Is the Tharu equipped with a dry or wet dual-clutch transmission?

1 Answers
StClayton
07/30/25 7:20am
The Tharu 2.0T is paired with a 7-speed wet dual-clutch transmission codenamed DQ381; the 1.4T model uses a dry dual-clutch transmission codenamed DQ200. The wet dual-clutch transmission in the Tharu 2.0T shifts crisply and intuitively responds to the driver's intentions. During low-speed driving, there may be minimal hesitation when switching between gears 1, 2, and 3, but it has a very slight impact on comfort. The Tharu is a vehicle launched by SAIC Volkswagen, with body dimensions of 4453mm in length, 1841mm in width, and 1632mm in height, and a wheelbase of 2680mm. Its exterior design adopts the Rock Cutting design concept, featuring pronounced lines on the hood for a muscular look, wide-body dual U-shaped full LED headlights that sweep upwards, and grille bars that extend into the headlights.
Was this review help?
8
1
Share
More Forum Discussions

What Causes a Motorcycle's Center of Gravity to Lean to the Right?

Motorcycle center of gravity leaning to the right can be caused by issues with the steering ball joint tie rod or deformation of the steering column. Below are detailed explanations of the specific causes: Steering Ball Joint Tie Rod: Possible reasons include varying degrees of looseness, displacement, or deformation in components such as the steering ball joint tie rod, swing arm, shock absorber, or even the steering knuckle and bearings. These issues can lead to deviations in the front wheel toe-in and camber angles, resulting in symptoms like directional drift, shaking, or resonance during riding. It is recommended to have the front suspension checked and perform a four-wheel alignment. Steering Column Deformation: This type of fault usually occurs after a motorcycle has been dropped or involved in a collision. Most commonly, it is due to deformation of the steering column or bending of the front shock absorbers. Additionally, check if the steering column is too tight when turning, as excessive tightness can also create a sensation of drifting.
14
3
Share

What Are the Reasons for the Sudden Loss of Sound in the Envision's Audio System?

Reasons for the sudden loss of sound in the Envision's audio system: Dead battery: All electronic devices in the car are powered by the battery. If the car battery is dead, the audio system will have no sound. Loose audio plug: When the car travels on bumpy roads, the audio plug may come loose, causing the audio system to lose sound. Volume turned down or in mute mode: Simply turn up the volume or disable the mute mode on the audio system. Automatic shutdown of the audio system: If the audio system is left on for an extended period without the engine running, it will automatically shut down to prevent battery drain. Incompatible aftermarket audio system: If the owner has modified the audio system, poor quality or incompatibility may cause the audio system to lose sound. The Envision is a mid-size SUV with a 5-door, 5-seat configuration. Its dimensions are 4694mm in length, 1839mm in width, and 1686mm in height, with a wheelbase of 2750mm.
4
2
Share

How Many Cylinders Does the BMW 1000rr Have?

It features a four-stroke, inline four-cylinder, water-cooled engine with a total displacement of 999cc, delivering a maximum power of 193 hp at 13,000 rpm and a peak torque of 112 Nm at 9,750 rpm, with a top speed exceeding 300 km/h. BMW 1000rr Engine Overview: The engine itself weighs only 59.8kg, making it the lightest 1000mL four-cylinder engine currently on the market. Like all BMW motorcycle drive units, this engine is based on a meticulously designed overall concept, space-saving auxiliary device layout, and an integrated constant-mesh six-speed transmission. Four-Cylinder Engine Configuration: The four-cylinder engine is equipped with cam follower control and dual overhead camshafts, enabling maximum power and torque output while meeting requirements for rigidity, minimal moving mass, and optimized valve cross-section timing. Additionally, through a highly compact cylinder head, the engine achieves an ideal combination of maximum rigidity and the lightest mass for moving valve components.
15
0
Share

What Causes a Car Navigation Screen to Go Black?

Car navigation display screen blackouts are typically caused by issues related to the vehicle's power supply voltage, navigation system cables, or the power connector of the navigation display. Below are detailed explanations of the specific reasons for car navigation screen blackouts: 1. Vehicle power supply voltage issues: Investigate the stability of the vehicle's power supply voltage to rule out voltage fluctuations as a possible cause. 2. Navigation system cables: If the voltage is stable, check the cables at the back of the device for any issues. Try replacing the connections to eliminate this possibility. If the connections are fine, inspect the display cables of the device. If any problems are found, replace them with new ones for testing. 3. Loose power connector of the navigation display: If there is no image but sound is still present, this indicates a loose power connector on the navigation display. If there is neither sound nor image, the issue likely lies with the DVD system.
10
4
Share

What Causes the Squeaking Noise from Brake Pads When the Car is Cold?

The reasons for squeaking brakes when the car is cold are as follows: 1. If it is a new car, the brake pads and brake discs are still in the break-in period, which may cause a slight hissing noise. This is normal and can be ignored. It usually disappears automatically after a few hundred kilometers. 2. There may be foreign objects between the brake pads and brake discs, such as small particles like sand or small stones that have entered between them, causing a hissing sound. 3. The brake discs and brake pads may be stuck together due to rust, causing noise. This usually happens after driving in the rain and then leaving the car unused for several days. The brake discs and brake pads rust and stick together, resulting in noise when driving again. This is also normal. 4. The brake disc fixing screws may be missing or excessively worn, causing a mismatch with the brake pads and resulting in noise. 5. The brake pads may be nearly worn out, which can cause a screeching sound. If this occurs continuously for several days and the noise becomes louder and more frequent, it usually indicates that the brake pads need to be replaced.
9
5
Share

How many points are deducted for changing lanes in a designated lane?

Changing lanes in a designated lane, according to the provisions of the Road Traffic Safety Law, will result in a fine for violating the prohibition markings, with a one-time deduction of 3 points. The introduction of "designated lanes" and dedicated directional lanes is as follows: "Designated Lane": Refers to a dedicated lane where, based on the preset directions of the road to different destinations, a specific lane is designated for vehicles heading to a specified location and direction only, and vehicles heading to other destinations are not allowed to enter; Dedicated Directional Lane: To facilitate citizens in correctly using this lane, the Municipal Traffic Police Corps has set up supporting "Dedicated Directional Lane" indicator signs, LED prompt boards, guiding signs, and other traffic facilities starting 300 meters before the entrance of the "designated lane" to alert passing drivers about the entrance to the "designated lane" and the area it points to. At the same time, it warns that electronic monitoring devices are used in this section to capture vehicles not following the regulations, and violators will be fined and deducted 3 points for violating the prohibition markings.
4
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.