Is the Roewe i5 a Class A car?

1 Answers
IrisMarie
07/29/25 11:33pm
The Roewe i5 is a Class A sedan with a wheelbase of 2680 mm, and its length, width, and height are 4601 mm, 1818 mm, and 1489 mm respectively. The Roewe i5 is equipped with two types of engines: a 1.5-liter naturally aspirated engine and a 1.5-liter turbocharged engine. In terms of exterior design, the Roewe i5 features the Roewe family's rhythmic floating wing-style wide-body grille, paired with rectangular headlight clusters. Below, it includes a trapezoidal air intake. The side profile adopts a dual waistline design, while the rear incorporates a small ducktail spoiler. The entire lineup comes with a limited-time free upgrade to LED headlights.
Was this review help?
8
2
Share
More Forum Discussions

Does the Audi S4 burn engine oil?

The Audi S4 engine does not burn engine oil. Reasons for the Audi S4 engine burning oil: The Audi S4 engine burns oil because it uses unqualified engine oil. As the engine runs for a long time, the water vapor generated by high-temperature oxidation of the oil is sucked into the combustion chamber through the crankcase ventilation valve and burned. Using engine oil with viscosity that does not meet the standards will cause oil burning. Functions of vehicle engine oil: Engine oil lubricates the pistons, piston rings, and cylinders. When the engine pistons are working, there is a layer of oil film on the inner wall of the cylinder. During the combustion of the air-fuel mixture, part of the oil film is burned off by the high-temperature combustion gases.
2
5
Share

What are the differences between 0w40 and 5w40 engine oils?

The difference between 0w40 and 5w40 engine oils lies in their low-temperature flow performance. The relevant introductions about 0w40 and 5w40 engine oils are as follows: Different flowability: 0w40 engine oil can flow normally at minus 35 degrees Celsius; 5w40 engine oil can flow normally at minus 30 degrees Celsius. Meaning of 'w': 'w' stands for winter, and the smaller the number before it, the better the low-temperature flowability of the engine oil, indicating a lower usable environmental temperature and better protection for the engine during cold starts. The number after 'w' represents the kinematic viscosity of the engine oil at 100 degrees. The higher the value, the higher the viscosity. If the vehicle operates under high-speed or extreme load conditions, it is more suitable to use engine oil with higher viscosity.
16
2
Share

Which is better, the Middle East version or the China-specific version of the Prado?

In terms of configuration and cost-effectiveness, the Middle East version offers higher value for money with richer configurations and more optional features, while the China-specific version currently does not support optional configurations. Overall, the Middle East version is recommended. Below are the specific differences between the China-specific version and the Middle East version: 1. Different engines: The Middle East version offers three engine options, namely a 2.7L engine, a 4.0L engine, and a 2.8L diesel engine; the domestic version only has a 3.5L engine. 2. Different four-wheel drive systems: The Middle East version is equipped with a full-time four-wheel drive system and a central differential lock; the domestic version has a part-time four-wheel drive system. 3. Different appearances: The China-specific version does not have a front chrome bumper guard, while the Middle East version adds a chrome bumper guard to the front.
18
4
Share

What is the tire pressure for 7.00-16 tires?

700r16 steel-belted tires generally require slightly higher pressure than nylon tires. Typically, the front tires should be inflated to 7 bar, while the rear tires should be at 8 bar. Below are key points about vehicle tire pressure: 1. Service life: Both overinflation and underinflation will shorten tire lifespan. Underinflation increases tire deformation and contact area, leading to sidewall cracks, excessive heat generation, rubber degradation, and accelerated shoulder wear. 2. Increased load: Overinflation causes excessive stretching of tire cords, reduces elasticity, and increases the load burden during driving. 3. Follow manufacturer recommendations: Always use the vehicle manufacturer's recommended tire pressure values. These recommendations can typically be found in: the vehicle owner's manual, the label near the driver's door (B-pillar), the drawer beside the driver's seat, or the fuel tank door.
1
1
Share

What gear should an automatic transmission car use when climbing a steep slope?

An automatic transmission car should use the L gear, S gear, or M gear when climbing a steep slope. An automatic transmission car uses a computer to control hydraulic oil to push pistons for gear shifting based on throttle size, vehicle speed, and throttle opening. It automatically selects the appropriate gear according to driving speed and traffic conditions, allowing it to independently control the gear to better match the engine speed with the gear. The gears of an automatic transmission are as follows: P gear is the parking gear and also the starting gear; R gear is the reverse gear; N gear is the neutral gear; D gear is the drive gear, also known as the forward gear; S gear is the sport mode; L gear is the low-speed gear, which uses an automatic transmission and planetary gear mechanisms for shifting, automatically adjusting gears based on the degree of throttle pedal and changes in vehicle speed.
1
1
Share

Can I bring a backpack during the driving test (Subject 3)?

During the Subject 3 driving test, you can bring a backpack but it must be placed on the rear seat. Additional information: 1. The road driving skills test (Subject 3) generally includes: pre-driving preparations, lighting simulation test, starting, straight-line driving, gear shifting operations, lane changing, pulling over, going straight through intersections, left turns at intersections, right turns at intersections, crossing pedestrian crossings, passing school zones, passing bus stops, meeting vehicles, overtaking, making U-turns, and nighttime driving. 2. The safe and civilized driving knowledge test generally includes: requirements for safe and civilized driving operations, safe driving knowledge under adverse weather and complex road conditions, emergency handling methods for situations like tire blowouts, and post-accident handling knowledge.
6
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.