undercharged, its charge capacity will be low, and its service life will also be short. If overcharged, although the electrical performance of the battery will be good, its service life will be shortened. Therefore, new batteries should be carefully charged for the first time. For ordinary batteries, the initial charge must be performed according to the charging specifications before use. For dry-charged lead-acid batteries, according to the instruction manual, even if they need to be used within the specified two-year storage period, they can be put into use by adding electrolyte of the specified density and letting it stand for 15 minutes without charging.
2
1
Share

Why is the voice command not responding in Geely cars?

The sudden unresponsiveness of the in-car voice function is due to loose power or signal cables of the microphone. Some mobile phone music playback programs are incompatible with the docking codes of certain car models. If the phone's media audio is not turned off, it may cause signal interference with the Bluetooth function. How to activate the car's voice function: To activate the car's voice function, you can do so through the central control screen settings. Find the settings (usually represented by a gear icon) and the voice icon on the central control screen, then click to start the voice assistant. Once the voice function is activated, the car can recognize the driver's speech and execute the driver's commands. Advantages of car voice commands: While driving, using voice commands to play music can enhance the driving experience, and the owner can also show off to passengers. The introduction of voice control allows drivers to keep their hands on the steering wheel and eyes on the road, improving safety.
2
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.