Is the Tank 300 fuel-consuming?

1 Answers
VanJessica
07/29/25 4:09pm
The Tank 300 is fuel-consuming. Its fuel consumption is 9.3L/100km. Here are some methods to reduce fuel consumption while driving: Strengthen vehicle maintenance: Vehicle adjustments and maintenance affect engine performance and driving resistance. Owners should regularly visit auto repair shops for routine maintenance, such as checking tire pressure, wheel alignment, adjusting brake pad and drum clearance, lubricating chassis points, timely oil changes, and filter inspections. Additionally, among the specified oil types in the manual, choose the one with the lowest viscosity, as higher viscosity increases friction and fuel consumption. Avoid prolonged engine idling: Engine fuel consumption during idle parking is significantly higher than during normal driving. If the vehicle is stationary for extended periods, such as waiting for someone, it's best to turn off the engine. During cold starts, warming up the engine should not exceed 1 minute; maintaining a few minutes of low-speed driving is sufficient.
Was this review help?
8
5
Share
More Forum Discussions

What is the function of the shark fin on a car?

The shark fin on a car mainly serves the following purposes: 1. Signal reception. In most cases, the shark fin on the car roof contains an electronic signal transmission device. The car's navigation system locates the vehicle through the equipment inside the shark fin. At the same time, it can also provide signals for devices such as the car's radio and Bluetooth, and can also enhance signal reception. 2. Static electricity discharge. The shark fin on the car roof can release static electricity from inside the car in dry environments, preventing many unnecessary troubles caused by static electricity. In addition to the shark fin on the car roof, static electricity can also be discharged by using a chain to transfer the static electricity from the rear of the car to the road surface. 3. Air spoiler. The shark fin on some performance cars can act as an air spoiler, making it more aerodynamic. It can press the car onto the road surface during high-speed driving, making the car more stable. 4. Decoration. Most cars use built-in antennas to receive signals, but they may also have a shark fin installed on the roof to make the car look better. It should be noted that if the car is equipped with an overly exaggerated decorative item, it needs to be registered with the vehicle management office; otherwise, it is an illegal act.
3
2
Share

What could be the reason for the sudden inability to shift gears in a Mercedes-Benz GLA200?

Mercedes-Benz's inability to shift gears may be caused by issues such as transmission valve body failure, transmission shift mechanism failure, or internal friction plate failure in the transmission. Symptoms of transmission damage: Shifting gears may produce a certain sense of jerkiness. Generally, when the transmission is faulty, the car will experience a sense of impact or jerkiness during upshifting or gear shifting while driving. This means that during gear shifting, the engine's tachometer will suddenly drop and then rise again. If there is an impact during startup, this is also a sign of a faulty transmission. Transmission maintenance: It is important to regularly check the fluid level in the transmission to ensure it remains within the specified range and to top it up as needed based on actual working conditions. When topping up, ensure that the new fluid added is of the same type. When replacing the fluid, it should be done while the transmission is operating to promptly drain the old fluid and perform a cleaning. Regularly inspect the working condition of the transmission gears to ensure optimal meshing between the gears, and clean them in a timely manner to ensure perfect coordination between the gears and the shaft.
10
4
Share

What is the fuel tank capacity of the Changan Oshan X7 in liters?

The fuel tank capacity of the Changan Oshan X7 is 55 liters, as officially announced. Owners who have purchased the Changan Oshan X7 can also check this information on the vehicle's configuration sheet. The Changan Oshan X7 requires 92-octane gasoline, with a fuel consumption of 7 to 7.4L per 100 kilometers. A full tank can cover a distance of 743 to 786 kilometers. During daily driving, it is essential to monitor the remaining fuel level in the tank. This is typically observed through the fuel gauge inside the vehicle. Under normal circumstances, the fuel level will be accurately reflected on the gauge. The fuel gauge usually has 5 to 6 segments, and it is advisable to refuel when only 2 segments remain to avoid running out of fuel mid-journey. During actual refueling, the amount of fuel added may exceed the marked capacity. This is because the fuel tank capacity specified by the manufacturer is measured from the bottom of the tank to the safety limit. There is additional space from the safety limit to the tank opening, which is designed to accommodate fuel expansion due to temperature increases without causing overflow. If fuel is added up to the tank opening during refueling, the actual amount of fuel added may exceed the marked tank capacity.
6
4
Share

Should I Add Antifreeze or Water to the Car Radiator?

