Is the turn signal left down and right up?
2 Answers
Motor vehicle turn signals are left down and right up. Here is relevant knowledge about motor vehicle turn signals: Turn signal switch position: Currently, turn signal switches in small cars are usually installed on the left side of the steering wheel. Activate the turn signal in advance when preparing to turn, allowing 10-20 seconds before the turn to give following drivers sufficient reaction time. Advance signaling time: However, sometimes the duration for advance signaling should be determined based on road conditions, traffic conditions, and vehicle speed, but generally should not be less than 10 seconds. Signaling when changing lanes: Turn signals must be used when changing lanes. Develop good habits by always using turn signals when changing lanes: activate the left turn signal when changing to the left lane and the right turn signal when changing to the right lane, to alert surrounding vehicles and avoid accidents caused by negligence.
When I first got my driver's license, I wasn't very clear about the turn signal switch either. It wasn't until two years of driving that I learned the standard operation: pushing the left control lever down activates the left turn signal, while lifting it up activates the right turn signal—it's not about the physical position being lower left or upper right. This design corresponds to the steering wheel's turning direction—when turning left, the wheel turns left and the lever is pushed down; when turning right, the lever is lifted up. Getting this wrong can mislead following vehicles and cause rear-end collisions, so I always check if the signal is on before changing lanes. A common mistake beginners make is forgetting to turn off the signal after using it—the continuous clicking sound should be a reminder. Now, every time I start the car, I test the lighting system first, especially in rainy or foggy conditions with low visibility, to ensure everything is working properly for safer driving.