Is the original Volkswagen DVD integrated car stereo made by Desay SV?

Is It Normal for an Automatic Transmission to Make a Clicking Sound When Shifting to Reverse?

A very slight clicking sound is normal because the reverse lock mechanism engages when shifting into reverse gear. Therefore, a faint clicking sound may occur. However, if the sound is loud, it is necessary to inspect the reverse lock mechanism. It is recommended to visit a repair shop for a check-up. Additional relevant information is as follows: 1. Automatic Transmission: As the name suggests, it eliminates the need for the driver to manually shift gears. The vehicle automatically selects the appropriate gear based on driving speed and traffic conditions. 2. Automatic transmission vehicles typically have six gear positions, arranged from top to bottom as: P (Park), R (Reverse), N (Neutral), D (Drive), S (Sport), and L (Low). Driving an automatic car using only P (Park), R (Reverse), N (Neutral), and D (Drive) gears can fully meet general driving needs. However, in certain special driving conditions, other functional gears may be required. Therefore, with the correct operation and control, an automatic transmission car can perform better than a manual one. 3. Engine power is transmitted through the transmission: The transmission is also a key factor affecting fuel consumption. Generally, automatic transmissions consume over 10% more fuel than manual transmissions. Regardless of whether it's a manual or automatic transmission, more gears usually result in better fuel efficiency.

7

1

Share

Why does the car alarm go off for no reason?

The reasons why the car alarm goes off for no reason are as follows: 1. Controller failure: It may be a fault in the alarm itself or a fault in the triggered sensor. 2. The trigger sensitivity is too high: irregular alarms will interrupt rest. 3. The door switch, hood switch, or trunk switch is closed: the door is not closed tightly. The trigger wire is grounded, which means the wire is short-circuited. It will keep sounding until the battery runs out of power. In such cases, you can adjust the sensitivity of the alarm on the anti-theft control box. Generally, the anti-theft control box is installed under the dashboard. After disassembling, you can see it, and there is a spiral knob on it that can be rotated to adjust the sensitivity. It is recommended to reduce the sensitivity to a state where the car does not alarm when you kick the tire. When parking, it is recommended to use the silent mode of the anti-theft device. The anti-theft device can still prevent theft even without sound. When the control circuit starts the car abnormally, it will automatically cut off the power and sound the alarm, activating the audible anti-theft mode. If the anti-theft device detects continuous vibration and keeps sounding, it will affect others' rest and consume the car's power.

20

2

Share

Steps for Driving and Parking Operations?

First, confirm the parking environment of the car to check for any safety hazards. The parking space should be spacious enough to avoid obstructing the opening of car doors and the entry and exit of passengers. For manual transmission cars, press the brake pedal, then press the clutch pedal to cut off power transmission and bring the car to a complete stop. For automatic transmission cars, simply press the brake pedal to stop the car. For manual transmission cars, shift the gear into neutral, release the clutch pedal, and engage the handbrake. For automatic transmission cars, shift into the parking gear (P) and engage the handbrake or press the electronic parking brake.

6

0

Share

Where is the fuel pump located?

Currently, the fuel pump in most vehicle models is installed inside the fuel tank and is electrically driven. The fuel pump consists of three parts: the pump body, the permanent magnet motor, and the housing. Safety precautions for fuel pump fault detection: 1. Old fuel pump: When troubleshooting fuel pumps in vehicles that have been used for a long time, these fuel pumps must not be tested dry. After removing the fuel pump, since there is residual fuel inside the pump housing, if the brushes and commutator have poor contact during electrical testing, sparks may ignite the fuel inside the pump housing, leading to an explosion with extremely serious consequences. 2. New fuel pump: Newly replaced fuel pumps must also not be tested dry. Because the pump motor is sealed inside the pump housing, the heat generated during dry testing cannot dissipate, and the armature may overheat and burn out the motor. Therefore, the fuel pump must be immersed in fuel for testing. 3. Other aspects: After the fuel pump is removed from the fuel tank, it should be wiped clean promptly. Avoid sparks near its placement, and always follow the safety principle of "connect the wiring first, then power on."

19

1

Share

What is the correct way to operate a car steering wheel?

Place both hands at the 9 o'clock and 3 o'clock positions respectively. Naturally grip the steering wheel with four fingers (index to little finger) from the inside out, while the thumb naturally rests along the rim of the steering wheel. When turning the steering wheel to the right, use the left hand as the primary force to initiate the turn to the right, with the right hand assisting in the rotation. The right hand grips the upper left side of the steering wheel while the left hand releases. The right hand then turns the steering wheel as the left hand changes position and returns to its original place.

5

0

Share

Advantages and Disadvantages of Front-Wheel Drive and Rear-Wheel Drive?

The advantages and disadvantages of front-wheel drive (FWD) and rear-wheel drive (RWD) are as follows: 1. Advantages of FWD: The powertrain is compact, the drive shafts are short, and power loss is low. In terms of handling, FWD vehicles inherently tend to understeer, making them easier to drive. In terms of layout, the absence of a driveshaft running through the cabin reduces the central floor hump, increasing usable cabin space. 2. Disadvantages of FWD: During acceleration, the load on the front axle decreases, reducing tire grip and affecting power output. Additionally, the front wheels handle driving, steering, and most of the braking force, leading to significant wear. 3. Advantages of RWD: RWD is commonly found in supercars. Its benefits include achieving a near-perfect front-to-rear weight distribution while retaining the advantages of front-engine, rear-wheel-drive layouts without the associated drivetrain losses. 4. Disadvantages of RWD: Since the driven wheels are at the rear, RWD vehicles often have a large floor hump, affecting passenger comfort. They are more prone to drifting during sharp cornering and may oversteer. Moreover, on snowy or icy roads, RWD vehicles have poorer traction compared to FWD, sometimes struggling to climb slopes.

10

3

Share

Is the original Volkswagen DVD integrated car stereo made by Desay SV?

Is It Normal for an Automatic Transmission to Make a Clicking Sound When Shifting to Reverse?

Why does the car alarm go off for no reason?

Steps for Driving and Parking Operations?

Where is the fuel pump located?

What is the correct way to operate a car steering wheel?

Advantages and Disadvantages of Front-Wheel Drive and Rear-Wheel Drive?

How to Replace Brake Lights?

How to Adjust Valves for a 4-Cylinder Engine?

What are the steps for adding coolant?

Why is the wireless charging not working in the Hongqi H5?