You should add antifreeze to the car radiator. Water in daily life is impure and contains impurities. If water circulates in the engine, especially during the major cycle when it flows into the cooling tank behind the intake grille, the impure water can form scale and clog the cooling system. This can lead to reduced engine power, increased wear, and overheating. Additionally, water evaporates easily at high temperatures, causing a shortage in the cooling system, which may result in cylinder scoring, cylinder head deformation, or even engine failure in severe cases. Below is more information about antifreeze: 1. Antifreeze is a coolant with special additives, primarily used in liquid-cooled engine cooling systems. It offers excellent properties such as freeze protection in winter, boil-over prevention in summer, and year-round anti-scale and anti-corrosion benefits. 2. Engines and their cooling systems are made of metals like copper, iron, aluminum, steel, and solder. These metals can corrode and rust over time when exposed to water under high temperatures. In contrast, antifreeze not only prevents corrosion in the engine cooling system but also has anti-corrosion and rust-removal functions. 3. Over 95% of antifreeze used domestically and internationally is ethylene glycol-based. Compared to tap water, ethylene glycol's most notable feature is its freeze resistance, whereas water cannot prevent freezing. Additionally, ethylene glycol has a high boiling point, low volatility, moderate viscosity with minimal temperature variation, and excellent thermal stability. Thus, ethylene glycol-based antifreeze is an ideal coolant.
12
3
Share

How Does an Air Filter Work?

Here is how an air filter works: 1. Dry inertial air filter: The dry inertial air filter consists of a dust cover, guide vanes, dust discharge port, dust collection cup, etc. Its working principle is to use the suction force generated by the cylinder during intake to create a pressure difference inside and outside the air filter. External air enters the air filter at a high speed under pressure, throwing larger dust particles mixed in the air into the dust collection cup, thus completing the air filtration. 2. Wet inertial air filter: Also known as an oil bath filter, the wet inertial air filter mainly consists of a central tube and an oil pool. Its working principle is that air enters the filter and moves downward at high speed along the central tube, hitting the oil surface of the oil pool before abruptly changing direction to move upward, creating a rotational motion. At this point, some larger dust particles cannot reverse direction with the air due to inertia and are instead trapped in the oil, completing the air filtration. 3. Dry filtration air filter: The dry filtration air filter mainly consists of a paper filter element and sealing gaskets. Its working principle is that air passes through the paper filter element upon entering the filter, where dust in the air is either blocked by the filter element or adheres to it. 4. Wet filtration air filter: The wet filtration filter mainly consists of metal mesh soaked in engine oil. Its working principle is that after passing through the oil bath filter, air is further filtered through the oil-soaked metal mesh, where fine dust particles are trapped, and some adhered dust particles drip down with the oil.
17
5
Share

What does a triangle with an exclamation mark indicate as a warning light?

A triangle with an exclamation mark inside indicates a general performance or component malfunction in the vehicle. Common issues include parking sensor failure, fuel cut-off system intervention or malfunction, external light failure, or engine oil pressure sensor malfunction. Solution: It is necessary to visit a 4S shop for inspection to identify the source of the fault. The exclamation mark is a common warning symbol in vehicles. Apart from the triangle with an exclamation mark, there are four other forms of exclamation mark warnings: a yellow gear with an exclamation mark inside, a red circle with parentheses and an exclamation mark in the middle, a yellow bracket with a horizontal line and an exclamation mark in the middle, and a yellow bulb with an exclamation mark. Below is a detailed analysis of these four scenarios: Automatic transmission malfunction: A yellow gear with an exclamation mark inside indicates an automatic transmission fault warning light, signaling a transmission malfunction or transmission fluid level below the normal range. The transmission fluid should be replaced promptly. Brake system malfunction: A circle with parentheses and an exclamation mark in the middle represents a brake system warning, indicating either a brake system malfunction or low brake fluid level. Immediate inspection of the brake system is required to avoid accidents. Tire pressure anomaly: A bracket with a horizontal line and an exclamation mark in the middle represents a tire pressure monitoring warning light, which illuminates when the tire pressure is too low. Check the vehicle's tire pressure and restore it to the normal range. Lighting malfunction: A yellow bulb with an exclamation mark indicates a lighting fault warning light, signaling a malfunction in one of the vehicle's lights. Solution: Visit a 4S shop for inspection and repair as soon as possible, or conduct a self-inspection focusing on commonly used bulbs such as turn signals, fog lights, and interior lighting to identify the issue.
7
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.