Is the original vehicle license required for demerit points?

1 Answers
McSabrina
07/30/25 7:44am
Demerit points require the original vehicle license. Documents required for demerit points: To process demerit points on a driver's license, you need to bring the original and copy of the vehicle license of the offending vehicle, the original and copy of the driver's license, cash or a bank card designated by the traffic police department, and go to the service hall of the traffic management department. The license holder must be present in person. Personal signature is required, and the license holder must be present in person, and an ID card must be presented. Demerit points cannot be replenished: Within one cycle, if the demerit points on the license are less than 12, the fine must be paid, and the points will be cleared in the next cycle; if the demerit points reach 12, the driver must attend a seven-day study and examination on road traffic safety laws, regulations, and related knowledge at the place where the motor vehicle driver's license was issued within fifteen days.
Was this review help?
10
0
Share
More Forum Discussions

How to Deal with Spiders Inside the Car?

If there are spiders inside your car, you can try the following solutions: 1. Thoroughly clean the interior: Remove spider webs and maintain a clean, tidy environment inside the car. 2. Give the car a thorough wash: Take the car to a professional car wash for a more comprehensive cleaning. 3. Open the car doors and let it sit in the sun: Since spiders prefer damp environments, parking the car in direct sunlight with the doors open and removing the mats will make the spiders leave due to the high temperatures. 4. Close the doors and use insecticide: Spray insecticide inside the car, then tightly close the doors to kill the spiders. Afterward, open the doors to ventilate the car properly. 5. Place camphor in the car: Put camphor in corners and under mats where spiders might hide, as its strong smell will repel them.
13
4
Share

What are the reasons for the lack of power when accelerating in the Qoros 5?

The reasons for the lack of power when accelerating in the Qoros 5 are as follows: 1. Clogged air filter: Once the air filter is clogged, the engine's air intake will be restricted, leading to incomplete combustion and reduced engine efficiency, which will inevitably affect acceleration performance. 2. Fuel supply system not cleaned for a long time: Both fuel injection and carburetor systems require regular cleaning, with carburetors needing more frequent cleaning. 3. Ignition system: If there is a noticeable jerking sensation during driving, 80% of the time it is caused by the ignition system. The components most likely to fail in the ignition system are the ignition coil, high-voltage coil, and connecting wires. 4. Engine malfunction: Valve leakage, worn piston rings, and aging cylinder blocks can all lead to poor acceleration performance. This is mainly due to decreased cylinder pressure, which alters the engine's combustion state, resulting in the phenomenon of weak acceleration.
16
0
Share

Must a small cut on the side of a tire be replaced?

The side of the tire has a small cut. Theoretically, if only the surface rubber is damaged, the cut is small, and the internal materials are not affected, it can continue to be used. However, in practice, regardless of the size of the cut, as long as there is damage to the sidewall, it is recommended to replace it directly. Below is relevant information about tires: 1. Introduction: A tire is a circular elastic rubber product mounted on various vehicles or machinery to roll on the ground. Typically fitted on metal rims, it supports the vehicle body, absorbs external shocks, ensures contact with the road, and maintains driving performance. 2. When to replace a tire: One method is to pry open the damaged area on the sidewall to see if the cord fabric is visible. If it is visible, replace the tire immediately without hesitation.
14
4
Share

Where is the cabin air filter located in a Volkswagen?

In the Volkswagen Passat, the cabin air filter is located beneath the glove compartment on the passenger side. There is an external cover panel that needs to be removed by unscrewing two plastic screw fasteners. Once the panel is removed, you will see a rectangular cover for the cabin air filter. Pull it horizontally following the arrow direction to remove it. Additional information: 1. Maintenance: If the filter is dirty, clean it by blowing compressed air from the opposite side. Hold the air nozzle about 5 cm away from the filter and use 500 kPa pressure for approximately 2 minutes. The cabin air filter tends to accumulate dust easily, so simply blowing away loose dust with compressed air is sufficient. 2. Precautions: The cabin air filter is prone to collecting dust, so use compressed air to remove surface dust. Over time, the activated carbon filtration function of the cabin air filter diminishes, so it's recommended to visit a 4S dealership for replacement.
18
4
Share

How to Solve the Engine Oil Dilution Issue in Honda CR-V?

Honda has proposed four recall measures for the affected CR-V models: FI-ECU software upgrade; replacement of the air conditioning control unit; TCU software upgrade (CVT models only); replacement of the radiator lower hose assembly (CVT models only). Additional information is as follows: 1. Definition: The Honda CR-V is a classic urban SUV model produced by Dongfeng Honda Automobile Co. The 2015 CR-V features a sporty and fashionable exterior design, paired with Michelin Latitude series SUV tires, offering excellent handling performance. 2. Key Advantages: Fashionable and dynamic appearance with smooth, rounded yet sporty lines; improved materials and craftsmanship; decent configuration; powerful performance; flexible handling; relatively high cost performance.
4
3
Share

How long does a car stay in a 4S store before it is considered a stock car?

Stock cars refer to vehicles that have been in inventory for over a year without being sold. Below are specific details about stock cars: 1. Disadvantages of stock cars: When stored for long periods without use, components such as the battery, plastic parts, and internal wiring are prone to aging. If the car is not run in time, the lubricating oil may deteriorate or solidify, leading to wear on mechanical parts. 2. Replacement of all vehicle fluids: When purchasing a stock car, fluids such as engine oil, antifreeze, and lubricating oil need to be inspected or replaced. 3. Inspection of all rubber components: Rubber parts are prone to aging and deformation, such as the car's tires. The bottom areas are particularly susceptible to deformation under pressure, and any issues require inspection or replacement.
8
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.